1993 CHEVROLET CAMARO high beam

I
Vehicle Symbok
These are some of the symbols you will
find on your vehicle. For example, these
symbols are used on an original battery: These symbols are important for you
and your passengers whenever your
vehicle
is driven:
Caution Possible Injury
Protect Eyes by Shielding
Caustic Battery Acid
Could Cause Burns
Avoid Sparks or Flames
Sparks or Flame Could
Explode Battery Fasten Safety Belts
Door LocWUnlock
These symbols have to do with your
lights:
Master Lighting Switch
Turn Signal Direction Hazard
Warning Flasher
Headlight High Beam
Parking Lights
Courtesy Lights
Fog Lights
pf
%O
9.. .
ProCarManuals.com

9
The Turn
SignaUHeadlight
Beam
Lever
The lever on the left side of the steering
column includes your:
0 Turn Signal and Lane Change
0 Headlight Highbow Beam and
Passing Signal
0 Windshield Wipers
0 Windshield Washer
0 Cruise Control (Option)
Indicator
c; C. , .“ ,
i
I:
rum Signal and Lane Change
ndicator
’he turn signal has two upward
(for
tight) and two downward (for Left)
lositions. These positions allow you
to
ignal a turn or a lane change.
b signal a turn. move the lever all the
vay up or down. When the turn is
inished, the lever will return
.utomatically.
A green arrow on the instrument panel
will flash in the direction of the turn or
lane change.
To signal a lane change, just raise or
lower the lever
until the green arrow start:
to flash. Hold it there until you complete
your lane change. The lever
will return by
itself when you release
it.
As you signal a turn or a lane change, if
the arrows don’t flash but just stay on, a
signal bulb may be burned out and other
drivers won’t see your
turn signal.
If a bulb is burned out, replace it to help
avoid an accident.
If the green arrows
don’t go on at
all when you signal a turn,
check the fuse (see “Fuses” in the Index)
and for burned-out bulbs.
ProCarManuals.com

Features & Controls
Headlight HighLow Beam
To change the headlights from low beam
to high or high
to low, pull the turn signal
lever all
the way toward you. Then
release
it. When the high beams are on,
this blue light on the instrument panel
also will
be on.
. e*. 5 r
Windsmpers
You control the windshield wipers by
turning the band with the wiper symbol
on it.
For a single wiping cycle, turn the band
to
MIST. Hold it there until the wipers start,
then let go. The wipers
will stop after one
cycle.
If you want more cycles, hold the
band on
MIST longer.
You can set the wiper speed for a long or
short delay between wipes. This can be
very useful
in light rain or snow. Turn the
band to choose the delay time. The closer
to LO, the shorter the delay. For
steady wiping at
low speed, turn the
band away from you
to the LO position.
For high speed wiping, turn the band
further,
to HI. To stop the wipers, move
the band
to OFF.
99978
ProCarManuals.com

Features & Controls
I
I
I'o Get Out of Cruise Control
There are several ways to turn off the
Cruise Control:.
1. Step lightly on the brake pedal or push
the clutch pedal,
if you have a manual
transmission:
OR
2. Move the Cruise switch to OFF.
To Erase Speed Memory
When you turn off the Cruise Control or
the ignition, your Cruise Control set speed
memory
is erased.
Operation of Lights
Although your vehicle's lighting system
(headlights, parking lights,
fog lamps,
side marker lights and taillights) meet all
applicable federal lighting requirements,
certain states and provinces may apply
their own lighting regulations that may
require special attention before you
operate these lights. For example, some
jurisdictions may require that
you operate
your lower beam lights with fog lamps at
all times, or that headlights be turned on
whenever you must use your windshield
wipers.
In addition, most jurisdictions
prohibit driving solely with parking
lights, especially at dawn or dusk. It is
recommended that you check with your
own state or provincial highway authority
for applicable lighting regulations.
ProCarManuals.com

Features & Controls
At dusk, the exterior lights will come on
automatically and the front turn signal
lights will go out.
At dawn, the exterior
lights will
go out and the front turn signal
lights will come on (if the headlight
switch is
off).
Of course, you may still turn on the
headlights any time you need to.
To idle your vehicle with the
DRL off, set
the parking brake while the ignition is
in
the Off or LOCK position. Then start the
vehicle. The
DRL will stay off until you
release the parking brake.
I
Fog Lights (Option)
Use your fog lights for better vision in
foggy or misty conditions. Your parking
lights must be on or your fog lights won't
work.
To turn the fog lights on, push the switch
abovego. Push the bottom of the
switch to
turn the fog lights off. A light
on the switch will come on when the fog
lights are on.
Fog lights will go off whenever your high
beams come on. When the high beams
go
off, the fog lights will come on again.
Interior Lights
Courtesy Lights
When any door is opened, several interior
lights
go on. These lights are courtesy
lights. They make
it easier for you to
mter and leave your vehicle.
Courtesy lights include the dome light
md other lights throughout the interior of
your vehicle.
ProCarManuals.com

