INSTRUCTIONS FOR ALUMINUM TYPE
WHEELSN2zGFM
1. Aluminum is vulnerable to alkalies. If a vehicle
washing detergent has been used, or salt from
sea water or road chemicals has adhered, washthe vehicle as soon as possible. After washing
the vehicle, apply body or wheel wax to the
aluminum type wheels to prevent corrosion.
2. When cleaning the vehicle with steam, do not
direct steam onto the aluminum type wheels.
When tightening nuts for aluminum type
wheels, particularly observe the following:
(1) Cl;Zl;lsthe hub surface of aluminum type
(2) After finger-tightening wheel nuts, tighten
them to specifications.
(3) Do not use an impact wrench or push the
wrench by foot to tighten the wheel nuts.
(4) Do not apply oil to the threaded portions.
INSTRUCTIONS FOR TIRE CHAINS AND
SNOW TIRES
1.Use tire chains only on front wheels. Do not usetire chains on rear wheels.
2. When using snow tires, use them on all four
wheels for maneuverability and safety.
INSTRUCTIONS FOR COMPACT
TIRE
1. The compact spare tire is designed
space in the luggage compartment,
lighter weight makes it easier to use if
occurs.g
2.-- IThe following instructions for the compact spare .,z,tire should be observed.
i/(1) Check the inflation pressure after installing ii,the spare, and adjust to the specified
pres-..$i
sure.t’
(2) Avoid driving through automatic car washes
and over obstacles that could possiblyage the vehicle’s undercarriage. Because
the tire is smaller than the
original tire,
ground clearance is slightly reduced,
(3) The compact spare tire should not be
used: i5iS:on any other wheels, nor should standard
i;:?tires, snow tires, wheel covers or trim rings
Ibe used with the compact spare wheel. If.
1.;such use is attempted, damage to these
items or other vehicle components may
’
occur.
,i
23-48BODY - Moulding
lBAOO55(3) Remove
backrng paper from adhesive tape, and applyspecified adhesive tape as shown in the illustration,
Specified adhesive tape:
3M ATD Part No. 6383 or equivalent
(4) Apply
specrfred sealant to the places shown in the
rllustratidn.
Specified sealant: 3M Super Fast Urethane PrimerPart No. 8608 or equivalent
(5) Attach the side protect mouldings at the places shown
In the illustration.
(6) Use hand roller or similar tool to apply even pressure toentire surface of moulding.
NOTEPress moulding ends
f.irmly against the body surface.
Side protect moulding mounting positionsMA0400
Front doorFront door or
front fender panel
Section A-A
Section B-B
BODY - Aero P&s23-75 ‘!:j:
18A0411Door side garnishSide air dam
0 Adhesive tapea Adhesive tape(Thickness 1 2 mm
(047 In )>(.l 18 in.)>18A0912
(2) Using an infrared light or similar instrument, heat the
body painted surface and the side air dam.
Heating temperature
Body painted surface.. . . .
25-55OC (77- 131 OFI
Side air dam . . . . . . . . . . . . . . . . 25-40°C (77-104OF)
(3) Peel off the paper from the-adhesive tape, apply specified
adhesive and sealant at the places shown in the figure,and attach to the body adhesive surface.
Specified adhesive tape:
-3M. ATD Part No.6383 or
equivalent
(4) Using a hand roller or similar tool, apply pressure to theentire surface of the side air dam.
NOTEThe ends of the side air dam tend to loosen easily, so
apply manual pressure again.
