1993 CHEVROLET S10 fuel

Downloaded from www.Manualslib.com manuals search engine How To Use This Manual
These symbols are used on warning and indicator lights.
Engine Coolant Temperature
BRAKE
Brake
(Digital Cluster)
1
I Battery Charging
System
BRAKE
Fuel Engine Oil
Pressure
SHIFT
Brake
(Standard Cluster) Shift Light
Here are some other symbols you may see.
Fuse Lighter Horn Speaker
0-6
PO343

Downloaded from www.Manualslib.com manuals search engine Engine Block Heater
KO41 4
In very cold weather, 0°F (-18°C) or colder, the optional engine block heater
can help. You’ll get easier starting and better fuel economy\
during engine
warm-up.
To use the brock heater:
1. Turn
off the engine.
2. Open the hood and unwrap the electrical cord.
3. Plug it into a normal, grounded 1 IO-volt outlet.
A
Plugging the cord into an ungrounded outlet could cause an electrical
shock.
Also, the wrong kind of extension cord could overheat and
cause a fire. You could be seriously injured. Plug the cord into a
properly grounded three-prong 110-volt outlet.
If the cord won’t reach,
use a heavy-duty three-prong extension cord rated for at least \
15
amps.
2-1
5

Downloaded from www.Manualslib.com manuals search engine Features & Controls
I
e
OD (Automatic Overdrive). This position is for normal driving. If you need
more power for passing, and you’re:
- Going less than about 35 mph (56 km/h), push your accelerator
pedal about halfway down.
- Going about 35 mph (56 km/h) or more, push the accelerator all the
way down. You’ll shift down to the next gear and have more power.
OD should not be used when towing a trailer, carrying a heavy load,
driving on steep hills, or for off-road driving. Select
D (third gear) when
operating the vehicle under any of these conditions.
D (Third Gear). This is like OD, but you never go into Overdrive. You
should use
D when towing a trailer, carrying a heavy load, driving on
steeps hills, or for off-road driving.
2 (Second Gear). This position gives you more power but lower \
fuel
economy. You can use
2 (Second Gear) on hills. It can help control your
speed as you go down steep mountain roads, but then you would\

also
want to use your brakes off and on.
If you have a 4.3L engine (Codes Z and W) and if you manually select
2, the transmission will drive in second gear. You may use this feature
for reducing torque
to the rear wheels when you are trying to start your
vehicle from a stop on slippery road surfaces.
1 (First Gear). This position gives you even more power (but \
lower fuel
economy) than
2. You can use it on very steep hills, or in deep snow or
mud. If the selector lever is put in 1, the transmission won’t shift into
first gear until the vehicle is going slowly enough.
2-1 8

Downloaded from www.Manualslib.com manuals search engine Featurns & Controls
I
If you have a manual transmission, you have a SHIFT light. This light will
show you when
to shift to the next higher gear for best fuel economy.
When this light comes on,
you can "shift to the n-ext higher gear if weather,
road and traffic conditions let you. For the best fuel economy, accelerate
slowly and shift when the light comes on.
While you .accelerate, it
is normal for the light to go on and off if you quickly
change the position
of the accelerator. Ignore the SHIFT light when you
downshift.
For Four-wheel Drive Vehicles
Only: If your vehicle has four-wheel drive
and is equipped with a manual transmission, disregard the shift\
light when the
transfer case is in
4 LOW.
Shift Speeds-Manual Transmissions
If your speed drops below 20 mph (32 km/h), or if the engine is not running
smoothly, you should downshift
to the next lower gear. You may have to
downshift two or more gears to keep the engine running smoothly or for good
performance.
2-20

Downloaded from www.Manualslib.com manuals search engine 4 LOW: This setting also engages your front axle to give you extra traction.
You may never need
4 LOW. It sends the maximum power to all four wheels.
You might choose
4 LOW if you were driving off-road in sand, mud, or deep
snow and climbing or descending steep hills.
You can shift from
2 WHEEL to 4 HIGH or from 4 HIGH to 2 WHEEL while
the vehicle is moving.
It is not necessary for you to press the transfer case
shift lever button. Your front axle will engage faster if you take your foot
off
of the accelerator for a few seconds after you shift.
To shift into or out of 4 LOW or N SET PARKING BRAKE:
-
1. Stop your vehicle and shift your transmission into neutral.
2. Press the transfer case shift button and shift in one continuous motion.
Don’t pause in
N SET PARKING BRAKE as you shift into or out of 4 LOW,
or your gears could clash.
Remember that driving in
4 HIGH or 4 LOW may reduce fuel economy. Also,
driving in four-wheel drive on dry pavement could cause your tires to wear
faster and make your transfer case harder to shift.
Electronic Transfer Case
1
KO41 2
The optional electronic shift transfer case switch is on the left side of your
instrument panel above the light switches. Use this switch to \
shift into and
out of four-wheel drive. You can choose among three driving settings:
1. Two-wheel drive, “TWO WHEEL”: This setting is for driving in most
street and highway situations. Your front axle
is not engaged in
two-wheel drive.
2-29

Downloaded from www.Manualslib.com manuals search engine Features & Confmls
instrument Cluster
Your instrument cluster is designed to let you know at a glance how your
vehicle is running. You'll know how fast you're going, about how much fuel
you've used, and many other things you'll need to know to drive safely and
economically.
Digital Cluster
If you have the digital cluster it looks different but will tell you everything the
standard cluster does. The digital cluster
also includes a tachometer and will
give readings
in either English or Metric. To switch from English to Metric,
just press down
on the EIM lever.
Speedometer and Odometer
I
KO265
Your speedometer lets you see your speed in both miles per hour (mph) and
kilometers per hour (km/h). Your odometer shows how far your vehicle has
been driven, in either miles
(used in the U.S.) or kilometers (used in
Canada).
2-62
1

Downloaded from www.Manualslib.com manuals search engine KO271
~ NOTICE
If you have the 4.3L High Performance engine (VIN Code W), you will have
a fuel regulator that shuts the fuel
off when the engine reaches 5600 rpm.
Warning Lights, Gages and Indicators
This section describes the warning lights and gages that are o\
n your vehicle.
The pictures will help you locate them.
Warning lights and gages can s.ignal that something is wrong before it
becomes serious enough to cause an expensive repair or replacem\
ent. Paying
attention to your warning lights and gages could
also save you or others from
injury.
Warning lights
go on when there may be or is a problem with one of your
vehicle’s funcfions.
As you will see in the details on the next few pages,
some warning lights come on briefly when you turn the ignition\
key just to let
you know they’re working.
If you are fam’iliar with this section, you should not
be alarmed when this happens.
2-65

Downloaded from www.Manualslib.com manuals search engine Features & Controls
Malfunction Indicator Lamp (Service Engine Soon)
Standard Cluster Digital Cluster
I
PO1 61
A computer monitors operation of your fuel, ignition and emission control
systems. This light should come on when the ignition is on, but the engine is
not running, as a check to show you it is working. If it does not come on at
all, have it fixed right away.
If it stays on, or comes on while you are driving,
the computer is indicating that you have
a problem. You should take your
vehicle in for service
soon.
2-68
II