Your Driving and the Road
But if you’re driving, don’t wear
sunglasses at night. They may cut down
on glare from headlights, but they also
make a lot
of things invisible that should
remain visible
- such as parked cars,
obstacles, pedestrians,
or even trains
blocking railway crossings. You may
want to put
on your sunglasses after you
have pulled into a brightly-lighted service
or refreshment area. Eyes shielded from
that glare may adjust more quickly to
darkness back on the road. But be sure to
remove your sunglasses before you leave
the service
area.-^-
You can be temporarily blinded by
approaching lights.
It can take a second or
two, or even several seconds, for your
eyes to readjust to the dark. When you are
faced with severe glare (as from a driver
who doesn’t lower the high beams, or a
vehicle
with misaimed headlights), slow
down a
little. Avoid staring directly into
the approaching lights. If there is a line of
opposing traffic, make occasional glances
over the line
of headlights to make certain
that one
of the vehicles isn’t starting to
move into
your lane. Once you are past
the bright lights, give your eyes time to
readjust before resuming speed.
High Beams
[f the vehicle approaching you has its
high beams on, signal
by flicking yours to
high and then back to low beam. This is
:he usual signal to lower the headlight
beams. If the other driver
still doesn’t
lower the beams, resist the temptation
to
put your high beams on. This only makes
two half-blinded drivers.
On a freeway, use your high beams only
in remote areas where you won’t impair
approaching drivers. In some places, like
Zities, using high beams is illegal.
ProCarManuals.com

When you follow another vehicle on a
freeway or highway, use low beams. True,
most vehicles now have day/night mirrors
that enable the driver to reduce glare. But
outside mirrors are not of this type and
high beams from behind can bother the
driver ahead.
A Few More Night Driving Suggestions
Keep your windshield and all the glass on
your vehicle clean
- inside and out.
Glare at night is made much worse by dirt
on the glass. Even the inside of the glass
can build
up a film caused by dust.
Tobacco smoke also makes inside glass
surfaces very filmy and can be a vision
hazard
if it’s left there. Dirty
glass makes lights dazzle and flash
more than clean glass would, making the
pupils of your eyes contract repeatedly.
You might even want to keep a cloth and
some glass cleaner
in your vehicle if you
need to clean your glass frequently.
Remember that your headlights light
up
far less of a roadway when you are in a
turn or curve.
Keep your eyes moving; that
way, it’s
easier to pick
out dimly lighted objects.
Just as your headlights should be checked
regularly for proper aim,
so should your
eyes be examined regularly. Some drivers
suffer from
night blindness - the
inability to see
in dim light - and aren’t
even aware of
it.
Driving in the Rain
Rain and wet roads can mean driving
trouble. On a wet road you can’t stop,
accelerate or
turn as well because your
tire-to-road traction isn’t as good as on
dry roads. And,
if your tires don’t have
much tread left,
you’ll get even less
traction.
It’s always wise to go slower and be
cautious
if rain starts to fall while you are
driving. The surface may get wet
suddenly when your reflexes are tuned for
driving on
dry pavement.
ProCarManuals.com

sometimes they can be waiting for you as
you come over a hill or dip into a shallow
valley. Start your windshield wipers and
washer, to help clear accumulated road
dirt. Slow down carefully.
Tips on Driving in Fog
If you get caught in fog, turn your
headlights on low beam, even
in daytime.
You’ll see
- and be seen - better. Use
your fog lights
if your vehicle has them.
Don’t use your high beams. The light will
bounce off the water droplets that make
up fog and reflect back at you. Use
your defogger. In high humidity, even
a light buildup of moisture on the inside
of the glass will cut down on your already
limited visibility. Run your windshield
wipers and washer occasionally. Moisture
can build up on the outside glass, and
what seems to be fog may actually be
moisture on the outside of your
windshield.
Treat dense fog as an emergency. Try to
find a place to pull off the road. Of course
you want to respect another’s property,
but you might need to put something
between you and moving vehicles
-
space, trees, telephone poles, a private
driveway, anything that removes you
from other traffic.
[f visibility is near zero and you must stop
but are unsure whether you are away from
the road,
turn your lights on, start your
hazard warning flashers, and sound your
horn at intervals or when you hear
approaching traffic.
Pass other vehicles in fog only if you can
see far enough ahead to pass safely. Even
then, be prepared to delay your pass if
you suspect the fog is worse up ahead. If
other vehicles try to pass you, make
it
easy for them.
ProCarManuals.com