1993 GMC SIERRA four wheel drive

CAUTION
It can be dangerous to get out of your vehicle if the shift lever is not
fully in
P (Park) with the parking brake firmly set. Your vehicle can
roll.
If you have left the engine running, the vehicle can move suddenl\
y.
You
or others could be injured. To be sure your vehicle won’t move,
when you’re on fairly level ground, use the steps that follow.
If you have four-wheel drive and your transfer case is in N (Neutral),
your vehicle will be free to
roll, even if your shift lever is in P (Park).
So, be sure the transfer case is in a drive gear-not in N (Neutral).
If you are parking on a hill, or if you’re pulling a trailer, also see
“Parking On Hills” in the Index.
When You Are Ready to Leave After Parklng on a Hill
1. Apply your regular brakes and hold the pedal down while you:
Start your engine;
Shift into a gear; and
Release the parking brake.
2. Let up on the brake pedal.
3. Drive slowly until the trailer is clear of the chocks.
4. Stop and have someone pick up and store the chocks.
Maintenance When Trailer To wing
Your vehicle will need service more often when you’re pulling a trailer. See
the Maintenance Schedule for more on this. Things that are esp\
ecially
important in trailer operation are automatic transmission fluid (don’t overfill),
engine oil, axle lubricant, belts, cooling system, and brake ad\
justment. Each
of these is covered in this manual, and the Index will help \
you find them
quickly.
If you’re trailering, it’s a good idea to review these sections before
you start your trip.
Check periodically
to see that all hitch nuts and bolts are tight.
mailer Wiring Harness
See “Trailer Wiring Harness’’ in the Index.
4-61
ProCarManuals.com

Your Driving and the Road
Power Winches
i !
If you wish to use a power winch on your vehicle, only use it \
when your
vehicle is stationary or anchored.
i
NOTICE
Use the regular brakes, set the parking brake or block the wh\
eels to keep
your vehicle from rolling.
Power rake-off (PTO)
Before using a power take-off, refer to the manufacturer’s or installer’s
instructions.
To engage a power take-off:
1. Set ths parking brake.
2. Shift the transmission into N (Neutral).
3. Hold the clutch pedal down and engage the power take-off.
*
If you are going to drive the vehicle, shift the transmission int\
o the gear
you want. Then shift the transfer case into the range you wan\
t
(if you
have four-wheel-drive), apply the regular brakes and release th\
e parking
brake.
When you release the clutch, the power take-off will start.
4. Release the clutch (and the regular brakes) as you normally \
would.
4-62
ProCarManuals.com

Pmbkms on the Road
not be able to get enough power from a single battery in another vehicle
to start your diesel engine.
If your vehicle has more than one battery, use the battery that’\
s closest
to the starter-this will reduce electrical resistance.
2. Get the vehicles close enough so the jumper cables can reach, but be
sure the vehicles aren’t touching each other.
If they are, it could cause a
ground connection you don’t want. You wouldn’t be able
to start your
vehicle, and the bad grounding could damage the electrical syst\
ems.
You could be injured
if the vehicles roll. Set the parking brake firmly
manual transmission in
N (Neutral).
If you have a four-wheel-drive vehicle, be sure the transfer c\
ase is
not in
N (Neutral).
1 on each vehicle. Put an automatic transmission in P (Park) or a
3. Turn off the ignition on both vehicles. Turn off all lights that aren’t need-
ed, and radios. This will avoid sparks and help save both bat\
teries. And
it could save your radio!
ou leave your radio on, it could be badly damaged. The repairs
r.,Jldn’t be covered by your warranty. I
4. Open the hoods and locate the batteries.
Find the positive
(t) and negative (-) terminals on each battery.
5-4
ProCarManuals.com

Problenrs on the Road
Towing Your Vehicle
Try to have a GM dealer or a professional towing service tow your vehicle.
They can provide the right equipment and know how to tow it without dam-
age.
If your vehicle has been changed since it was factory-new, by adding things
like fog lamps, aero skirting, or special tires and wheels, th\
ese things could
be damaged during towing.
Before you do anything, turn on the hazard warning flashers.
When you call, tell the towing service:
That your vehicle has rear-wheel drive, or that it has the four-wheel drive
option.
The make, model, and year of your vehicle.
Whether you can move the shift lever for the transmission and \
transfer case,
if you have one.
If there was an accident, what was damaged.
I A To help avoid injury to you or others:
Never let passengers ride in a vehicle that is being towed.
Never tow faster than safe or posted speeds.
Never tow with damaged parts not fully secured.
Never get under your vehicle after it has been lifted by the tow
truck.
Always use separate safety chains on each side when towing a
vehicle.
When your vehicle is being towed, have the ignition key
off. The steering
wheel should be clamped in a straight-ahead position, with a clamping device
designed for towing service.
Do not use the vehicle’s steering column lock for
this. The transmission and transfer case,
if you have one, should be in Neu-
tral and the parking brake released.
If you have a two-wheel drive vehicle, don’t have your vehicle \
towed on the
rear wheels, unless you must. If the vehicle must be towed on\
the rear
wheels, don’t go more than
35 mph (56 km/h) or farther than 50 miles (80
krn) or your transmission will be damaged. If these limits must be exceeded,
then the rear drive wheels have to be supported on a dolly.
5-8
ProCarManuals.com

