Page 139 of 340

CD Player Theft Deterrent Feature
Delco LOC 11’ is an theft deterrent feature for the
compact disc player. It can be used or ignored. If
ignored, the system plays normally. If it is used, your
player won’t be usable if
it is ever stolen because it will
go to “LOC” mode any time battery power is removed.
It will also
go to LOC mode any time power from the
battery is turned off by the Battery Rundown Protection
feature (see“Battery Rundown Protection”
in the Index).
Until an unlock code is entered, it will not turn on.
The instructions below tell you how to enter a secret
code into the system. If your vehicle loses battery power
for any reason, you must unlock
the system with the
secret code before your audio system will turn on.
Setting the Anti-Theft System
1. Write down any six-digit number and keep it in a
2. Turn the ignition to the ACC or RUN position.
3. Turn the PWR-VOL knob to turn the radio off.
safe place. This is your secret c.ode.
4. Press station preset buttons 1 and 4 at the same time
and hold
until bb---’’ shows on the display.
You now have only 15 seconds between each of the
following steps.
5. Press SET, and “000” will appear on the display.
6. Press SCAN until the first digit of your code
appears.
7. Press SEEK until the second and third digits of your
8. Press the TUNE knob (“000” will appear again on
code
appear.
the display).
9. Press SCAN until the fourth digit of your code
appears.
10. Press SEEK until the fifth and sixth digits of your
code appear.
11. Press the TUNE knob (“rEP’ will appear for five
seconds,
then 000 ).
12. Repeat steps 6 through 10. Then press the TUNE
knob again. SEC will appear, indicating that Delco
LOC IT’ is set, and your audio system is secure. If
bb---” appears, the steps were not successful, and
you must repeat the entire procedure.
3-13
Page 140 of 340

Disabling the Anti-Theft System
Enter your secret code by following these steps (you
will have only
15 seconds between each step).
1. Turn the ignition to the ACC or RUN position, and
turn
the radio off.
2. Press station preset buttons 1 and 4 at the same time.
SEC will appear in the display, indicating the audio
system is secure.
3. Press SET, and “OOO” will appear on the display.
4. Press SCAN until the first digit of your secret code
appears.
5. Press SEEK until the second and third digits of your
code appear.
display).
6. Press the TUNE knob (“000” will appear on the
7. Press SCAN until the fourth digit of your code appears.
8. Press SEEK until the fifth and sixth digits of your
code appear.
9. Press the TUNE knob. If the display shows “---,” the
radio is unsecured and will play again. If the display
shows SEC, the disabling sequence was unsuccessful
and the numbers did not match
the secret code.
If
you lose or forget your code, see your retailer.
Unlocking the System After a Power Loss
When battery power is reapplied to a secured audio
system after a
loss of power, the audio system will not
turn on and
LOC will appear on the digital display. You
will need to unlock the Delco LOC
11s system.
1. Turn the ignition to the ACC or RUN position, and
turn the radio
off.
2. Press SET, and “000” will appear on the display.
3. Follow steps 4-8 for disabling your anti-theft
system.
digital display if you are successful.
If SEC appears,
however, the numbers did not match, and your audio
system
is still locked.
4. Press the lower knob. The time will appear on the
Understanding Radio Reception
FM Stereo
FM stereo will give you the best sound, but FM signals
will reach only about
10 to 40 miles ( 16 to 65 km). Tall
buildings or hills can interfere with FM signals, causing
the sound to come and go.
3-14
Page 234 of 340

Thermostat
Engine coolant temperature is controlled by a thermostat
in the engine coolant system. The thermostat stops the
flow
of coolant through the radiator until the coolant
reaches
a preset temperature.
When you replace your thermostat, an AC@ thermostat
is recommended.
Power Steering Fluid
p .w ii
How To Check Power Steering Fluid
When the engine compartment is cool, unscrew the cap
and wipe the dipstick with
a clean rag. Replace the cap
and completely tighten it. Then remove the cap again
and look at the fluid level on the dipstick.
The level should be at the FULL COLD mark. Add
enough fluid to bring the level up to the mark.
A fluid loss in this system could indicate a problem.
Have the system inspected and repaired.
What to Add
Refer to the Maintenance Schedule to determine what
kind
of fluid to use. See “Recommended Fluids and
Lubricants”
in the Index.
I NOTICE:
When adding power steering fluid or making a
complete fluid change, always use the proper
fluid. Failure to use the proper fluid can cause
leaks and damage hoses and seals.
6-24
Page 249 of 340

These grades are molded on the sidewalls of passenger
car tires.
While the tires available
as standard or optional
equipment
on General Motors vehicles may vary with
respect to these grades, all such tires meet General
Motors performance standards and have been approved
for use
on General Motors vehicles. All passenger type
(P Metric) tires must conform to Federal safety
requirements
in addition to these grades.
Wheel Alignment and Tire Balance
The wheels on your vehicle were aligned and balanced
carefully at the factory to give you the longest tire life
and best overall performance.
In most cases,
you will not need to have your wheels
aligned again. However,
if you notice unusual tire wear
or your vehicle pulling one way
or the other, the
alignment may need to be reset.
If you notice your
vehicle vibrating when driving on
a smooth road, your
wheels may need to be rebalanced.
Wheel Replacement
Replace any wheel that is bent, cracked, or badly rusted
or corroded.
If wheel nuts keep coming loose, the wheel,
wheel bolts, and wheel nuts should be replaced.
If the
wheel leaks air, replace it (except some aluminum
wheels, which can sometimes be repaired). See your
Oldsmobile retailer
if any of these conditions exist.
Your retailer will know the kind of wheel you need.
Each new wheel should have
the same load carrying
capacity, diameter, width, offset, and be mounted the
same way
as the one it replaces.
If you need to replace any of your wheels, wheel bolts,
or wheel nuts, replace them only with new GM original
equipment parts. This way,
you will be sure to have the
right wheel, wheel bolts, and wheel nuts for your
Oldsmobile model.
6-39
-