Page 134 of 323

Comfort Controls & Audio Systems
AM/FM Stereo with Compact
Disc Player
(CONT.)
When Finished with the Compact
Disc Player:
If you press POWER or turn off the
ignition, the disc will stay in the player
and
start again when you turn on the
ignition or power switch. The disc will
begin playing at the point where it had
been stopped.
ST/PL (Stop/Play): Press to stop the
disc player; the radio will play. Press
again to play the disc (the player will
start playing the disc where it was
stopped earlier).
EJCT (Eject): Press to eject the disc;
the radio will play.
CD Player Anti-Theft Fieature
Delco LOC II@ is a security feature for
the compact disc player. It can be used
or ignored. If ignored, the system plays
normally.
If it is used, your player won’t
be usable if it is ever stolen, because it
will go to
LOC mode any time battery
power is removed. Until an unLOC
code is entered, it will not
turn on.
The instructions below tell you how to
enter a secret code into the system.
If
your vehicle loses battery power for any
reason, you must unlock the system with
the secret code before the radio will turn
on.
To Set the Anti-Theft System:
1. Write down any six-digit number and
keep it in a safe place.
2. Turn the ignition to the Accessory or
Run position.
3. Press the POWER button to turn the
radio
off.
4. Press the PREV and FF buttons
together. Hold them down until
“- - -” shows on the display (at least
five seconds). You are ready to enter
your secret code.
NOTE:
If you allow more than 15
seconds to elapse between any steps, the
radio automatically reverts to time and
you must
start the procedure over at step 4.
ProCarManuals.com
Page 135 of 323

5. Press SET and 000 will appear on
the display.
6. Press and hold SEEK until the first
digit of your code appears.
7. Press and hold SCAN until the
second and third digits of your code
appear.
8. Press AM/FM and 000 will appear
again. Now you are ready to enter
the last three digits of your code.
9. Repeat steps 6 and 7 for the last
three digits of your code.
1 0. Press AM/FM and rEP will appear.
1 1. Repeat steps 6 through 10. This time
SEC will appear, indicating that the
radio is secure.
If “- - -” appears,
the steps were
not successful and
you must repeat the entire
procedure.
To Unlock the System After a Power
Loss:
When battery power is reapplied to a
secured radio, the radio won’t turn
on
and LOC will appear on the display.
Enter your secret code as follows; pause
no more than
15 seconds between steps.
1. Turn the ignition on. (Radio off.)
2. Press the SET button. The display
will show
000.
3. Enter the six digits of the code
following steps
6-9 above. The
display will show the numbers as
entered.
4. Press the AM/FM button and the
time appears, indicating that the
disabling sequence was successful.
If
the display indicates SEC, the
numbers did not match and the unit is
still secured.
Disabling the Anti-Theft System:
1. Press PREV and FF together for five
seconds with the ignition on and
radio power off. The display will
show SEC, indicating the unit is in
the secure mode. (If
“- - -” appears
on the display, the anti-theft system
has already been disabled.)
2. Press the SET button. The display
will show
000.
3. Enter the first three digits of the code
following steps
6 and 7 of the
preceding paragraphs. The display
will show the numbers as entered.
4. Press AM/FM. The radio will
display
000.
5. Repeat steps 6 and 7 to enter the second
three digits
of the code. The display
will show the numbers as entered.
6. Press
AM/FM. If bb- - -” then the
time appears, the disabling sequence
was successful (the numbers matched
the secret code) and the unit is in the
UNSECURED mode. If the display
shows
SEC, the disabling sequence
was unsuccessful (the numbers did
not match) and the
unit will remain
in the SECURED mode.
133
ProCarManuals.com
Page 178 of 323

