1990 MITSUBISHI ECLIPSE mirror

ELECTRICAL - Fuses8-3q
rMULTI-PURPOSE FUSES
The multi-purpose fuses are located within the junction block at
the lower part of the instrument panel (at the driver’s seat side).
These fuses are all the blade type; 1 O-ampere, 15-ampere and
30-ampere fuses are used.
IPower supply circuitFuse No.
RatedLoad circuitapacity
(A)IBattery
t-lonition,itchBattery
IGz
ACC
IG,
10
10
10
15
15
10Automatic seatbelt control unit, buzzer, passing control relay,
key reminder switch, theft-alarm starter relay
Air conditioner control unit, air conditioner switch, heater relay,
power window relay, defogger timer, daytime running light relay
2 only>, transistor relay RadioCigarette lighter, remote controlled mirror
Door lock relay, door lock control unitAuto-cruise control unit
, AA control unit,
inhibitor switch, combination meter
ACC
IGI9
1011
12
1315
10
10
10Wiper motor, washer motor, intermittent wiper relay
Horn, headlight relay, theft-alarm control unit, daytime running
light relay
1 Auto-cruise control unit, auto-cruise control actuator,
automatic seatbelt control unit, theft-alarm control unit,
combination meter, warning light, seatbelt timer
Turn-signal and hazard flasher u.nit
14
15
16
17
10Theft-alarm horn relay
30Blower motor
15Stop light
Back up light
CM/T>, dome light relay
!Dome light. luggage compartment
Irght, foot. Irght.door-ajar warntng light, radio, MPI control unrt.AK control unit, ignition key illumination light.security lightI

BODY- Door Mirrors .23-27
DOOR MIRRORSIPIKhAC
.i~e large-size Talbot mirrors are attached on the
front doors that smoothly blend into the body
styling. They also contribute to the reduced aerody-
namic drag.
ELECTRIC REMOTE CONTROL MIRRORThe electric remote control mirror is a two-motor
type mirror for independent vertical and horizontalNote that the electric remote control mirror switch
angle
adjustment The mirror system consists of ais the centralized-control type and is installed on the
mirror assembly, actuator assembly, frame, body,door trim on the driver’s seat side. The one switch
etc.can be used to adjust the direction settings (to the
left and right, and up and down) of the left and right
_ mirrors.
/
/
l Pivo; screwFrameBody*Adjustment nutleAo398
‘Motor
B
NOTE
IThe &ark l denotes component parts of actuator assembly.
I

Mirror assemblywheel, and the pivot screw is thus turned; the threaded part of
Adjustment nut
\A
Connectingthe screw functions to move the adjustment nut, therebyplate (fylcrum
Iadjusting the mirror assembly in the left or right direction, with
the fulcrum at the center.
23-28---BODY - Door Mirrors
ADJUSTMENTS TO THE LEFT AND RIGHT
The rotational force of motor A is transferred to the worm
Adjustment nutand pivot screwI
meshing portionI ’‘Motor A or
B
Worm wheel
Pivot screwADJUSTMENTS UP AND DOWN
Motor
B operates to make the up and down adjustments,
functioning in the same way as the adjustments to the left and
right.In the event of a malfunction, the mirror can be adjusted by
pressing the mirror part to move the meshing of the adjust-
ment nut and the pivot screw (the tab at the adjustment nut
side) toward the outer side.
Even for “full stroke” operation, the adjustment nut condition
will be as described above, thus protecting the motors and
improving reliability.
c