1994 GMC SIERRA wheel size

Jack Storage
Your jack and wheel ratchet are behind the passenger seat. Turn the wing
nut to the left and remove the cover if there is one.
Spare Tire Storage-Underbody Carrier
Remember, never remove or restow a tire from or to a stowage position
under the vehicle while the vehicle is supported only by a
jack.
Spare Tire
Your spare tire may be
mounted underneath
the rear
of the vehicle,
OR;
it may be mounted to
the inside
of the truck
bed on the driver’s
side.
If you have a chassis cab, refer to the information from the body
supplier/installer.
The spare tire is
a full size tire, like the other tires on your vehicle.
5-29
ProCarManuals.com

If your vehicle has front tires with different load ratings or tread designs
(such
as all season vs. on/off road) than the rear tires, don’t rotate your tires
front
to rear.
After the tires have been rotated, adjust the front and rear inflation pressure
as shown on the CertificatiodTire label. Make certain that all wheel nuts are
properly tightened. See “Wheel
Nut Torque” in the Index.
A CAUTION:
Rust or dirt on a wheel, or on the parts to which it is fastened,
When It’s Time for New Tires
TREAD WEAR
INDICATORS
One way to tell when
it’s time for
new tires
is to check the
treadwear indicators,
which
will appear
when your tires have
only
2/32 inch (1.6
mm) or less of tread
remaining.
You need a
new tire if:
0 You can see the indicators at three or more places around the tire.
0 You can see cord or Fabric showing through the tire’s rubber.
0 The tread or sidewall is cracked, cut or snagged deep enough to show
cord or fabric.
The tire has a bump, bulge or split.
The tire has a puncture, cut, or other damage that can’t be repaired well
because
of the size or location of the damage.
6-74
ProCarManuals.com

Dual Tire Rotation
n
Use one of these
patterns if you have
the same tire sizes and
load ranges on
the
front and rear.
Use
this pattern if
your front and rear
tires are different sizes
or load ranges. The
dual rear tires are
rotated
as a pair and
the inside rear tires
become the outside
rear tires.
When you install dual wheels, be sure
the vent holes in the wheels are lined
UP.
6-75
ProCarManuals.com

Dual lire Operation
If your vehicle has dual rear wheels, the outer tire will usually wear faster
than the inner tire. Your tires will wear more evenly and last longer
if you
rotate the tires periodically. If you’re going to be doing a lot of driving on
high-crown roads,
you can reduce tire wear by adding 5 psi (35 kPa) to the
tire pressure in the outer tires. Be sure to return to the recommended
pressures when
no longer driving under those conditions.
Buying New Tires
To find out what kind and size of tires you need, look at the
CertificationRire label.
The tires installed on your vehicle when it was new had
a Tire Performance
Criteria Specification
(TPC Spec) number on each tire’s sidewall. When you
get new tires, get ones with that same TPC Spec number. That way, your
vehicle will continue
to have tires that are designed to give proper
endurance, handling, speed rating, traction, ride and other things during
normal service on your vehicle. If your tires have an all-season tread
design, the TPC number will be followed by a
“MS” (for mud and snow).
If you ever replace your tires with those not having
a TPC Spec number,
make sure they are
the same size, load range, speed rating and construction
type (bias, bias-belted or radial) as your original tires.
6-76
ProCarManuals.com

NOTICE:
The wrong wheel can also cause problems with bearing life,
brake cooling, speedometer/odometer calibration, headlight aim,
bumper height, vehicle ground clearance, and tire or tire chain
clearance to the body and chassis.
Used Replacement Wheels
Tire Chains
NOTICE:
If your vehicle has dual wheels or LT26Y75R16 size tires, don’t
use tire chains; they can damage your vehicle.
If you don’t have
dual wheels or
if you have a tire size other than LT265/75R16,
use tire chains only where legal and only when you must. Use
only SAE Class “S” type chains that are the proper size for your
tires. Install them on the tires of the rear axle. Tighten them as
tightly
as possible with the ends securely fastened. Drive slowly
and follow the chain manufacturer’s instructions.
If you can
hear the chains contacting your vehicle, stop and retighten them.
If the contact continues, slow down until it stops. Driving too
fast with chains on will damage your vehicle.
6-79
ProCarManuals.com