1995 CADILLAC SEVILLE reset

Downloaded from www.Manualslib.com manuals search engine 4. Let the belt go back all the way. You should hear a slight clicking
sound. If you don't, the adjustment feature won't set, and you'll have
to start again.
5. Now you can add a small amount of slack. Lean forward slightly, then
sit back.
If you've added more than 1 inch (25 mm) of slack, pull the
shoulder belt out as
you did before and start again.
If you move around in the vehicle enough, or if you pull out the shoulder
belt, the belt will become tight again. If this happens, you can reset it.
1-17

Downloaded from www.Manualslib.com manuals search engine F 4
7
Windshield Washer
To wash your
windshield, press and
hold the paddle labeled
PUSH. Once you feel
you have enough
washer fluid on the
windshield, release the
paddle. The wipers will
continue to clear the
windshield, then either
stop or return to your
preset speed.
When the washer fluid reaches a low level,
LOW WASHER FLUID will
be displayed in the Driver Information Center.
Driving without washer fluid can be dangerous.
A bad mud splash can
block your vision.
You could hit another vehicle or go off the road. Check
your washer fluid level often.
2-45

Downloaded from www.Manualslib.com manuals search engine To Resume a Set Speed
Suppose you set your cruise control at a desired speed and then you apply . .
the brake. This, of course, shuts off the cruise control, however, you don’t
need to reset it. Once you’re going about
25 mph (40 km/h) or more, you __
can move the cruise control switch from ON to R/A (Resume/Accelerate)
for about half a second.
You’ll go right back up to your chosen speed and stay there.
To Increase Speed While Using Cruise Control
There are two ways to go to a higher speed. Here’s the first:
1. Use the accelerator pedal to get to the higher speed.
2. Push the button at the end of the lever, then release the button and
the accelerator pedal. You‘ll
now cruise at the higher speed.
--.
-<

Downloaded from www.Manualslib.com manuals search engine Trip Odometer
TRIP ~
SET I
By using this button,
you can tell how far
you’ve gone since you
last
set the TRIP SET
back to zero. To reset,
press and hold the
button until zeros
appear.
If your vehicle is domestic, the trip odometer will return to zero after
999.9 miles
(1 609 km). If your vehicle is Canadian, the trip odometer will
return to zero after 1 999.9 km (1,242 miles).
WMING LIGHTS
This part describes the warning lights that are on your vehicle. The
pictures will help
you locate them.
Warning lights can signal that something is wrong before it becomes
serious enough
to cause an expensive repair or replacement. Paying
attention to your warning lights could also save you or others from injury.
Warning lights come
on when there may be or is a problem with one of
your vehicle’s functions. As you will see in the details on the next few
pages, some warning lights come
on briefly when you start the engine just
to let you know they’re working.
If you are familiar with this section, you
should not be alarmed
when this happens.
When one of the warning lights comes on and stays on when you are
driving, check the section that tells you
what to do about it. Please follow
this manual’s advice. Waiting to do repairs can
be costly -- and even
dangerous.
So please get to know your warning lights. They‘re a big help.
Your vehicle may also have a Driver Information Center that works along
with the warning lights. See “Driver Information Center‘‘ in the Index.
r
L
c.-d
c +..
2-76

Downloaded from www.Manualslib.com manuals search engine Anti-Lock Brake System Warning Light
ANTI-
LOCK (0 ABS)
With the anti-lock brake system, this light will come on when you start
your engine and may stay on
for several seconds. That’s normal. If the
light doesn’t come on, have it fixed
so it will be ready to warn you if there
is a problem.
If the light stays on, turn the ignition off. Or, if the light comes on when
you’re driving, stop as soon as possible and turn the ignition
off. Then
start the engine again to reset the system. If the light still stays
on, or
comes on again while you’re driving, your Cadillac needs service.
If the
regular brake system warning light isn’t on, you still have brakes, but you
don’t have anti-lock brakes.
If the regular brake system warning light is
also on, you don’t have anti-lock brakes and there’s
a problem with your
regular brakes.
See “Brake System Warning Light” earlier in this part.
Traction Disabled Message
If this message is displayed, there’s a problem with your traction control
system and your vehicle needs service. When this message is displayed,
the system will not limit wheel spin. Adjust your driving accordingly.
-,.
c-
2-80

