Part C: Periodic  Maintenance 
Inspections 
Listed below  are inspections  and services  which should 
be  performed  at least  twice 
a year  (for instance, each 
spring and fall).  You should 
let your  GM retailer’s 
service department or  other qualified  service  center  do 
these  jobs.  Make  sure any necessary repairs  are 
completed at  once. 
Restraint  Systems 
Now and then, make  sure all your belts, buckles,  latch 
plates, retractors, anchorages and reminder  systems  are 
working properly. Look  for any 
loose parts  or  damage. 
If you see anything that  might keep a restraint system 
from  doing  its job,  have it repaired. 
Steering,  Suspension  and  Front-Wheel-Drive 
Axle  Boot  and  Seal  Inspection 
Inspect the front and rear suspension  and steering 
system  for damaged, loose  or missing parts, signs  of 
wear,  or lack  of  lubrication.  Inspect the power steering 
lines 
and hoses  for proper  hookup,  binding, leaks, 
cracks,  chafing,  etc.  Clean and then inspect  the drive 
axle boot  seals  for  damage,  tears or leakage. Replace 
seals  if necessary. 
Exhaust  System  Inspection 
Inspect  the  complete  exhaust  system.  Inspect  the  body  near 
the  exhaust  system.  Look  for  broken,  damaged,  missing  or 
out-of-position  parts 
as well as open  seams,  holes,  loose 
connections,  or other  conditions  which  could  cause  a heat 
build-up  in  the  floor  pan  or could 
let exhaust  fumes  into 
the  vehicle.  See “Engine  Exhaust”  in  the  Index. 
Throttle  Linkage  Inspection 
Inspect  the  throttle  linkage  for  interference  or binding,  and 
for damaged  or missing  parts.  Replace  parts  as  needed. 
Accelerator  and  cruise  control  cables  should  not  be 
lubricated. 
Manual  Transaxle 
Check the transaxle  fluid  level;  add  if needed.  See 
“Manual  Transaxle” 
in the  Index. A fluid loss may 
indicate 
a problem.  Check  the  system  and  repair if needed. 
Brake  System  Inspection 
Inspect  the  complete  system.  Inspect  brake  lines  and  hoses 
for  proper  hookup,  binding,  leaks,  cracks,  chafing,  etc. 
Inspect  disc  brake  pads  for  wear  and  rotors  for  surface 
condition. 
Also inspect drum brake  linings  for  wear  and 
cracks.  Inspect  other  brake  parts,  including  drums,  wheel 
cylinders,  calipers,  parking  brake,  etc.  The  parking  brake  is  self-adjusting  and 
no manual  adjustment is required.  You 
may  need  to  have  your  brakes  inspected  more  often  if  your 
driving  habits  or  conditions  result 
in frequent  braking. 
7-40