1994 OLDSMOBILE BRAVADA fuel

What Kind of Oil to Use
Beginning midyear 1993, oils of the
proper quality for your vehicle will be
identified with this new “starburst”
symbol. The “starburst” symbol
indicates that the oil has been certified
by the American Petroleum Institute
(API), and is preferred for use in your
gasoline engine.
You should look for this on the front of
the oil container, and use only oils that
display this new symbol.
You should also use the proper viscositJ
oil for your vehicle, as shown in the
following chart:
I RECOMMENDED SAE VISCOSITY GRADE ENGINE
FOR BEST FUEL ECONOMY AND COLD STARTING,
SELECT THE LOWEST SAE VISCOSITY GRADE OIL
FOR THE EXPECTED TEMPERATURE RANGE.
Y
HOT
WE
-
“F
k100
+so
+SO
+40
+20
0
ATHER __
COLD
-
“C
t38
t 21
t16
t4
-7
-18

LOOK FOR
ONE OF THESE
LABELS
SAE 5W-30 PREFERRED
IF NEITHER SAE 5W-30 NOR SAE 1OW-30 GRADE OILS ARE AVAILABLE, SAE 30 GRADE MAY BE USED AT TEMPERATURES WEATHER ABOVE 40 DEGREES F (4 DEGREES c).
DO NOT USE SAE 1OW-40, SAE 2OW-50 OR ANY OTHER GRADE OIL NOT RECOMMENDED.
Is shown in the chart, SAE 5W-30 is
lest for your vehicle. However, you can
Ise
SAE 1OW-30 if it’s going to be 0°F
:-lS.C)
or above. These numbers on an
)il container show its viscosity, or thickness.
Do not
use other viscosity oils,
such as SAE
IOW-40 or SAE 20W-50.
If you cannot find oils with the new
“starburst” symbol on the front of the
container, you should look for and use
oils containing the following three things:
SH or SG
“SH”
or “SG” must be on the oil
container, either by itself or combined
with other quality designations, such as “SH/CD,” “SH,SG,CD,” “SG/CD,” etc.
These letters show American Petroleum Institute (API) levels of quality.
SAE 5W-30
Energy Conserving I1
Oils with these words on the
container will help you save fuel.
These three things are usually included
in a doughnut shaped logo (symbol) on
most containers.
If you cannot find oils
with the “starburst” symbol, you should
look for oils with the doughnut shaped
symbol, containing the three things
noted above.
169
ProCarManuals.com

I
1
1
1
1
1
i 1
i
i
i
1
MFD BY GENERAL MOTORS COW XXlKx
c- GAWRFRT CAWRRR
THIS VEHICLE CONFORMS TO ALL APPLICABLE US. FEDERAL
OF MANUPACTURE SwOwN ABOVE. MOTOR w1ICLE SAFEl’Y STANDARDS IN EPFECT ON TAE DATE
MODEL:
WAX
RR FRT
SPA LmG
SERIAL
NUMBER M.P.V.
SPEED PAYLOAD
TIRESIZE
RTC RIM PSVWA (COLD)
SEE
OWNER’S MANUAL POR ADDITIONAL INPORMATlON
Loading Your Vehicle
The Certificatioflire label is found on
the rear edge of the driver’s door. The
label shows the size of your original
tires and the inflation pressures needed
to obtain the
gross weight capacity of
your vehicle.
This is called the GVWR
(Gross Vehicle Weight Rating). The
GVWR includes the weight of the
vehicle, all occupants, fuel and cargo.
The Certificationnire label also tells
you the maximum weights for the front
md rear axles, called Gross Axle
Weight Rating (GAWR). To find out the
3ctual loads on your front and rear
des, you need to go to a weigh station
md weigh your vehicle. Your dealer can
help
you with this. Be sure to spread out
your load equally on both sides of
the centerline.
Never exceed the GVWR for your
vehicle, or the Gross Axle Weight
Rating (GAWR) for either the front or
rear axle.
And,
if you do have a heavy load, you
should spread it out. Using heavier
suspension components
to get added durability might not
change your weight ratings. Ask your
dealer to help you load your vehicle the
right way. NOTICE:
Your warranty does not cover parts
or components that fail because of
overloading.
If you put things inside your vehicle -
like suitcases, tools, packages, or
anything else
- they will go as fast as
the vehicle goes. If you have to stop or
turn quickly, or
if there is a crash,
they’ll keep going.
183
ProCarManuals.com

