1994 CHEVROLET BLAZER belt

Downloaded from www.Manualslib.com manuals search engine Rear Seat Passengers
It’s very important for rear seat passengers to buckle up! Accident statistics
show that unbelted people
in the rear seat are hurt more often in crashes
than those who are wearing safety belts.
Rear passengers who aren’t safety belted can be thrown
out of the vehicle in
a crash. And they can strike others in the vehicle who are wearing safety
belts.
Rear Seat Outside Passenger Positions
Lap-Shoulder Belt
The positions next to the windows have lap-shoulder belts. Here’s how to
wear
one properly.
1. Pick up the latch plate and pull the belt across you. Don’t let it get
2. Push the latch plate into the buckle until it clicks.
twisted.
1-24

Downloaded from www.Manualslib.com manuals search engine Pull up on the latch plate to make sure it is secure.
On four-door models, when the shoulder belt is pulled out all the way,
it will lock.
If it does, let it go back all the way and start again.
If the belt is not long enough, see “Safety Belt Extender” at the end of
this section.
Make sure the release button on the buckle is positioned
so you would
be able to unbuckle the safety belt quickly if you ever had to.
To make the lap part tight, pull down on the buckle end of the belt as
you pull up on the shoulder part.
The lap part
of the belt should be worn low and snug on the hips, just
touching the thighs. In a crash, this applies force to the strong pelvic bones.
And you’d be less likely to slide under the lap belt.
If you slid under it, the
belt would apply force at your abdomen. This could cause serious or even
fatal injuries. The shoulder belt should go over the shoulder and across the
chest. These parts of the body are best able to take belt restraining forces.
1-25

Downloaded from www.Manualslib.com manuals search engine The safety belt locks if there’s a sudden stop or a crash.
Children
To unlatch the belt,
just push the button on
the buckle.
Everyone
in a vehicle needs protection! That includes infants and all
children smaller than adult size. In fact, the law
in every state in the United
States and
in every Canadian province says children up to some age must be
restrained while
in a vehicle.
1-26

Downloaded from www.Manualslib.com manuals search engine Two-Door Four-Door
. .. ./
Child Restraints
Be sure to follow the instructions for the restraint. You may find these
instructions
on the restraint itself or in a booklet, or both. These restraints
use the belt system
in your vehicle, but the child also has to be secured
within the restraint
to help reduce the chance of personal injury. The
instructions that come with the infant or child restraint will show you how
to
do that.
1-28

Downloaded from www.Manualslib.com manuals search engine Securing a Child Restraint in a Rear Outside Position
- Four-Door Models
You’ll be using the lap-shoulder belt. See the earlier part about the top strap
if the child restraint has one.
1. Put the restraint on the seat. Follow the instructions for the child
restraint.
2. Secure the child in the child restraint as the instructions say.
3. Pick up the latch plate, and run the lap and shoulder portions of the
vehicle’s safety belt through or around the restraint. The child restraint
instructions will show
you how.
If the shoulder belt goes in front of the child’s face or neck, put it
behind the child restraint.
4. Buckle the belt.
Make sure the
release
button is
positioned
so you
would be able to
unbuckle the
safety belt
quickly
if you
ever had to.
1-30

Downloaded from www.Manualslib.com manuals search engine 5. Pull the rest of
the shoulder belt
all the way out of
the retractor to
set the lock.
6. To tighten the
belt, feed
the
shoulder belt into
the retractor while
you push
down
on the child
restraint.
7. Push and pull the
child restraint in
different
directions to be
sure it
is secure.
To remove the child restraint, just unbuckle the vehicle’s safety belt and let
it
go back all the way. The safety belt will move freely again and be ready to
work for an adult or larger child passenger.
1-31

Downloaded from www.Manualslib.com manuals search engine Securing a Child Restraint in a Rear Outside Position
- Two-Door Models
You’ll be using the lap-shoulder belt. See the earlier part about the top strap
if the child restraint has one.
1. Put the restraint on the seat. Follow the instructions for the child
restraint.
2. Secure the child in the child restraint as the instructions say.
3. Pick up the latch plate, and run the lap and shoulder portions of the
vehicle’s safety belt through or around the restraint. The child restraint
instructions will show you how.
If the shoulder belt goes in front of the
child’s face or neck, put
it behind the child restraint.
4. Buckle the belt.
Make sure the
release button is
positioned
so you
would be able to
unbuckle the
safety belt
quickly if you
ever had to.
1-32

Downloaded from www.Manualslib.com manuals search engine 5. Press the “cinch”
button
on the
retractor cover
to
set the lock.
6. To tighten the belt, feed the shoulder belt back into the retractor while
you push down on the child restraint.
7. Push and pull the
child restraint in
different
directions to be sure it is secure.
To remove the child restraint, just unbuckle the vehicle’s safety belt and let
it go back all the way. The safety belt will move freely again and be ready to
work for an adult or larger child passenger.
1-33