1993 GMC SIERRA light

Featums & Controls
Manual Transmission:
Move your shift lever to neutral and hold the clutch pedal to the floor
while starting the engine. Your vehicle won't start
if the clutch pedal is
not all -the way down-that's a safety feature.
2. Turn your ignition key to Run. Don't turn it to Start.
- LUUk
I
3. Press the accelerator pedal all the way down and then release \
it.
With the ignition in Run, the GLOW PLUGS light will come on. This
means that part
of your engine is being warmed up for better starting.
When the light goes
off, your engine is ready to start.
If the engine ls already warm, this light may not come.'on. That's normal.
4. If this light does not come on, or the instant the light goes off, turn your
ignition key to
Start. When the engine starts, let go of the key. I
2-1 6
f ProCarManuals.com

CAUTION
Plugging the cord into an ungrounded outlet could cause an ele\
ctrical
shock.
Also, the wrong kind of extension cord could overheat and
cause a fire. You could be seriously injured. Plug the cord into a
properly grounded three-prong
11 0-volt outlet. If the cord won’t reach,
use a heavy-duty three-prong extension cord rated for at least \
15
amps.
1 NOTICE
1 After you’ve used the block heater, be sure to store the cord in th~~~~
manner it was, to help keep it away from moving engine parts.\

If YOU
don’t, it could be torn and damaged.
~p@&%?yl~
How long should you keep tne MOCK neater plugged in? The answer depends
on the weather, the kind
of oil ,you have, and some other things. Follow this-
chart.
,.
ENGINE BLOCK HEATER USAGE”
Viscosity . 32’ $0 0°F ’ 0’ to -10°F ‘Belaw -1 0°F
Grade Oil (0” to &I S‘C) ’ ’ (-18’ to. -23°C) (B&w -23°C)
SAE Not Two Eight Hours
I OW-30 Required Hours or Overnight
SAE . Nit ’ . Two Eight Hours
15W-40 f3equired Hours or Overnight
..
* The times listed are minimum. times. It will not harm &her
the block heater
TO1 57
or the vehicle to leave it plugged in longer than the times stated. 3
For best results in cold weather, use Number I-D diesel fuel or a “winterized”
Number
2-D fuel.
If Your Diesel Engine Won’t- Start
If you’ve run out of fuel, look -at “Running Out Of Fuel” (see ‘‘Diesel Fuel
Requirements and Fuel System”
m the Index).
If you’re not out of fuel, and your engine won’t start, do this:
Turn y6ur ignition key
to Run. .Make sure that the GLOW PLUGS light is out.
Then turn
the ignition key to Stkrt while you ‘push the accelerator pedal
down.
2-1 8
ProCarManuals.com

. If the light. doesn’t go off, wait a few seconds, then try staiting your engine
again. And, see your dealer
as soon as you- can for a starting system check.
If the light comes on and then goes out and you know your batte\
ries are
charged, but your engine still won’t start, your vehicle nee\
ds service.
If your batteries don’t have enough .charge to start ,your engine, see “Battery”
in the Index.
Be sure you have the right oil for your engine, and that you’ve changed the
oil
at the proper times. If you use the wrong oil, your engine may be harder
to start.
If the engine starts, runs a short time, then stops, your vehicle needs service.
NOTICE
Don’t use starting “aids” such as ether or gasoline, in the m~v intakc They
could damage your engine.
..- - .- * K2214
In very cold weather, 0°F (-18°C) or colder, if you have an engine block
heater, it can help. You’ll get easier starting and better fuel economy during
engine warm-up.
2-1 9
ProCarManuals.com

To Stop-Let up on the accelerator pedal and press the brake pedal\
. Just
before the vehicle stops, press the clutch pedal and the brake pedal, and
shift to
N (Neutral).
N (Neutral)-Use this position when you start or idle your engine.
R (Reverse)-To back up, press the clutch pedal and shift into R. Let up on
the clutch pedal slowly while pressing the accelerator pedal. If you shift from
OD into R, the shift lever must first be placed in the N (Neutral) position
centered between
2 and 3 prior to shifting into R.
NOTICE I
Shift to R (Reverse) only after your vehicle is stopped. Shifting to R
(Reverse) while vour vehicle is movina could damaae vour transmission.
- -
Also, use Reverse, along with the parking brake, for parking your ve\
hicle.
Shift Light
I K2317
If you have a manual transmission, you may have a SHIFT light. This light
will show you when to shift to the next higher gear for best fuel economy.
When this light comes on, you can shift to the next higher gear
if weather,
road and traffic conditions let you. For the best fuel economy, accelerate
slowly and shift when the light comes on.
While you accelerate, it is normal for the light to go on and
off if you quickly
change the position
of the accelerator. Ignore the SHIFT light when you
downshift.
2-27
ProCarManuals.com

