Page 163 of 410

Downloaded from www.Manualslib.com manuals search engine LOW OIL LEVEL - 36
For correct operation of the low oil sensing system, the vehicle should be
on a level surface.
A false LOW OIL LEVEL message may appear if the
vehicle is parked
on grades. The oil level sensing system does not check
for actual oil level
if the engine has been off for a short period of time,
and the
oil level is never sensed while the engine is running. If the LOW
OIL LEVEL message appears, and your vehicle has been parked on level
ground with the engine
off for at least 30 minutes, your oil level should be -
checked by observing the oil dipstick. Prior to checking your oil level be
sure your engine has been
off for five minutes and your vehicle is on a
level surface. Then check
your dipstick and add oil if necessary. See
“Engine Oil”
in the Index.
CHECK WASHER FLUID - 25
This message will appear for a few seconds indicating that you need
washer solvent.
CHANGE OIL SOON - 40
This message will appear when you have used 90% of the engine oil’s
expected life, based on your driving patterns.
CHANGE ENGINE OIL - 82
This means that the life of your engine oil has expired and it should be
changed
within 200 miles. See “Engine Oil” and “Filter
Recommendations” in your maintenance schedule booklet. After an
oil
change the Oil Life Index must be reset. See “Oil Life Indicator” in the
Index on how to reset it.
CRUISE ENGAGED - 43
This message will appear for a few seconds when you select a speed at
which to cruise.
ENGINE COOLANT HOT - 44
This message will appear when your engine coolant temperature is over
248” F (126O C). To avoid added strain on a hot engine turn off your
Climate Control system. Stop and allow your vehicle to idle
until it cools
down or the message is removed.
If it does not cool down, turn off your
engine and have
it serviced before driving it again. Severe engine damage
can result from an overheated engine. See “Engine Overheating”
in the
Index.
Y-
2-92
Page 281 of 410
Downloaded from www.Manualslib.com manuals search engine ENGINE OIL
A CHECK OIL LEVEL message will appear when the engine oil is
approximately
a quart low. If the message is displayed, check the dipstick
level and add
oil as needed.
It’s
a good idea to check your engine oil every time you get fuel. In order
to get an accurate reading, the oil must be warm and the vehicle must be
on level ground.
Turn
off the engine and
give the oil a
few
minutes to drain back
into the oil
pan. If you
don’t, the oil dipstick
might not show the
actual level.
6-10
c1
Cr
c-
--
Page 282 of 410
Downloaded from www.Manualslib.com manuals search engine rcT To Check Engine Oil
Pull out the dipstick and clean it with a paper towel or cloth, then push it
back in all the way. Remove it again, keeping the tip down, and check the
r level.
,-
Wiben to Add Oil
If ,the oil is at or below the ADD line, then you’ll need to add some oil.
For crankcase capacity, see “Capacities and Specifications” in the Index.
- But you must use the right kind. This part explains what kind of oil to use.
Don’t add too much oil. If your engine has so much oil that the
operating range, your engine could be damaged.
- oil level gets above the upper mark that shows the proper
Page 283 of 410
Downloaded from www.Manualslib.com manuals search engine I To remove, turn the
fill cap
counterclockwise. oil L-5
t*
Just fill it enough
to put the level somewhere in the proper operating
range. Push the dipstick
all the way back in when you’re through.
What Kind of Oil to Use
Oils of the proper quality for your vehicle can be identified by looking for
the “Starburst” symbol. The “Starburst” symbol indicates that the oil has
been certified by the American Petroleum Institute (API), and is
preferred for use
in your gasoline engine.
If you change your own oil, be sure you use oil that has the “Starburst”
symbol
on the front of the oil container. If you have your oil changed for
you, be sure the oil put into your engine is American Petroleum Institute
certified for
gasoline engines.
6-12