Page 88 of 406

Downloaded from www.Manualslib.com manuals search engine - .- The other positions let you perform these functions:
ACC: Accessory lets you use things like the radio and the windshield
wipers when the engine is
off. To get into “Acc”, push in the key and turn
before you inserted the
key.
- it toward you. Your steering wheel will remain locked, just as it was
OFIF: This position lets you turn off the engine but still turn the steering
wheel. It doesn’t lock the steering wheel like
“Lock.” Use “Off” if you
must have your car in motion while the engine is off (for example, if your
car is being pushed).
RUN: This is the position for driving.
STARE This starts your engine.
If your Key seems stucK in “Lock, and you can’t turn it, be sure - - ..
-~
ignition switch. If none of this works, then your vehicle need
STARTING YOUR ENGINE
Move your shift lever to “P” (Park) or “N” (Neutral). Your engine won’t
start
in any other position -- that’s a safety feature. To restart when you’re
already moving, use
“N’ (Neutral) only.
1
NOTICE:
Don’t try to shift to “P” (Park, if your Cadillac is moving. If you
do, you could damage the transaxle. Shift to
when your vehicle is stopped.
Page 89 of 406

Downloaded from www.Manualslib.com manuals search engine To start vour V8 engine:
1. Don’t push the accelerator pedal before starting your engine. In some
other vehicles you might need to do this, but because
of your vehicle’s
computer systems, you don’t.
c
2. Turn your ignition key to “Start.” When the engine starts, let go of the
key. The idle speed
will go down as your engine gets warm.
3. If it doesn’t start right away, hold your key in “Start” for about three
seconds at a time until your engine starts. Wait about
15 seconds
between each try to help avoid draining your battery.
-
-
will cause your battery to be drained much so0
ive heat can damage your starter motor.
-
4. If your engine still won’t start (or starts but then stops), it could be
flooded with too much gasoline. Try pushing your accelerator pedal all
the way to the floor and holding it there
as you hold the key in “Start’’
for about three seconds.
If the vehicle starts briefly but then stops
again, do
the same thing.
Jour ~II~III~: IS ueslgrleu LU work wi
ding electrical equipment, check with your d
n’t, your engine might not
perform properly.
nual that tells how
to do it without damagi
“Towing Your Vehicle” in the Index.
76
r
Page 108 of 406

Downloaded from www.Manualslib.com manuals search engine p WINDSHIELD WPERS
You control the windshield wipers by turning the band marked “WIPER.”
For a single wiping cycle, turn the band to “MIST? Hold it there until the
wipers start, then let go. The wipers will stop after one cycle.
If you want
more cycles, hold the band on “MIST” longer. H
I
You can set the wiper speed for a long or short delay between wipes. This
can be very useful in light rain or snow. Turn the band to choose the delay
time. The closer to
“LO,” the shorter the delay.
For steady wiping at low speed, turn the band away from you to the “LO”
the wipers, move the band to “OFF.”
7
7 position. For high speed wiping, turn the band further, to “HI.” To stop
rr
A CAUTION:
Damaged wiper blades may prevent you from seeing well enough
to drive safely.
To avoid damage, be sure to clear ice and snow
from the wiper blades before using them.
If they’re frozen to the
windshield, carefully loosen or thaw them.
If your blades do
become damaged, get new blades or blade inserts.
r
95
Page 126 of 406
Downloaded from www.Manualslib.com manuals search engine Electrochromic Outside Rearview Mirror (Option)
(Not available on Touring Sedan)
This mirror automatically dims to minimize glare for maximum rear
visibility.
As glare increases, the mirror darkens accordingly. When the
glare subsides, the mirror returns to its clear daytime state.
The mirror
is controlled by the same three position sensitivity switch that
controls the Electrochromic Inside Rearview mirror.
CONVENIENCE NET (OPTION)
a:’
Your vehicle may have a convenience net. You’ll see it just inside the back
wall of the trunk.
Put small loads, like grocery bags, behind the net. It can help keep them
from falling over during sharp turns or quick starts and stops.
The net isn’t
for larger, heavier loads. Store them in the trunk as far
forward as you can.
You can unhook the net
so that it will lie flat when you’re not using it.
113
Page 134 of 406

