1995 LAND ROVER DISCOVERY torque

AIR CONDITIONING
1
SPECIFICATIONS, TORQUE TORQUE VALUES
NOTE: Torque wrenches should be regularly checked for accuracy to ensure that all fixings are
tightened to the correct torque.
Nm
Air conditioning
Compressor flange bolts 10............................................................................
Receiver drier union bolts 6...........................................................................
Dual pressure switch 11..................................................................................
Pressure pipe union nuts - M16 14.................................................................
Discharge pipe union nuts - M22 22...............................................................
Suction pipe union nuts - M24 33...................................................................
AIR CONDITIONING CHARGE DATA
Total oil in system 180ml - 6.3Fl oz...........................................................................
Total refrigerant in system 0,90kg - 32Fl oz..............................................................
Total refrigerant in system with rear air conditioning 1,15kg - 40Fl oz.......................

ELECTRICAL
25
REPAIR STARTER MOTOR - Mpi
Service repair no - 86.60.01
Remove
1.Disconnect battery negative lead.
2.Remove 2 nuts securing cables to starter
solenoid; release cables.
3.Remove 3 bolts securing starter motor.
4.Manoeuvre starter motor clear of bell housing.
5.Remove starter motor.Refit
6.Clean mating faces of starter motor and
differential housing.
7.Manoeuvre starter motor into position.
8.Fit mounting bolts and Tighten to
45 Nm.
9.Connect battery cables to starter solenoid; fit
nuts and tighten to the correct torque.
10.Reconnect battery negative lead.

ELECTRICAL
1
SPECIFICATIONS, TORQUE TORQUE VALUES
NOTE: Torque wrenches should be regularly checked for accuracy to ensure that all fixings are
tightened to the correct torque.
Nm
Generator
Generator mounting bracket to cylinder head 34............................................
Generator to mounting bracket 24..................................................................
Generator shaft nut 35....................................................................................
Generator through bolts 5..............................................................................
Generator rectifier bolts 3,5.............................................................................
Amplifier module screws 1,2............................................................................
Amplifier heat sink screws 1,2.........................................................................
Auxiliary driving lamp mounting bolts 15.........................................................
Distributor clampbolt 20..................................................................................
Distributor pick-up bearing plate support pillars 1,2.........................................
Distributor pick-up barrel nuts 1,2....................................................................
Distributor vacuum unit 2...............................................................................
Torque values below cover all screws and bolts used, unless specified otherwise.
METRIC Nm
M5 6......................................................................................................
M6 9......................................................................................................
M8 25.....................................................................................................
M10 45...................................................................................................
M12 90...................................................................................................
M14 105..................................................................................................
M16 180..................................................................................................
UNC / UNF
1/4 9......................................................................................................
5/16 24...................................................................................................
3/8 39.....................................................................................................
7/16 78...................................................................................................
1/2 90.....................................................................................................
5/8 136....................................................................................................