Features & Controls
Four-Wheel-Drive Vehicles Only: If your vehicle has four-wheel drive and is
equipped with a manual transmission, disregard the shift light \
when the
transfer case is in
4 LOW.
Shift Speeds-Manual Transmission
This chart shows when to shift to the next higher gear for best fuel economy.
MANUAL TRANSMISSION RECOMMENDED SHIFT SPEED
IN MPH (KMIH)
Engine
and
VIN
45-50 25-40 50 40 15
4,3L
V6
3 to 4 2 to 3 1 to 2 3 to 4 2 to 3 1 to 2 Code
Trans. Cruise Shift Speed
Acceleration Shift Speed
(4
- (64) (40) (24) (K)
(72-80)
(40-64) - (80) (64)
(24)
5-Speed*
40 25 15 5.7L V8
- -
* Transmission with L (low) gear only. L (low) is intended for heavy loads and
is not recommended for normal driving.
I TO1 61 I
If your speed drops below 20 mph (32 km/h), or if the engine is not running
smoothly, you should downshift to the next lower gear. You may have to
downshift two or more gears
to keep the engine running smoothly or for good
performance.
I A If you skip more than one gear when you downshift, you could lose
I & control of your vehicle: And you could injure yourself or others. I
I Ju skip more than one gear when you downshift, or if you race the
;,,,ine when you downshift, you can damage the clutch or transmission. \
I
Locking Rear Axle
If you have this feature, your rear axle can give you additional \
traction on
snow, mud, ice, sand or gravel.
It works like a standard axle most of the
time,
but when one of the rear wheels has no traction and the other does,
the locking feature
will allow the wheel with traction to move the vehicle.
2-28
ProCarManuals.com

Parking Brake
K2221
To set the parking brake:
Hold the regular brake pedal down with your right foot. Push down the
parking brake pedal with your left
foot. If the ignition is on, the brake system
warning light will come
on.
To release the parking brake:
Hold the regular brake pedal down. Pull the lever marked RELEASE.
Driving with the parking brake on can cause your rear brakes to overheat.
You may have to replace them, and you also da other p;
of I
your vehicle.
’ ‘
If you are on a hill:
See “Parking on Hills” in the Index. That part shows how to turn your front
wheels.
If you are towing a trailer and are parking on any hill:
See “Towing a Trailer” in the Index. That part shows what to do first to keep
the trailer from moving.
2-29
ProCarManuals.com

Featwes & Contmk
The front axle portion of the indicator diagram will light up when you shift into
four-wheel drive.
A slight delay between shifting and the indicator’s lighting is
normal.
If the indicator does not light up, or if the front axle light does not go
out after you shift out of four-wheel drive, have your dealer check your
system.
When your headlights or parking lights are on, rotate the dial\

to the right of
your headlight switch up
to brighten, or down to dim, your transfer case
indicator light.
Transfer Case Shift Positions
2H (High): This setting is for driving in most street and highway situations.
Your front axle is not engaged in two-wheel drive.
4H (High): This setting engages your front axle to help drive your vehicle.
Use
4H when you need extra traction, such as on wet or icy roads, or in
most
off -road situations.
N (Neutral): Shift to this setting only when your vehicle needs to be towed or
when using a power take
off.
4L (Low): This setting also engages your front axle to give you extra traction,
but should be used only for off-road or on extremely slippery surfaces.
You can shift from
2H to 4H or from 4H to 2H while the vehicle is moving.
Your front axle will engage faster
if you take your foot off of the accelerator
for a few seconds after you shift. In extremely cold weather it may be
necessary to stop or slow the vehicle to shift out of
2H.
To shift into or out of 4L or N (Neutral):
1. Slow the vehicle to a roll, about 3 mph (5 kmlh) and shift your
2. Shift the transfer case shift lever in one continuous motion.
transmission into neutral.
Don’t pause in
N (Neutral) as you shift the transfer case into 4L, or your
aears could clash.
Kernember that driving
in 4H or 4L may reduce fuel economy. Also, driving in
four-wheel drive on dry pavement could cause your tires to wea\
r faster and
make your transfer case harder
to shift.
Front Axle Locking Feature
The front axle locks and unlocks automatically when you shift the transfer
case.
A slight delay for the axle to lock or unlock is normal. If the outside
temperature is very hot, or the vehicle has been used under hard driving
conditions, there may be a slight delay for the axle to unlock.
2-38
ProCarManuals.com

Features & ContrOrs
To tilt the wheel, hold the steering wheel and pull the lever. Move the
steering wheel to a comfortable level, then release the lever to
lock the wheel
in place.
Mu/tifunction Lever
The lever on the left side of the steering column includes your:
Turn Signal and Lane Change Indicator
Headlight High-Low Beam & Passing Signal
Windshield Wipers
Windshield Washer
Cruise Control (Option)
2-42
ProCarManuals.com