1993 Oldsmobile Cutlass Supreme bulb

70
Features & Controls
Turn Signal and Lane Change
Indicator
(CONT.)
A green arrow on the instrument panel
will flash in the direction of the turn or
lane change.
To signal a lane change, just raise or
lower the lever until the green arrow
starts to flash. Hold it there until you
complete your lane change. The lever
will return by itself when you release it.
As you signal a turn or a lane change, if
the arrows don’t flash but just stay on,
a
signal bulb may be burned out and
other drivers won’t see your turn signal.
If a bulb is burned out, replace it to help
avoid an accident.
If the green arrows
don’t go on at all when
you signal a
turn, check the fuse (see the
Index
under Fuses G Circuit Breakers) and
for burned-out bulbs.
A warning chime will remind you if you
have left your turn signal on for more
than
‘/2 mile (-8 km) of driving.
. Cruise Control (OPTION)
With cruise control, you can maintain a
speed of about
25 mph (40 lun/h) or
more without keeping your foot on the
accelerator. This can really help on long
trips.
Cruise control does not work at speeds
below about
25 mph (40 lun/h).
When you apply your brakes, the cruise
control shuts off.

i-
Features & Controls
96
Low Coolant Warning Light
If this light comes on, your system is
low on coolant and the engine may
overheat.
See the
Index under Engine Coolant
and have your vehicle serviced as soon
as you can.
Oil Warning Light
(E LE CTRONlC CLUSTER)
If you have a problem with your oil, this
light may stay on after you start your
engine,
or come on when you are
driving. This indicates that oil is not
going through your engine quickly
enough to keep it lubricated. The engine
could be low
on oil, or could have some
other oil problem. Have it fixed right
away. The
oil light could also come
on in three
other situations:
When the ignition is on but the engine
is not running, the light will come on
as a test to show you it is working, but
the light will go out when you turn the
ignition to
Start. If it doesn’t come on
with the ignition on, you may have a
problem with the fuse or bulb. Have it
fixed right away.
Sometimes when the engine is idling
at a stop, the light may blink on and
off. This is normal.
If you make a hard stop, the light may
come on for a moment. This is
normal.

Your Driving and the Road
Driving with a Trailer (CONT.)
Making Turns
When you’re turning with a trailer,
make wider turns than normal.
Do this
so your trailer won’t strike soft
shoulders, curbs, road signs, trees, or
other objects. Avoid jerky or sudden
maneuvers. Signal well in advance.
Turn Signals When Towing a Trailer
When you tow a trailer, your vehicle has
to have
a different turn signal flasher
and extra wiring. The green arrows
on
your instrument panel will flash
whenever you signal a turn or lane
change. Properly hooked up, the trailer
lights will also flash, telling other
drivers you’re about to turn, change
lanes or stop. When towing a
trailer, the green arrows
on your instrument panel will flash for
turns even if the bulbs on the trailer are
burned out. Thus, you may think
drivers behind you are seeing your
signal when they are not. It’s important
to check occasionally to be sure the
trailer bulbs are still working.
Driving On Grades
Reduce speed and shift to a lower gear
before you start down a long or steep
downgrade.
If you don’t shift down, you
might have to use your brakes
so much
that they would get hot and
no longer
work well.
On a long uphill grade, shift down and
reduce your speed to around
45 mph
(70 lm/h) to reduce the possibility of
engine and transaxle overheating.
If you are towing a trailer and you have
an automatic transaxle with Overdrive,
you may want to drive in
D instead of
(or, as you need to, a lower gear).

Service & Appearance Care
Bulb Replacement
240
Baffery
Every new Oldsmobile has a Delco
Freedom@ battery. You never have to
add water to one of these. When it’s
time for a new battery,,+we recommend a
Delco Freedom@ battery. Get one that
has the catalog number shown on the
original battery’s label.
Jump Starting
For jump starting instructions, see the
Index under lump Starting.
Vehicle Storage
If you’re not going to drive your vehicle
for
25 days or more, take off the black
negative
(-) cable from the battery. This
will help keep your battery
from
running down. In
this section you’ll find directions for
changing the light bulbs in some of the
lights on your Oldsmobile. You’ll also
find directions for adjusting the
alignment of the mini-quad headlights,
if you have this type.
Be sure to read the directions before
you begin to replace or adjust any lights
See the
Index under Replacement
Bulbs to find the type of bulb you need
to use.
Batteries have acid that can
burn you and gas that can
explode. You can be badly hurt
if
you aren’t careful. See the Index
under Jump Starting for tips on
working around a battery without
getting hurt.
Contact your deakr to
learn how to
prepare your vehicle for .longer storage
periods.
Halogen Bulbs ~~

4. Now adjust the vertical aim. Check
the vertical aim for each headlight
and adjust it as necessary.
5. Turn the vertical aiming screw until
the bubble
in the level is centered at
0 (zero).
To Replace a Headlight
(2-DOOR MODELS)
Before replacing a headlight that does
not light, check to make sure that the
wiring connector is securely fastened to
it.
See the
Index under Replacement
Bulbs to check the size and type of
headlight
you need to use before you
begin
to replace the headlight. You
must replace a headlight with one that
is exactly the same.
1. Pry up the plastic pins and remove
the headlight cover.
243

6. Plug the wiring connector into the
headlight socket. Snap the locking
tabs onto the socket.
headlight assembly. The socket must
be pointing in the same direction the
socket on the burned-out bulb was.
7. Place the new headlight in the
8. Insert the tabs on the aiming ring
into the slots in the headlight
assemblv.
9. Holding the aiming ring closed, insert
the screws at the end
of the ring.
Tighten the screws until the aiming
ring touches the plastic nuts
on both
the top and bottom.
Do not
overtighten.
Do not damage the
vertical aiming bubble.
245

Service & Appearance Care
246
To Replace a Headlight (CONT.)
To check the aim, the vehicle should be
properly prepared as follows:
The vehicle must have all four tires on
a perfectly level surface.
The vehicle should not have any
snow, ice or mud attached to it.
There should not be any cargo or
loading of vehicle, except it should
have a full tank
of gas and one person
or
160 pounds (75 kg) on the driver's
seat.
Tires should be properly inflated.
The horizontal indicator should read
0 (zero). If
your vehicle is damaged in
an
accident and the headlight aim seems to
be affected, see your Oldsmobile dealer.
Headlights on damaged vehicles may
require recalibration of the horizontal
aim by your Oldsmobile dealer.
Headlight Replacement
(4-DOOR MODELS)
See the Index under Replacement
Bulbs to check the type of bulb to use.
To Replace a Bulb:
1. Turn the L-shaped bulb assembly
counterclockwise
*I6 turn until the
flanges align with the slots in the
retainer ring. You may need to twist
it back and forth slightly to loosen it.

3. Pull the taillight housing away from
4. Press the bulb housing release lever
the
body
of the vehicle.
and turn the housing
'16 turn
counterclockwise to remove it.
5. To replace the bulb, pull it from the
6. Reverse all steps to reassemble the
assembly.
taillight.
Fog Light Bulb Replacement
Oldsmobile recommends that you not
change your
fog light bulb unless you
have the proper aiming equipment. See
your Oldsmobile dealer for help with
this.
249