Your Driving and the Road
176
lf You’re Caught in a Blizard
(CON X)
Run your engine only as long as you
must. This saves fuel. When you run
the engine, make it go a little faster
than just idle. That is, push the
accelerator slightly. This uses less fuel for the heat that you get and it keeps
the battery charged.
You will need a
well-charged battery to restart the
vehicle and possibly for signaling later
on with your headlights. Let the heater
run for a while. Then,
shut the engine off and close
the window almost all the way to preserve the heat.
Start the engine
again and repeat this only when you feel really uncomfortable from the
cold. But
do it as little as possible.
Preserve the fuel as long as you can.
To help keep warm, you can get out of
the vehicle and do some fairly
vigorous exercises every half-hour or
so until help comes.
If Mu’re Stuck in Deep Snow
This manual explains how to get the
vehicle out
of deep snow without
damaging it. See the
Index under
Rocking Your Ehicle.
ProCarManuals.com
Page 189 of 323
Jump Starting
If your battery has run down, you may
want to use another vehicle and some
jumper cables to start your Oldsmobile.
But please follow the steps below to do
it safely.
MU I IUIV
I; Batteries can hurt you. They
h can be dangerous because:
They contain acid that can burn
They contain gas that can
They contain enough electricity
If you don’t follow these steps
exactly, some or all
of these things
can hurt you.
you.
explode
or ignite.
to burn you. Ignoring
these steps could result in
costly damage to your vehicle that
wouidn’t becovered by your
warranty.
Trying to start your Oldsmobile
b
pushing or pulling it won’t work,
and it could damage your vehicle
To Jump Start Your Oldsmobile:
1. Check the other vehicle. It must have
a 12-volt battery with a negative
ground system.
ProCarManuals.com
Page 190 of 323
Problems on the Road
i
I
I
I
I88
Jump Starting (CONT.)
2. Get the vehicles close enough so the
jumper cables can reach, but be sure
the vehicles aren’t touching each other.
If they are, it could cause a
ground connection you don’t want.
You wouldn’t be able to start your
Oldsmobile, and the bad grounding
could damage the electrical systems.
You could be injured
if the
L vehicles roll. Set the parking
brake
firmly on each vehicle. Put
an automatic transaxle in
P (Park)
or a manual transaxle
in N (Neutral).
3. Turn off the ignition on both
vehicles.
Turn off all lights that aren’t
needed, and radios.
This will avoid
sparks and help save both batteries.
And it could save your radio!
4. Open the hoods and locate the
batteries.
r An electric fan can start up
even when the engine is not
I
I uming and can injure you. Keep
hands, clothing and tools away
from any underhood electric fan.
Find the positive
(+) and negative
(-) terminals on each battery.
ProCarManuals.com
Page 191 of 323

Your Oldsmobile has a remote positive
(+) jump starting terminal. The terminal
is in the red box on the same side
of the
engine compartment as your battery.
You should always use the remote
positive
(+) terminal instead of the
positive
(+) terminal on your battery.
To open the remote positive (+)
terminal box, pull the tab and open the
cover.
A
Using a match near a battery
can cause battery gas to
explode. People have been
hurt
doing this, and some have been
blinded. Use a flashlight if you
need more light.
You don’t need to add water to the
Delco Freedom@ battery installed
in every new
GM vehicle. But if a
battery has filler caps, be sure the
right amount of fluid is there. If
it
is low, add water to take care of
that first. If you don’t, explosive
gas could be present.
Battery fluid contains acid that can
bum you. Don’t get it on
you. If
you accidentally get it in your eyes
or
on your skin, flush the place
with water and get medical help
immediately.
5. Check that the jumper cables don’t
have loose or missing insulation. If
they do, you could get a shock. The
vehicles could be damaged, too.
Before you connect the cables, here are
some things you should know. Positive
(+) will go to positive (+) and negative
(-) will go to negative (-) or a metal
engine part. Don’t connect
(+) to (-) or
you’ll get a short that would damage the
battery and maybe other parts, too.
Fans
or other moving engine
parts can injure you badly.
Keep your hands away bm
moving parts once the engines are
running. I
I89
ProCarManuals.com
Page 192 of 323
Jump Starting (CONT.)
6. Connect the red positive (+) cable to
the positive
(+) terminal of the
vehicle with the dead battery. Use a
remote positive
(+) terminal if the
vehicle has one.
0
7. Don’t let the other end touch metal.
Connect
it to the positive (+)
terminal of the good battery. Use a
remote positive (+) terminal if the
vehicle has one.
8. Now connect the black negative (-)
cable to the good battery’s negative
(-) terminal.
Don’t let the other end touch anything
until the next step. The other end
of the
negative cable
doesn’t go to the dead
battery. It goes to a heavy unpainted metal part on the engine of the vehicle
with the dead battery.
9. Attach the cable at least 18 inches
(45 cm) away from the dead battery,
but not near engine parts that move.
The electrical connection is just as
good there, but the chance of sparks
getting back to the battery is much
less.
ProCarManuals.com
Page 193 of 323
10. Now start the vehicle with the good
battery and run the engine for a
while.
1 1. Try to start the vehicle with the
dead battery.
If it won’t start after a
few tries, it probably needs service.
-wP
1
1 2. Remove the cables in reverse order
to prevent electrical shorting. Take
care that they don’t touch each other
or any other metal.
X51 O(
Towing Your Oldsmobile
Try to have a GM dealer or a
professional towing service tow your
Oldsmobile. The usual towing
equipment is
:
(A) Sling-type tow truck
(B) Wheel-lift tow truck
(C) Car carrier
If your vehicle has been changed or
modified since it was factory-new by
adding aftermarket items like
fog lamps,
aero skirting, or special tires and
wheels, these instructions and
illustrations may not be correct.
Before
you do anything, turn on the
hazard warning flashers.
191
ProCarManuals.com