1991 LEXUS SC300 differential

SSM (SPECIAL SERVICE MATERIALS)
SA095±04\
 
\


\


\

\

08826±00110 Seal packing 1389,
THREE BOND 1389 or equivalent 






Differential Carrier x Cover
\
 
\


\

\

08833±00100 THREE BOND 1360K or equivalentDifferential Case x Ring Gear
LUBRICANT
SA096±02
 Item Capacity Classification
 








Differential oil
 








1.35 liters (1.43 US qts, 1.19 lmp. qts)
 








API GL±5 Hypoid Gear Oil
[Above±18

C (0
F)]
SAE 90
[Below±18
C (0
F)]
SAE 80W or 80W±90
SA±78±
SUSPENSION AND AXLE REAR DIFFERENTIAL
WhereEverybodyKnowsYourName

ON±VEHICLE REPAIR
COMPONENTS
SA097±02
SIDE GEAR SHAFT OIL SEAL
REPLACEMENT
SA0V1±04
1. DRAIN DIFFERENTIAL OIL
2. REMOVE REAR DRIVE SHAFT(See page SA±65)
3. REMOVE SIDE GEAR SHAFT
(a) Using SST and 2 bolts, remove the side gear shaft. SST 09520±22010
(b) Remove the snap ring from the side gear shaft.
4. REMOVE SIDE GEAR SHAFT OIL SEAL Using SST, remove the oil seal.
SST 09308±00010
±
SUSPENSION AND AXLE REAR DIFFERENTIALSA±79
WhereEverybodyKnowsYourName

5. INSTALL SIDE GEAR SHAFT OIL SEAL
(a) Using SST and a hammer, drive in a new oil seal.SST 09608±32010, 09608±35014 (09608±06020)
(b) Apply MP grease to the oil seal lip.
6. INSTALL SIDE GEAR SHAFT
(a) Install a new snap ring to the side gear shaft.
(b) Using a hammer and brass bar, tap in the side gear shaft to
the differential.
NOTICE: Be careful not damage the side gear shaft and oil
seal.
7. CHECK INSTALLATION OF SIDE GEAR SHAFT
(a) Check that there is 2±3 mm (0.08±0.12 in.) of play in axialdirection.
(b) Check that the side gear shaft will not come out by trying to pull it out by hand.
8. INSTALL REAR DRIVE SHAFT
(See page SA±65)
9. CHECK DIFFERENTIAL OIL LEVEL Fill with hypoid gear oil if necessary.
Oil grade:
API GL±5 Hypoid Gear Oil
Viscosity: Above±18
C (0
F) SAE 90
Below±18
C (0
F) SAE 80W±90 or 80W
Capacity: 1.35 liters (1.43 US qts, 1.19 lmp. qts)
SA±80±
SUSPENSION AND AXLE REAR DIFFERENTIAL
WhereEverybodyKnowsYourName