Downloaded from www.Manualslib.com manuals search engine Fuel Data Panel
Your Fuel Data Panel tells you all you need to know about your fuel
economy and how far you can travel with the fuel remaining. Here's how
it works.
Press
the AVG button to display the Average Mile Per Gallon (AVG
MPG). You can also display
it in metric units by pressing the ENG MET
button.
-.
When AVG MPG is selected, the total distance is divided by the total fuel -.-
used.
When the
INST button (Instantaneous Fuel Economy) is selected, you
will see what your fuel economy is at that instant. The computer takes a
new reading twice every second. It
will show economy up to 70 miles per
gallon (or
two liters per 100 Kilometers).
c4
L .#
To reset the average fuel economy, press the INFORMATION button I.-
until the AVG MPG is displayed on the Driver Information Center
(DIC). Press and hold the
RESET button until both the Fuel Data Center
and DIC display reads
0.0. Another method to reset the average fuel
economy is to press
the AVG button to display the average miles per
gallon.
Then press the RESET button followed by the AVG button to
reset
this calculation.
2-86

Downloaded from www.Manualslib.com manuals search engine Driver Information Center Control Buttons
AVG
DtSPtAV
WOFF
TRIP
SET
INFORMATION Button
Pressing the INFORMATION button repeatedly will display the
ENGINE RPM (Digital Cluster only), ENGINE COOLANT TEMP,
BATTERY VOLTAGE, AVG MPH, MPG AVG, FUEL USED, OIL
LIFE
LEFT and TIMER.
RESET Button
Pressing the RESET button will reset the AVG MPH, MPG AVG, FUEL
USED, OIL LIFE LEFT and TIMER when each function is displayed.
TIMER Button
The TIMER feature is like a stopwatch, in that you can clock the time it
takes to get from one point to another.
To operate, press either the TIMER button or successively press the
INFORMATION button
until TIMER 0O:OO:OO is displayed on the Driver
Information Center. Each
of the fields for the HOURS, MINUTES and
SECONDS are two numeric digits.
Once
TIMER 0O:OO:OO is displayed, press the TIMER button to start the
timing feature.
Press the TIMER button again to stop it. If you will be
starting and stopping
your Cadillac, during a trip for instance, the TIMER
feature will automatically start timing where it left off when you last
stopped.
To reset it, press and hold the RESET button until the display
(L4
L.
_4
t
c-
2-88

Downloaded from www.Manualslib.com manuals search engine .-
reads TIMER 0O:OO:OO. Press the INFORMATION button to exit from
the TIMER function.
AVG MPH (Average Speed) Reset
Press repeatedly the INFORMATION button to display the AVG MPH,
then press and hold the RESET button until
0.0 AVG MPH is displayed.
MPG AVG (Average Fuel Economy) Reset
Press repeatedly the INFORMATION button to display the MPG AVG,
then press and hold the RESET button until
0.0 AVG MPG is displayed.
Another method to reset both AVG MPG is
to press the AVG button on
the Fuel Data Panel until 0.0 AVG MPG is shown in both displays.
Fuel Used Reset
Press repeatedly the INFORMATION button to display the FUEL
USED on the Driver Information Center, then press and hold the
RESET button until
FUEL USED 0.0 is displayed.
Oil Life Left Reset
Press repeatedly the INFORMATION button to display the OIL LIFE
LEFT, then press and hold the RESET button until
0.0 OIL LIFE LEFT
is displayed.
DISPLAY ON/OFF Button
Pressing this button will turn off the Driver Information Center (DIC),
Electronic Climate Control and
Fuel Data Center displays. If you have
the digital cluster, the fuel gage, trip odometer and odometer will also
turn off. While displays are off, pressing the INFORMATION button
will
only turn on the DIC. If any other button is pressed or a driving warning
message needs to be displayed or fuel level falls below four gallons, all the
displays will come back on.
TRIP SET Button
Press and hold this button to set the trip odometer back to zero.
ENG/MET (English/Metric Button)
Press this button to switch from English (miles and Degrees Fahrenheit)
to metric (kilometers and Degrees Celsius).
2-89