1992 MAZDA 323 battery

Troubleshooting GI
Measuring continuity/resistance
Touch the ohmmeter probes to the switch terminals to check
Verify the operating state of the switch before checking
continuity because readings vary accordingly.
Note Continuity is checked according to the direction of the positive
(+) and negative (-) probes ofihe ohmmeter in the circuit
containing the diode.
Connection
I Continuity
Yes
The negative (- ) probe of the ohmmeter is
connected to the positive terminal of the internal
ohmmeter battery, the positive (+) probe to the
negative terminal of the battery. No
Connect the ohmmeter probes to the sensor or solenoid valve
terminals to check resistance.
Caution
Verify the operating state of the sensor before checking
resistance because readings vary accordingly.
1. Short between the terminals with a jumper wire to discharQe
the capacitor.
2. Set the ohmmeter range to xl Ok R and connect it to the
capacitor terminals.
3. The capacitor is good if the needle of the ohmmeter swings
once and returns to its original position.
15

GI Troubleshooting
FindIng short circuits
Shorts occur between the power (positive) and ground (negative) sides of a circuit.
Therefore, finding a short circuit requires determining how the circuit is routed.
Circuits
not connected to control unit
I
Examples
ihort location 1 SvmWom
I Battery
,pOSlhl
terminal) lgnitbn switch
I Finding short circuit
4
1. Remove the fuse and
main fuse of the circuit.
2. Disconnect ail connecton
Of electrical components in the circuit.
3. Attach a voltmeter or test
Motor
M
Qi!
Short (A)
Short (8)
Short (C)
Short (0) l The motor operates
regardless of whether the
thermoswitch is ON or OFF
when the ignition switch is ..-..
ON. -
@The fuse is not melted.
0 The main fuse melts when the
ignition switch and thermo-
switch are ON and the relay is
operating.
lgnitlon switch
Switch short locatior
Short (A)
Short (B)
Short (C) Test lamp lamp to the fuse box and
reconnect each connector, beginning
nearest the power
, source. Circuits connected to control unit
1 Examples
Symptom
l Fuse melts.
Short (D)
Short (E) 14. Check the voltmeter
reading or test lamp as
the connectors are
connected.
l solenoid A operates when the
ignition switch is ON.
l The CPU transistor burns out
when the ignition switch is
turned ON.
l The CPU thinks the switch is
ON because the same
conditions exist as when the
switch is ON.
@The CPU senses the sensor
to be 0 Q because the same
conditions exist as when the
resistance value is 0 Q.
l The CPU equipped with the
self-diagnosis function outputs
the code. l-
Finding short circuit
1. Remove the fuse and main
fuse of the circuit.
2. Disconnect ail connectors oi
electrical components in the
circuit.
rest lamp 3. Attach a voltmeter or test
lamp to the fuse box and
reconnect each connector,
beginning nearest to the
power source.
Check the voltmeter reading
or test lamp as the
connectors are connected.
Sensor/switch
1. Attach the test lamp or
voltmeter to the CPU
connector.
2. Connect to the switch/
sensor connector.
3. Check the voltmeter reading
voltmeter reads OV or the test lamp
16

