
properly inflated and not overloaded.
Excessive speed, underinflation, or
excessive loading, either separately or in
combination, can cause heat buildup and
possible tire failure.
Those grades are molded on the
sidewalls of passenger car tires.
While the tires available as standard or
optional equipment on General Motors
vehicles may vary with respect to these
grades, all such tires meet General
Motors performance standards and have
been approved for use on General
Motors vehicles. All passenger type
(P metric) tires must conform to Federal
safety requirements in addition to these
grades.
Wheel Alignment and Tire Balance
The wheels on your vehicle were
aligned and balanced carefully at the
factory to give you the longest tire life
and best overall performance.
In most cases, you will not need to have
your wheels aligned again. However, if
you notice unusual tire wear
or your
vehicle pulling one way or the other, the
alignment may need to be reset. If you
notice your vehicle vibrating when
driving on a smooth road, your wheels
may need to be rebalanced.
Wheel Replacement
Replace any wheel that is bent, cracked
or badly rusted. If wheel nuts keep coming
loose, the wheel, wheel bolts,
and wheel nuts should be replaced.
If
the wheel leaks air out, replace it
(except some aluminum wheels, which
can sometimes be repaired). See your
Geo dealer if
any of these conditions
exist.
Your dealer will know the kind of wheel
you need.
If you need to replace any of your
wheels, wheel bolts, or wheel nuts,
replace them only with
new GM original
equipment parts. This way, you will be
sure to have the right wheel, wheel
bolts, and wheel nuts for your Tracker.
ProCarManuals.com

Service & Appearance Care
Finish Damage
Any stone chips, fractures or deep
scratches in the finish should be repaired
right away. Bare metal will corrode
quickly and may develop into a major
repair expense.
Minor chips and scratches can be
repaired with touch-up materials
available from your dealer or other
service outlets. Larger areas of finish
damage can be corrected in your
dealer’s body and paint shop.
Underbody Maintenance
Chemicals used for ice and snow
removal and dust control can collect on
the underbody. If these are not removed,
accelerated corrosion (rust) can occur on
the underbody parts such as fuel lines,
frame, floor pan, and exhaust system
even though they have corrosion
protection.
At least every spring, flush these
materials from the underbody
with plain
water. Clean any areas where mud and
other debris can collect. Dirt packed in
closed areas of the frame should be
loosened before being flushed. Your
dealer or an underbody vehicle washing
system can do this for you.
Chemical Paint Spotting
Some weather and atmospheric
conditions can create a chemical fallout.
Airborne pollutants can
fall upon and
attack painted surfaces on your vehicle. This damage can take two forms:
blotchy, ringlet-shaped discolorations,
and small irregular dark spots etched
into the paint surface.
Although no defect in the paint job
causes this, Geo will repair, at no
charge to the owner, the surfaces of new
vehicles damaged by this fallout
condition within
12 months or 12,000
miles (20 OOO km) of purchase,
whichever comes first.
ProCarManuals.com

Service & Appearance
I Replacement Bulbs
Care
Back-up ............................................................. 1156
Dome
............................................................. 9605 1559
Front Parking and Turn Signal
......................................... 1157 NA
Headlight (Halogen) ..................................................... 9004
Heater or Air Conditioning Control
.................................... 96052599
Charging System
................................................... 9433184
Check Engine
..................................................... 9433 184
Engineoil Pressure
................................................ 9433184
Indicator
and Warning
Brake
............................................................ 9433184
4WD
............................................................. 9433184
Headlight HighBeam
............................................... 9433184
Safety Belt
........................................................ 9433184
TurnSignal
....................................................... 9433184
Instrument Cluster
.................................................... 9605 156
License Plate
............................................................ 194
Lighter
............................................................. 9433184
Rear Defogger Switch
............................................. 96061736
Rear Wiper/Washer Switch
........................................... 9606 1736
Rear
Hazard and Turn Signal
........................................... 1156
Rear Parking andstop
................................................... 1157
Sidemarker
................................................. ........ 194
9 - 276
ProCarManuals.com

Service & Appearance Care
Capacities (Approximate)
The following approximate capacities are given in U.S. and metric conversions.
Automatic Transmission Air
Conditioning?.
................ .See the refrigerant information label under hood.
.............................................
................................................... Drain and Refill .3.0 qt. (2.8 L)**
Overhaul .4.9 qt. (4.6 L)
Cooling System
Automatic Transmission. ...................................... S.5 qt. (5.2 L)
I Manual Transmission. ........................................ S.6 qt. (5.3 L)
FuelT ank....................................................llgal.(42.0L) .
Crankcase
..........................................
........................................
With Filter Change. .4.5 qt. (4.2 L)*
Without Filter Change .4.2 qt. (4.0 L)*
Front Differential ............................................... 1 1 qt. (1 .O L)
Manual Transmission. .1.6 qt. (1.5 L)**
Rear Differential. .2.3 qt. (2.2 L)
Transfer Case .................................................. 1 .8 qt. (1.7 L)
..........................................
..............................................
Wheel Nuts
Wheel Nut Torque .60 lb. ft. (80 N-m)
? Not all air conditioning refrigerants are the same. If the air conditioning system in
your vehicle needs refrigerant, be sure
the proper refrigerant is used. If you’re not
sure, ask your Geo dealer.
after filling.
See “Engine Oil” in the Index.
Transmission Fluid” in the Index.
.........................................
*.When changing the oil filter, additional oil may be needed. Recheck the oil level
** Recheck fluid level after filling. See “Automatic Transmission Fluid” or “Manual
9 278
ProCarManuals.com