If your vehicle has the four-wheel-drive option and the transfer c\
ase is
engaged, a dolly must be used under the rear wheels when towi\
ng from the
front.
Engine Overheating
You will find a coolant temperature gage on your vehicle instrument\
panel. If
you have a diesel engine, you will also find a low coolant light on your
instrument panel.
If Steam Is Coming From Your Engine:
K2509
I CAUTION
A
Steam from an overheated engine can burn you badly, even if you
just open the hood. Stay away from the engine
if you see or hear
steam coming from it. Just turn
it off and get everyone away from
the vehicle until
it cools down. Wait until there is no sign of steam
or coolant before opening the hood.
If you keep driving when your engine is overheated, the liquids in it
can catch fire. You or others could be badly burned. Stop your
engine
if it overheats, and get out of the vehicle until the engine is
cool.
5-9
ProCarManuals.com

Hydraulic Clutch Grease Fitting
A grease fitting is on the clutch housing for lubricating the clutch fork ball
stud. See your Maintenance Schedule for when to lubricate the clutch
housing. See “Recommended Fluids and Lubricants” in the Index for the
proper lubricant to use.
Be sure not to over-fill because you could damage your clutch.
Four- Wheel Drive
Most lubricant checks in this section also apply to four-wheel-drive vehicles.
However, they have two additional systems that need lubrication.
Transfer Case
When to Check Lubricant:
Refer to the Maintenance Schedule to determine how often to check the
lubricant. See “Periodic Maintenance Inspections” in the Index.
How to Check and Add Lubricant:
I
PO230
If the level is below the bottom of the filler plug hole, you’ll need to add
some lubricant. Add enough lubricant to raise the level to the bottom of the
filler plug hole.
What to Use:
Refer to the Maintenance Schedule to determine what kind of lubricant to
use. See “Recommended Fluids and Lubricants” in the Index.
639
ProCarManuals.com

I I Power Rating I 1
Lamp or Bulb
Malfunction Indicator (“Service Engine
Quantity
at 12.8V, Watts Trade No.
Soon”)
“Diesel only
**Crew Cab Only tCanadian Vehicles only t0390
1 .7
74
Service Fuel Filter Lamp*
1 .7
74
Low Coolant Lamp*
1 .7 74 Glow Plugs Lamp*
1 .7
74
Upshift Indicator
1 .7
74
Service Replacement Part and Filter Recommendations
Engine
(VIN)
4.3 (Z)
5.0 (H)
5.7 (K)
6.2 (C)
6.2
(J)*
6.5 (F)*
7.4
(N)
-
Oil
Filter
PF51
PF35t
PF35t
PF35
PF35
PF35
PF35
-
Air
Cleaner
A1 78CW A348C
A348C
A644C A644C
A917C
A348C
PCV
Valve
CV789C
cv774c
cv774c
-
-
-
cv774c I I
tFour Wheel Drive Vehicles use a PF51
*Heavy
Duty Emission Engine
1,
Spark** Plugs
CR43TS
.CR43TS
.CR43TS
-
-
.CR43TS
oil filter
’*Use AC copper-cored resistor type spark plugs.
Fuel
Filter
GF481
GF481
GF481
TP 1
006
TP 1 006
TP1006
GF481
-I
RC36
RC36
RC32
RC32
RC32
RC36
t0039
6-99
ProCarManuals.com

Service & Appearance Care
Fuses and Circuit Breakers
Name
Gages
Turn-B/U EMCllgn
Inj. A
Brake
AC/Htr
Ctsy
Park LP P. Lps
StoplHaz. Wiper
Radio
Accll g n
.
Acc/Batt. Crank 4WD
DRL
Circuits Protected
Cruise Control, 4 WD Display Illum. Rear
Window Defogger Timer, Aux. Batt. Relay
Feed, Safety Belt Buzzer Timer, Cluster
Ign. Feed
Back-up Lamps, Turn Signals
T.C.C., Air Diverter, E.S.C., E.G.R., E.C.M.
Ign., R.W.A.L. Brake Switch
Throttle Body Injectors R.W.A.L., Cluster-Speed0
H.V.A.C.
4 WD, Aux. Batt. Relay
Dome Lamp, Cargo Lamp, Ctsy. and Glove
Box Lps. (TR-9), Radio (Memory-Clock)
Horn Relay, Horn Feed, Cigar Lighter, Park
Lamps
C49 SW Illum., Headlamp “On” Warning,
Radio Illum., H.V.A.C. Illum.
Haz. Flasher, Seat Belt Buzzer, Stop
Lmps., R.W.A.L. Memory
Windshield Wiper, Washer
Radio Feed
Pwr. Windows
Door Locks, Rear Window Defogger
Crank, Discreet Four Wheel Drive
Daytime Running Lights
Fuse
20 Amp
15 Amp
10 Amp
10 Amp
15 Amp
25 Amp
20 Amp
20 Amp
5 Amp
15 Amp
25 Amp
10 Amp
5 Amp
25 Amp
15 AmD
Circuit
Breaker
30 Amp
30 Amp
An inline fuse
is used for the underhood lamp
10 not use fuses of higher amperage than those recommended above.
TO038
6-1 00
ProCarManuals.com