1994 OLDSMOBILE BRAVADA air condition

Features di Controli
64
Overhead Console
The front overhead console has reading
lights, a center dome light, a compass
and outside temperature display, and
storage compartments-including one
for your garage door opener and one for
sunglasses.
Temperature and Compass
Display
The outside air temperature and the
compass are displayed at the front
of
the overhead console. The control
switches are located to the left
of the
display.
Turn the display on or
off by pressing
the
ON/OFF switch. Display the
temperature in either degrees
Fahrenheit (English)
or Celsius (metric)
by pressing the
US/MET switch.
Before you turn on the ignition and move
the vehicle, the temperature indicated
will be the last outside temperature
recorded with the ignition on. If
the outside temperature is
37°F (3°C)
or lower when you turn on the ignition,
ICE will appear on the display. It's a
caution to the driver that road
conditions may be icy, and that
appropriate precautions should be
taken.
Compass Calibration:
The compass is self-calibrating, so it
does not need to be manually set.
However, when your Bravada is new,
the compass may function erratically.
If
it does, CAL (Calibration) will appear
on the display.
To correct the problem,
drive in a complete
360" circle three
times, and the compass will function
normally.
ProCarManuals.com

The oil light could also flash on in three
other situations:
. When the ignition is on (in the Run
position) but the engine is not
running, the light will come on as a
test to show you it is working, but the
light will
go out when you turn the
ignition to
Start. If it doesn't come on
with the ignition on, you may have a
problem with the fuse. Have it fixed
right away.
Sometimes when the engine is idling
at a stop, the light may flash on and
off. This is normal.
If you make a hard stop, the light may
come on for a moment. This is normal.
0-
A \
Voltmeter (ELEcmoNIc CLUSTER)
Your charging system gage will show
the rate of charge when the engine is
running. When the engine
is not
running but the ignition is on (in the
Run position), the display measures the
voltage output
of your battery, and will
flash until you turn the ignition to
Start.
The reading will change as the rate of
charge changes (with engine speed,
etc.), but readings between the warning
zones indicate the normal operating
range. Readings in either warning zone
indicate a possible problem with your
charging system. Have your Oldsmobile
serviced immediately. You
also have a warning light.
A box
around the battery symbol will flash
when the charging system needs
service.
If it comes on while you are driving, you
may have a loose belt or other problem
with the electrical charging system.
Have it checked right away. Driving
while this light is on could drain your
battery.
If
you must drive a short distance with
the light on, be certain to turn off all
your accessories, such as the radio and
air conditioner.
U
87
ProCarManuals.com

Features & Controls
90
CHECK
OAGES
Battery Light (STANDARD CLUSTER)
The battery light will come on briefly
when you turn on the ignition as a
check to show you it is working. It
should go out once the engine
is
running. If it stays on, or comes on
while you are driving, you may have a
loose belt or other problem with the
electrical charging system. Have it
checked right away. Driving while this
light is on could drain your battery.
If
you must drive a short distance with
the light
on, be certain to turn off all
your accessories, such as the radio and
air conditioner.
I
CHECK
GAGES
Check Gages Ljght
(STANDARD CLUSTER)
This light will come on briefly when you
are starting the engine. If the light
comes on and stays on while you are
driving, check your various gages to see
if they are in the warning zones.
ProCarManuals.com

Comfort Cont'rok &Audio Systems
LO HI
Climate Control System
Your vehicle's heater and air
conditioner work best
if you keep your
windows closed. Your vehicle also has
flow-through ventilation, described later
in this section, to bring outside air into
your vehicle.
3f Fan Lever: The lever at the top has
four positions. Move it toward
HI to
increase the air flow. To decrease the
air flow, move it toward
LO.
Temperature Lever: Slide the lever on
the left to control the temperature of the
air flow into the vehicle. Move the lever
up for warmer air, down for cooler air.
Function Lever: Slide the lever on the
right to select the function desired. The
air conditioner compressor will operate
in all settings except
VENT and HTR
(Heater) when the outside temperature
is above freezing. When the air
conditioner compressor cycles
on, you
may sometimes notice slight changes in
your vehicle's engine performance and
power. This is normal, because the
system is designed to keep the desired
cooling level and help fuel economy. There are
three air conditioning
settings:
MAX A/C, NORM A/C, and
BI-LEV A/C. On very hot days, your
vehicle will cool down more quickly and
economically in any of these settings
if
you open the windows long enough to
let hot inside air escape. For all settings,
adjust the temperature control lever and
fan speed as desired.
MAX A/C: Select this setting to get
maximum cooling or quick cool-down
on very hot days. This setting
recirculates much of the air inside your
vehicle. It should not be used for long
periods
of time because the air may
become too cold and dry.
Also slide the temperature control lever
down to the coolest setting and adjust
the fan speed as desired.
NORM A/C: Use this setting for
normal cooling on hot days. This setting
cools outside air and directs it through
the instrument panel outlets.
BI-LEV A/C: Use on cool but sunny
days. This setting brings in outside air,
but directs it two ways-through the
instrument panel outlets and the heater
ProCarManuals.com

ducts at your feet. At times this
temperature difference may be more
apparent than others.
VENT: The vent setting brings in
outside air through the instrument
panel outlets and at your front side
windows.
HTR The heater setting brings in most
heated air through the heater ducts, and
some through the defroster vents.
If you have the optional engine coolant
heater and use it during cold weather,
20°F (-8°C) or lower, your heating
system will more quickly provide heat
because the engine coolant is already
warmed. See the
Index under Engine
Coolant Heater.
most of the warmed air to the
windshield and side windows. Some
will also
go to the floor vents.
The air conditioner will also run in this
setting to remove moisture from the air
when the temperature is above
40°F
(4°C). Adjust the temperature control
as desired.
(Defrost): This setting directs
Defogging and Defrosting
To rapidly defrost the windshield, slide
the temperature control lever all the
way up and select the
(j@ setting.
Adjust the fan to the highest speed.
To rapidly defog the side windows,
select the
BI-LEV AfC setting and
adjust the fan to the highest speed. Aim
the side vents toward the side windows.
For increased air flow to the side vents,
close the center vents.
r
93
ProCarManuals.com