Sewice & Appearance Care
Payload
The Payload Capacity is shown on the
Certificationflire label. This is the
maximum load capacity that your
vehicle can carry. Be sure to include the
weight of the people inside as part of
your load. If you added any accessories
or equipment after your vehicle left the
factory, remember to subtract the weight
of these things from the payload.
Your dealer can help you with this.
Trailering Package
If your vehicle comes with the trailering
package, there is also a load rating
which includes the weight of the vehicle
and the trailer it tows. This rating is
called the Gross Combination Weight
Rating (GCWR)
.
When you weigh your trailer, be sure to
include the weight of everything you put
in it. And, remember to figure the weight
of the people inside as part
of your load.
Your dealer can help you determine
your GCWR.
Add-on Equipment
When you carry removable items, you
may need to put a limit on how many
people you carry inside your vehicle. Be
sure to weigh your vehicle before you
buy and install the new equipment.
NOTICE:
Your warranty doesn’t cover parts
or components that fail because of
overloading.
I Single Belt Accessory Drive
Your new vehicle uses a serpentine belt
that is lighter, more durable and fuel
efficient than systems with several belts.
The belt runs over or around the pulleys
on the engine.
A tensioner is used to
keep the belt tight at all times. The
tensioner also makes replacing the belt
easier.
If you need to replace the belt, be
sure to get the correct replacement belt.
Your dealership or parts supplier can
help you with this. The Accessory Drive
Belt Routing label on your vehicle will
show you how to route the belt your
vehicle uses.
I Air Conditioning
Every now and then have your
dealership check your air conditioning
system to be sure it has not lost any
cooling ability. If you think the system
is not working properly, have your
dealership check it out as soon as
possible.
The air conditioning will not work when
the temperature is below
40°F (4°C).
ProCarManuals.com

Service & Appearance Care
186
Inflation-Tire Pressure
The Certification/Tire label which is
on the rear edge
of the driver’s door
shows the correct inflation pressures
for your tires, when they’re cold.
“Cold” means your vehicle has been
sitting for at least three hours or driven
no more than
a mile. Also see
Capacities G Specifications in the
Index.
NOTICE:
Don’t let anyone tell you that
underinflation
or overinflation is all
right. It’s not. If your tires don’t
have enough air (underinflation)
you can get:
Too much flexing
Too much heat
Tire overloading
Bad wear
Bad handling
Bad fuel economy.
If your tires have too much air
(overinflation)
) you can get:
Unusual wear
Bad handling
Rough ride
Needless damage from road
hazards.
When to Check
Check your tires once a month or more.
Also, check the tire pressure
of the
spare tire.
How to Check
Use a good quality pocket-type gage to
check tire pressure. Simply looking at
the tires will not tell you the pressure,
especially if you have radial tires
-
which may look properly inflated even if
they’re underinflated.
If your tires have valve caps, be sure to
put them back on. They help prevent
leaks by keeping out dirt and moisture.
ProCarManuals.com

Sewice & Appearance Care
194
Aluminum Wheels
Your aluminum wheels have a
protective coating similar to the painted
surface of your truck. Don’t use strong
soaps, chemicals, chrome polish,
abrasive cleaners or abrasive cleaning
brushes on them because you could
damage this coating. After rinsing
thoroughly, a wax may be applied.
NOTICE:
Don’t use an automatic vehicle
wash that has hard silicon carbide
cleaning brushes. These brushes
can take off the protective coating.
1 Weatherstrips
Silicone grease on weatherstrips will
make them last longer, seal better, and
not stick or squeak. Apply silicone
grease with
a clean cloth at least every
six months. During very cold, damp
weather more frequent application may
be required. (See
Recommended Fluids
G Lubricants in the Index.)
Sheet Metal Damage
If your vehicle is damaged and requires
sheet metal repair or replacement,
make sure the body repair shop applies
anti-corrosion material to the parts
repaired or replaced to restore
corrosion protection.
Foreign Material
Calcium chloride and other salts, ice
melting agents, road oil and tar, tree sap,
bird droppings, chemicals
from
industrial chimneys, and other foreign
matter can damage your vehicle’s finish
if they remain on painted surfaces. Use
cleaners that are marked safe for painted
surfaces to remove foreign matter.
Finish Damage
Any stone chips, fractures or deep
scratches in the finish should be
repaired right away. Bare metal will
corrode quickly and may develop into a
major repair expense.
Minor chips and scratches can be
repaired with touch-up materials available from your dealer or
other
service outlets. Larger areas of finish
damage can be corrected in your
dealer’s body and paint shop.
Underbody Maintenance
Chemicals used for ice and snow
removal and dust control can collect on
the underbody.
If these are not
removed, accelerated corrosion (rust)
can occur on the underbody parts such
as fuel lines, frame, floor pan, and
exhaust system even though they have
corrosion protection.
At least every spring, flush these
materials from the underbody with plain
water. Clean any areas where mud and
other debris can collect. Dirt packed in
closed areas of the frame should be
loosened before being flushed. Your
dealer or an underbody vehicle washing
system can do this for you.
Chemical Paint Spotting
Some weather and atmospheric
conditions can create a chemical fallout.
Airborne pollutants can fall upon and
attack painted surfaces on your vehicle.
This damage can take two forms:
ProCarManuals.com