Maintenance Schedule
Introduction: A Word about Maintenance
We at General Motors want to help you keep your vehicle in
good working condition. But we don’t know exactly how
you’ll drive it. You may drive very short distances only a
few times a week. Or you may drive long distances all the
time
in very hot, dusty weather. You may use your vehicle
in making deliveries. Or you may drive it to work, to do
errands,
or in many other ways.
Because of all the different ways people use their GM
vehicles, maintenance needs vary. You may even need more
frequent checks and replacements than you will find in the
schedules
in this part. So please read this part and note how
you drive. If you have any questions on how to keep your
vehicle
in good condition, see your Geo dealer, the place
many GM owners choose
to have their maintenance work
done. Your dealer can be relied
upon to use proper parts
and practices.
Your Vehicle and the Envitvnment
Proper vehicle maintenance not only helps keep your vehicle
in good working condition, but it also helps the
environment.
All recommended maintenance procedures are
important. Improper vehicle maintenance
or the removal of
important components can significantly affect the quality of
the air we breathe. Improper fluid levels or even the wrong
tire inflation can increase the level of emissions from your
vehicle.
To help protect our environment, and to help keep
your vehicle
in good condition, please maintain your vehicle
properly.
9 282
ProCarManuals.com

Maintenance Schedule
Section A: Scheduled Maintenance Services (Cont.)
Dplanatiun of Scheduled Maintenance Services
Below are explanations of the services listed in Schedules I
and 11.
290
ITEM
NO.
1
2
SERVICE
Engine Oil and Filter Change* - Always use SG
Energy Conserving I1 Oils of proper viscosity. The
SG designation may be shown alone or in
combination with others, such as SG/CC, SG/CD,
or SF, SG, CC, etc. To determine the preferred
viscosity for your vehicle’s engine (e.g., SAE
5W-30 or 1OW-30) see “Engine Oil’’ in the Index.
Engine Idle Speed Check* - Check the idle speed
and adjust it to underhood label specifications.
*An Emission Control Service.
The proper fluids and lubricants to use are listed in Section
D. Make sure whoever services your vehicle uses these. All
parts should be replaced and all necessary repairs done
before
you or anyone else drives the vehicle.
ITEM
NO. SERVICE
3 Cooling System Service* - Drain, flush and refill
the system with new or approved recycled coolant
conforming to
GM Specification 4038M. Keep
coolant at
the proper mixture as specified. See
“Coolant”
in the Index. This provides proper freeze
protection, corrosion inhibitor level, and engine
operating temperature.
Inspect hoses and replace
if they are cracked,
swollen, or deteriorated. Tighten screw-type hose
clamps. Clean the outside of the radiator and air
conditioning condenser. Wash
the pressure cap and
neck.
To help ensure proper operation, we recommend a
pressure test of both
the cooling system and the
pressure cap.
ProCarManuals.com

Maintenance Schedule
Section A: Scheduled Maintenance Services (Cont.)
ITEM
NO. SERVICE
7 Distributor Cap and Spark Plug Wire
Inspection*
- Inspect for burns, cracks or other
damage. Check the boot
fit at the distributor and at
the spark plugs. Replace wires as needed. Operation
in extreme cold and/or on salted roads may require
more frequent replacement.
Replacement* - Inspect valve for proper function.
Replace the valve every
50,000 miles (83 OOO km)
as well as any worn, plugged or collapsed hoses.
8 Positive Crankcase Ventilation (PCV) Valve
ITEM
NO. SERVICE
9 Exhaust Gas Recirculation (EGR) System
Inspection*
- Inspect at 50,000 mile (83 OOO km)
intervals.
Replacement* - Inspect at each oil change.
Replace
every 30,000 miles (50 000 km) or more
often under dusty conditions.
Ask your dealer for
the proper replacement intervals for your driving
conditions.
If your vehicle is equipped with a
crankcase ventilation filter, replace
it too.
10 Air Cleaner Filter (PCV Filter, if Equipped)
1 *An Emission Control Service.
ProCarManuals.com

Maintenance Schedule
Section C: Periodic Maintenance Inspections
Listed below are inspections and services which should be
performed at least twice a year (for instance, each spring or
fall). You should let your
GM dealer’s service department or
other qualified service center do these
jobs. Make sure
any necessary repairs are completed at once.
CHECK
I OR SERVICE WHAT TO DO
Steering, Suspension,
and Front-Wheel-Drive
Axle Boot and Seal
Inspection
Exhaust System
Inspection
Throttle Linkage
Inspection
Rear Axle (All) and
Front Axle
(Four-wheel Drive)
Service ~ Inspect front and rear suspension and steering system for damaged, loose or missing parts, signs
of wear or lack of lubrication. On vehicles equipped with power steering, inspect power steering,
lines and hoses for proper hookup, binding, leaks, cracks, chafing, etc. On vehicles equipped
with manual steering, check
for seal leakage. Clean and then inspect drive axle boot seals for
damage, tears or leakage. Replace seals
if necessary.
Inspect the complete exhaust system. Inspect the body near the exhaust system. Look for broken,
damaged, missing,
or out-of-position parts as well as open seams, holes, loose connections, or
other conditions which could cause a heat build-up in the floor pan or could let exhaust fumes
into the vehicle. See “Engine Exhaust’’
in the Index.
Inspect the throttle linkage for interference or binding, and for damaged or missing parts.
Replace parts as needed. Check accelerator pedal for smooth operation and even pedal effort.
Check the gear lubricant level and add if needed. See “Rear Axle’’ and ‘‘Four-wheel Drive’’
in
the Index. A fluid loss may indicate a problem. Check the system(s), and repair the system(s) if
needed. Refer to “Scheduled Maintenance Services,” earlier in this part, to determine when to
change
the lubricant.
ProCarManuals.com