1994 GMC SIERRA light

on the instrument
panel also will be on.
Windshield Wipers
turning the band with
the wiper symbol on
it.
For a single wiping cycle, turn the band to
MIST. Hold it there until the
wipers start, then let go. The wipers will stop after one cycle. If you want
more cycles, hold the band on
MIST longer.
You can set the wiper speed for a long or short delay between wipes. This
can be very useful in light rain or snow. Turn the band to choose the delay
time. The closer to
LO, the shorter the delay.
For steady wiping at low speed, turn the band to the
LO position. For high
speed wiping, turn the band further, to
HI. To stop the wipers, move the
band to the
off symbol.
Remember that damaged wiper blades may prevent you from seeing well
enough to drive safely,
To avoid damage, be sure to clear ice and snow from
the wiper blades before using them. If they
are frozen to the windshield,
carefully loosen or thaw them. If your blades do become damaged, get new
blades or blade inserts.
.. . .-
.Y
ProCarManuals.com

Using Cruise Control on Hills
How well your Cruise Control will work on hills depends upon your speed,
load, and the steepness of the hills. When going up steep hills, you may
have to step
on the accelerator pedal to maintain your speed. When going
downhill, you may have to brake or shift to a lower gear to keep your speed
down.
Of course, applying the brake takes you out of Cruise Control. Many
drivers find this to be too much trouble and don’t use Cruise Control on
steep hills.
To Get Out of Cruise Control
There are two ways to turn off the Cruise Control:
0 Step lightly on
the brake pedal or
push the clutch
pedal, if you have
a manual
transmission
OR;
0 move the Cruise switch to
OFF.
To Erase Speed Memory
When you turn off the Cruise Control or the ignition, your Cruise Control
set speed memory is erased.
2-48
1
ProCarManuals.com

Headlights and Vehicle Lighting
Your light switches
are on
the left side of
your instrument panel.
Push
the left side of the switch with the parking lights symbol on it to turn
on:
Parking Lights
Sidemarker Lights
Clearance Lights (if you have them)
Taillights
License Plate Lights
Instrument Panel Lights
0 Transfer Case Shift Indicator Light (if you have one)
Push the
left side of the switch with the master lighting symbol on it to turn
on all the lights listed above as well as the headlights.
Push the right side of the switch
with the off symbol on it to turn off your
lights.
Turn the dial
at the right of the off switch to adjust instrument panel lights.
Turning the dial all the way up
until it clicks turns on the interior lights.
You can switch your headlights from high to
low beam by pulling on the
turn signal/high beam lever.
A circuit breaker protects your headlights. If you have an electrical
overload, your headlights will flicker on and off. Have your headlight
wiring checked right away
if this happens.
2-49
ProCarManuals.com

Headlights-On Reminder
A buzzer will sound when your headlights are turned on and your ignition is
in
OFF, LOCK or ACC. If you need to use your headlights when the
ignition switch is in
OFE LOCK or ACC, the buzzer can be turned off by
turning the interior light switch dial all the way
off.
Daytime Running Lights (DRL) Indicator Light
(Canada On/y)
If your vehicle was
first sold, when new,
in Canada, you will
have this light on the
instrument panel.
It goes on whenever
the Daytime Running
Lights are on.
Daytime Running Lights (Canada On/y)
The Canadian Federal Government has decided that “Daytime Running
Lights” (DRL)
are a useful feature, in that DRL can make your vehicle more
visible to pedestrians and other drivers during daylight hours. DRL are
required on new vehicles sold in Canada.
The high beam headlights will come on at reduced brightness in daylight
when:
The ignition is on,
The headlight switch is off, and
The parking brake is released.
When you turn on your headlights, the DRL will switch
off and the exterior
lights will come on. When you turn
off the headlights, the exterior lights
will go out and the high beams will change to the reduced brightness of
DRL again. The
DRL indicator light on the instrument panel will go on
whenever the DRL are on. This light means that only the DRL are on. When
you turn on your exterior lights, this light will go out.
Of course, you may still turn on the headlights any time
you need to.
To idle your vehicle with the DRL
off, set the parking brake. The DRL will
stay
off until you release the parking brake.
ProCarManuals.com

Dome Lights
The dome lights will come on when you open the doors. You can also turn
the dome lights
on by turning the interior light dimmer dial all they way up
until it clicks.
If you have a Crew
Cab, you can use the
dome- lamp switch,
located below the
headlight switch,
to
set the dome lamps to
come on automatically
or remain
off.
To turn the lights off, just press the side of the switch marked OFF. To
return the lights to automatic operation, press the side marked AUTO.
Reading Lights
If your vehicle has
reading lights, press
the bar
next to the
light
to turn the light
on. Press the bar again
to turn the light
off.
2-51
ProCarManuals.com

If your vehicle has an
overhead console with
reading lights, they
can be swiveled to
point
in the direction
you want.
To turn the light on, press the button next to the light with the master
lighting switch symbol on it. Press the button again
to turn the light off.
Cargo Lamp
To turn your optional
cargo lamp on,
push
the side of the switch
with the cargo lamp
symbol on it.
The switch is below the main light switch. The interior light switch
must be
on or one of the doors open for the cargo lamp to work.
2-52
ProCarManuals.com

Underhood Reel Light
... .
If you have an
underhood reel light,
it is located inside the
engine compartment
on the passenger side
fender. You can use
it
as a flashlight.
To use the light, pull up on the lever and pull the light out. The cord will
unreel as
you pull the light.
When you are done
using the light, reel
the cord back into the
housing by turning the
handle.
Then, slide the light into the holder. Press
PUSH on the lever to hook the
light into the holder.
2-53
ProCarManuals.com

Mirrors
Inside Mirror
Push or pull the tab
under the mirror to
reduce glare from
headlights behind you
after dark.
Outside Mirrors
1
Electric Outside Rearwie w Mirrors
Adjust your outside
mirrors
so you can
just see the side of
your vehicle, and have
a clear view
of objects
behind you. Some
mirrors can be folded
in to enter narrow
doorways.
If you have electric mirrors, they can be adjusted to point where you want
from inside the vehicle.
ProCarManuals.com