Downloaded from www.Manualslib.com manuals search engine When one of the warning lights comes on and stays on when you are
driving, check the section that tells you what to do about it. Pkase
follow
the manual’s advice. Waiting to do repairs can be costly -- and even
dangerous.
So please get to know your warning lights. They’re a big help.
Brake System Warning Light
Your Cadillac’s hydraulic brake system is divided into two parts. If one
part isn’t working, the other part can still work and stop you. For good
braking, though,
you need both parts working well.
If the warning light goes on, there could be a brake problem. Have your
brake system inspected right away.
This light shoula
come
on and turn off as you
start the vehicle. If it
doesn’t come on then,
have it fixed
so it will
be ready to warn you
if
there’s a problem.
This light will also come on when you set your parking brake, and will
- stay on if your parking brake doesn’t release fully. If it stays on after your
parking brake is fully released, it means you have a brake problem. If the
light comes on while driving, pull
off the road and stop carefully. You may
-_ notice that the pedal is harder to push. Or, the pedal may go closer to the
floor. It may take longer to stop.
If the light is still on, have the vehicle
towed for service.
(See “Towing Your Vehicle” in the Index.)
121
Page 135 of 406

Downloaded from www.Manualslib.com manuals search engine A CAUTION:
I
Your brake system may not be working properly if the brake
warning light is on. Driving with the brake warning light
on can I
lead to an accident. If the light is still on after you’ve pulled off
the road and stopped carefully, have the vehicle towed for
service. 1’
Anti-Lock Brake System Warning Light
With anti-lock, this light will go on when you start your engine and may
stay on for several seconds or
so. That’s normal. If the light doesn’t come
on, have it fixed so it will be ready to warn you if there is a problem.
If the light stays on or comes on when you’re driving, stop as soon
as
possible and turn the key off. Then start the engine to reset the system. If
the light still stays on, or comes on again while you’re driving, your
Cadillac needs service. Unless the regular brake system warning light is
also
on, you will still have brakes, but not anti-lock brakes. If the regular
brake system warning light is also on, see “Brake System Warning Light”
earlier in this part.
The anti-lock brake system warning light may also come on when you are
driving with a compact spare tire. If this happens, the light means you
won’t have anti-lock until you replace the compact spare with
a full-size
I-
I-
.-.
‘.I
r
r
122
Page 138 of 406

Downloaded from www.Manualslib.com manuals search engine - Engine Coolant Temperature Warning Light
r
This light tells you that
your engine coolant has overheated or your
radiator cooling fans
are not working. If you
have been operating
your vehicle under
normal driving
conditions, you should
pull
off the road, stop
your vehicle and turn
-1 the engine off as soon
as possible.
HOT COOLANT CAN BURN YOU BADLY!
In “Problems on the Road,” this manual shows what to do. See “Engine
Overheating” in the Index.
Engine Temperature Warning Light
I This light tells you that
your engine has overheated.
If you have been operating your vehicle under normal driving conditions,
you should pull
off the road, stop the car and turn the engine off as soon
as possible.
A warning chime should also sound if you drive with this light
on. The chime will continue to sound until the ignition is turned
“off” or
the light goes out.
As a check, the light should come on for a few seconds
when you start your engine.
125
Page 161 of 406

Downloaded from www.Manualslib.com manuals search engine 0 Push the SET button.
0 Push any two of the push buttons that are next to each other.
0 Repeat these steps for each station you select. Whenever you push
those buttons together, you’ll get the station you selected.
Your Cassette Tape Player
Your tape player is built to work best with tapes that are 30 to 45 minutes
long
on each side. Tapes longer than that use such thin tape that they may
not work well in this player.
Tu Play A Cassette Tape
Have the radio on.
A
Insert the tape squarely through the tape door.
The longer side with the tape visible goes in first.
If you hear nothing or
hear just
a garbled sound, it may not be in squarely. Push EJECT to
remove the tape and start over.
Once the tape is playing, use the upper and lower knobs for volume
and balance, just as you do for radio. The arrows show which side
of
the tape is playing.
7
To go forward to another part of the tape push FWD. To go Wackward,
push
REV. To stop the tape, push the other button lightly.
To go from one side of the tape to the other, push in the upper knob
on your radio. To remove or stop the tape, push EJECT
148