Comfort Con&ols &Audio Systems
94
Rear Window Defogger
Press ON to warm the defogger grid on
:he rear window. The indicator light
will glow while the rear window
iefogger is operating. The defogger will
:urn off automatically after about
10
ninutes. If you turn it on again, the
iefogger will operate for about five
ninutes only.
You can turn the defogger
Iff by turning off the ignition or
?ressing
OFF.
Do not attach a temporary vehicle
.icense across the defogger grid on the
:ear window.
NOTICE:
Don't use a razor blade or
something else sharp on the inside
of the rear window. If you do, you
could cut or damage the warming
grid, and the repairs wouldn't be
covered by your warranty.
Flow-Through Ventilation System
Your vehicle's flow-through ventilation
system supplies outside air into the
vehicle when
it is moving. Outside air
will also enter the vehicle when the
heater
or the air conditioning fan is
running.
Ventilation Tips
Keep the hood and front air inlet free
of ice, snow, or any other obstruction
(such as leaves). The heater and
defroster will work far better,
reducing the chance of fogging the
inside
of your windows.
weather, slide the function lever to
HTR and turn the blower fan to HI
for a few moments before driving off.
When you enter a vehicle in cold
ProCarManuals.com

all conditions-both on and off paved
surfaces, no matter
if the weather is fair
or foul.
The heart of the AWD system is the
transfer case. Here, engine power is
divided by an interaxle differential.
Under normal conditions,
it sends 65
percent of the torque to the rear axle and
the other 35 percent to the front axle.
But on a slippery surface, a viscous
clutch in the transfer case adjusts the
65/35 proportion according to need,
sending more power to the axle with
traction.
Another feature of the AWD system
that helps Bravada keep its grip is the
limited-slip rear axle. In conditions
where one rear wheel
loses traction but
the other still has some-as when one
wheel hits an icy patch or slips onto a
muddy road shoulder-this design
provides power to the wheel with
traction. And AWD is simple. It’s
always there-working.
Braking
Braking action involves perception
time
and reaction time.
First, you have to decide to push on the
brake pedal. That’s
perception time.
Then you have to bring up your foot
and do it. That’s
reaction time.
Average reaction time is about 3/4 of a
second. But that’s only an average. It
might be less with one driver and as
long as two or three seconds or more
with another. Age, physical condition,
alertness, coordination, and eyesight all
play a part.
So do alcohol, drugs and
frustration. But even in
3/4 of a second,
a vehicle moving at 60 mph
(100 km/h)
travels 66 feet
(20 m). That could be a
lot
of distance in an emergency, so
keeping enough space between your
vehicle and others is important.
And, of course, actual stopping
distances vary greatly with the surface
of the road (whether it’s pavement or
gravel); the condition of the road (wet,
dry, icy); tire tread; and the condition of
your brakes. Avoid needless heavy braking. Some
people drive in spurts
- heavy
acceleration followed by heavy braking
- rather than keeping pace with traffic.
This is a mistake. Your brakes may not
have time to cool between hard stops.
Your brakes will wear out much faster if
you
do a lot of heavy braking. If you
keep pace with the traffic and allow
realistic following distances, you will
eliminate a lot of unnecessary braking.
That means better braking and longer
brake life.
If your engine ever stops while you’re
driving, brake normally but don’t pump
your brakes. If you do, the pedal may
get harder to push down. If your engine
stops, you will still have some power
brake assist. But you will use it when
you brake. Once the power assist is
used up, it may take longer to stop and
the brake pedal will be harder to push.
109
ProCarManuals.com

Problems on the Road
146
NOTICE:
If your engine catches fire because
you keep driving with no coolant,
your vehicle can be badly damaged.
The costly repairs would not be
covered by your warranty.
If No Steam Is Coming From Your
Engine
If you get the overheat warning but see
or hear no steam, the problem may not
be too serious. Sometimes the engine
can get a little too hot when you:
Climb a long hill on a hot day.
Stop after high speed driving.
Idle for long periods in traffic.
Tow a trailer.
If you get the overheat warning with no
sign of steam, try this for a minute or
so:
1. Turn off your air conditioner.
2. Turn on your heater to full hot at the
highest fan speed and open the
window as necessary.
3. If you’re in a traffic jam, shift to
N (Neutral). If
you no longer have the overheat
warning, you can drive. Just to be safe,
drive slower for about ten minutes.
If
the warning doesn’t come back on, you
can drive normally.
If the warning continues, pull over,
stop, and park your vehicle right away.
If there’s still no sign of steam, push the
accelerator until the engine speed is
about twice as fast as normal idle speed.
Bring the engine speed back to normal
idle speed after two or three minutes.
Now see
if the warning stops. But then,
if you still have the warning, TURN
OFF THE ENGINE AND GET
EVERYONE OUT
OF THE VEHICLE
until it cools down.
You may decide not to lift the hood but
to get service help right away.
Cooling System
When you decide it’s safe to lift the
hood, here’s what you’ll see:
(A) Coolant recovery tank
(B) Radiator pressure cap
If the coolant inside the coolant
recovery tank is boiling, don’t do
anything else until it cools down.
ProCarManuals.com