INST LPS PWR ACC
HORNIDM IGNIGAU BRAKE STOPIHAZ
h TAIL LPS TURNIBU HTR A/C RADIO
%se Usage
Position
INST LPS
PWR ACC
HORN/DM
IGN/GAU BRAKE
STOP/HAZ
TAIL LPS
TURNDU HTR A/C RADIO
ECM B
ECM I
PWR WDO
WIPER
CRANK
TRAILER*
Rating
(AMP.)
5
30
20
20
15
15
20
15
25
15
15
10
30
25
3
30
UNDERHOOD':' 4
CD PLAYER 10
"In-line fuse.
Circuitry
Instrument Panel Lights, Headlight Warning Buzzer, Heater
Light, Ashtray Light, Radio Illumination Light, Rear Wiper
Switch Light
Power Door Locks, Rear Defogger, Console Accessory
Receptacles, CD Player
Horn, Dome Lights, Glove
Box Light, Clock, Lighter, Lighted
Vanity Mirror, Outside Rearview Mirror, Courtesy Lights
Indicator Lights and Gages, Rear Defogger Relay, Cruise
Control, Rear Defogger Switch, Seat Belt Timer
Four Wheel Anti-lock Brake Module, Digital Ratio Adapter
Module (Speedometer)
Stop Lights, Hazard Warning Lights, Chime Module, Center
High Mounted Stop Light (CHMSL)
Light Switch, TaiVPark Lights, Electronic Cluster, License Light
Turn Signals
& Back-up Lights
Heating and Air Conditioning
Radio, Inside Rearview Mirror Map Lights, Rear Wiper, Rear
Washer, Compass
Electronic Control Module, Fuel Pump
Electronic Control Module
Power Windows
Windshield Wipers and Washer
Electronic Control Module
Trailer Wiring Harness
Underhood Light
CD Player (attached to fuse block)
197
ProCarManuals.com

I Capacities & Specifications
I Automatic Transmission
Pan Removal and Replacement ................................... 5 quarts
After Complete Overhaul
............................................ 10.5 quarts
Cooling System ................................................................... 11.8 quarts
Refrigerant (R-12), Air Conditioning .............................. 2 lb. 5 oz.
4.7 L
9.9 L
11.2 L
1.13 kg
Not all air conditioning refrigerants are the same. If
the air conditioning system in your vehicle needs
refrigerant, be
sure the proper refrigerant is used. If
you’re not sure, ask your Oldsmobile dealer. For
additional information, see your “Warranty and
Owner Assistance Information” booklet.
Engine Crankcase
Without filter ................................................................ 4 quarts 3.8 L
With filter ..................................................................... 4.5 quarts 4.3 L
Fuel Tank ........................................................................\
.... 20 gallons 76 L
Wheel Nut Torque .............................................................. 95 pound-feet 130 N*m
NOTE: All capacities are approximate. When adding, be sure to fill to the appropriate level on the dipstick, or as
Tire Pressure, All ................................................................ 35 psi 240 ltPa
recommended in this manual.
199
ProCarManuals.com

Service & Appearance Care
200
Engine Specifications
4.3L V6 Engine
VIN Engine Code ................................................................. W
Type ........................................................................\
.............. V6
Displacement
....................................................................... \
4.3 Liters
Compression Ratio
............................................................... 9.1 : 1
Firing Order ........................................................................\
. 1-6-5-4-3-2
Thermostat Temperature Specification
............................... 195°F (91OC)
Normal Maintenance Replacement Parts
Air Cleaner Element .................................................................. AC Type A1 163C
Engine Oil Filter
........................................................................\
AC Type PF-51
Fuel Filter
........................................................................\
.......... GF481
PCV Valve
........................................................................\
......... AC Type CV-892C
Spark Plugs
........................................................................\
........ AC Type oCR43TSM
Gap: 0.045 inch (1.14
rnm)
ProCarManuals.com