1995 LAND ROVER DISCOVERY ECU

[x] Cancel search: ECU

Page 133 of 873

LAND ROVER DISCOVERY 1995  Workshop Manual V8i
15
REPAIR OIL SUMP
Service repair no - 12.60.44
Remove
1.Drain engine oil
See SECTION 10,
Maintenance, Under Vehicle Maintenance
2.Fit drain plug. Tighten to40 Nm.
3.If fitted, disconnect low oil

Page 137 of 873

LAND ROVER DISCOVERY 1995  Workshop Manual 4.0 V8
1
REPAIR CRANKSHAFT PULLEY
Service repair no - 12.21.01 - Crankshaft Pulley
Remove
1.Disconnect battery negative lead.
2.Remove cooling fan.
See COOLING SYSTEM,
Repair, Viscous Coupling, Fan Bl

Page 139 of 873

LAND ROVER DISCOVERY 1995  Workshop Manual 4.0 V8
3
REPAIR ENGINE ASSEMBLY
Service repair no - 12.41.01/99
Remove
1.Position vehicle on ramp.
2.Remove bonnet.
See CHASSIS AND BODY,Repair, Bonnet [Hood]
3.Remove radiator.See COOLING SYSTEM,
Rep

Page 140 of 873

LAND ROVER DISCOVERY 1995  Workshop Manual 12ENGINE
4
REPAIR 39.Release battery positive lead terminal cover.
40.Remove terminal nut
41.Release terminal from battery.
42.Release fusebox main feed lead.
43.Position battery cable over engine.
44

Page 141 of 873

LAND ROVER DISCOVERY 1995  Workshop Manual 4.0 V8
5
REPAIR 77.Release sensor/shield and remove.
78.Disconnect sensor multiplug.
79.Remove sensor.
80.Remove starter motor heatshield.
See
ELECTRICAL, Repair, Starter Motor
Heatshield - 4.0 V8
81.

Page 142 of 873

LAND ROVER DISCOVERY 1995  Workshop Manual 12ENGINE
6
REPAIR
106.Remove top starter bolt securing engine earth
cable.
107.Remove nut securing kick-down cable clip to LH
cylinder head.
108.With assistance, raise engine, move aside all
pipes and

Page 143 of 873

LAND ROVER DISCOVERY 1995  Workshop Manual 4.0 V8
7
REPAIR 171.Route drive belt around pulleys.
172.Pivot tensioner downwards.
173.Align belt to tensioner and release tensioner.
174.Connect battery positive lead and tighten.
175.Secure termina

Page 144 of 873

LAND ROVER DISCOVERY 1995  Workshop Manual 12ENGINE
8
REPAIR
9.Disconnect multiplug from camshaft sensor.
See FUEL SYSTEM SFI, Repair, Camshaft
Position Sensor (CMP Sensor)
10.Remove 9 bolts securing front cover.
11.Remove 2 bolts securing sum