d-II __ EXCEPT F.R.GERMANY -CURRENT FROM BATTERY
-----CURRENT FROM IGl. IG2
-I 1--~-l-l-a-r-~ A, ,.,TiTl-TLITr r-.-a ar.1. ?I,-% ----CIJARENT FROM ACC
“-‘e 30A
I -mILLUMINATION LAMPS I-4
HiZP
r--- “f E-l
MAIN 00A FUSE l5A
q
-GA- I’LIE iHTS
---mm_
n POSITION LIGHTS E-l
TAIL 15A
-W/B
I
+-.
i-. I
i REAR WIPER
15A
-0J‘o ---- L/G _--- ;-.-&+v ---.
WIPER 20A .---$- ---. l REAR WIPER E WASHER o-2
m--c____ L _____ ;--:-; ____. l ;:E;H;E:;SHm
O-l
HEATER 30A
-- _-__ ,,,-j __-__; --me., HEATER
G
t
METER 15A : - - l COURTESY LAMPS I-3
-------B/y ---- + I
ZiUNROOF 15A : --•INTERIOR 6 SPOT LAMPS I-2
t
-oJy)--
G/O---:--- -t----.mSLIOING SUNROOF M
~~~~ .--- __ ___ n SOUN0 WARNING SYSTEM I-2
48s VALV
30A I
i
AES 60A +--t-
I mSTOF’LIGHTS F-3
ABS iOA
--- ’ ‘I ---
GNITION ! ;
iWITCH 1 I
TRUNK COMPARTMENT
‘LAMP I-3
‘mPOWER DOOR LOCK A
K-2
FUSE 30A
y-------t- --~--G/!---j--& .--- - l HEADLIGHT CLEANER O-l
I
’ . ---B/R---+-* ----
K-l
I PowE~~om!,IJ,+~~ -..---- -...;PO,.,ER WI,.,,,OWS
! I ENGINE 15A
’ I (’ I :
:.
.--
1 ----L ---- l -* ---- OJY) ---- FJ,w----l-q -..--
FUEL INJ ’ .-------------------:-L.---
’ I UENGINE CONTROL SYSTEM B-l
FUSE 20A
l REAR WINOOW DEFROSTER I-l
-- mCIGARETTE LIGHTER I-l
mAUOI0 SYSTEM J
aSTARTING SYSTEM A-l

,c -
-
3
F.R.GERMANY F.R.GERMANY -CURRENT FROM BATTERY -CURRENT FROM BATTERY
-----CURRENT FROM IGl. 1G2 -----CURRENT FROM IGl. 1G2
l
ELECTRICAL WIRING SCHEMATIC =&$&jT FRoM ACC l ELECTRICAL WIRING SCHEMATIC =&$&jT FRoM ACC w-2 w-2
I I l ILLUMINATION LAMPS l ILLUMINATION LAMPS
MAIN BOA MAIN BOA , ,
485 VALVI
30A
HAZARO
30A ET’&” REAA FOG
i il E-5
t ‘=POSITION LIGHTS E-4
0
n LICENSE PLATE LIGHTS E-4
i ’ l TAILLIGHTS E-4
!rJJ:GHT LEVELING
.
i il E-2 REAR WIPER
15A a....*.
--- ~--
4
~FIEAR WIPER 6 WASHER i il o-2 I ----- - ---_ L/G _--...----A-___ 7
I WIPER 20A
,---.... - ----_ L ----
I
HEATER 30A
+-----w-.-L/W-+ -----; --__. l ,,,ZATER
G
I I
I
I METER 15A
I - l COURTESY LAMPS I-3
,--+ ---- (xro ---- FJ,y ----, I
I : I -mINTERIOR 6 SPOT LAMPS
I I SUNROOF 15A I I-2
b----------G/o ---- [ ---..- ~----,mSLIOING
I I SUNROOF
I
i i
I I SEAT WARMER
I
I I +g&)
ETN 30A t : ROOM 1OA
; ; i I ,
I : &---------,WBUCK-UP LIGHTS F-4
I
HORN iOA
STOP :
l- : !
.^. t , B/R l HORNS F-4
I , ABS iOA
- ~-
ABS 60A
9--t-“---
1 t
I :
t
I 1
FLASHER LIGHTS STOPLIGHTS
CHARGING SYSTEM
TRUNK COMPARTMENT
POWER DOOR LOCK K-2
INSTRUMENT CLUSTER
6 WARNING LAMPS C
?:m-“_“_“.B/W ---- +.+,v.-{~POWE~ ,.,INOOWS
K-l
l i .-m-e_ cx/v _____ G _-__ +.:m.
I , i il I-l
L_-----_-, l COOLING FAN SYSTEM B-2
B/L---------------------
R l STARTING SYSTEM A-l
21