6. Mix the recommended antifreeze with an equal amount of low-
mineral or distilled water and fill the reservoir to maximum, as
illustrated.
7. Loosen the air bleed bolt in the thermostat housing, then fill the radiator to the filler neck with the coolant mixture. Tighten thebleed bolt as soon as coolant starts to run out in a steady stream
without bubbles.
8. With the radiator cap off, start the engine and let it run until warmed up (fan goes on at least twice). Then, if necessary, addmore coolant mixture to bring the level back up to the filter neck.
9. Put the radiator cap on, then run the engine again and check for
leaks.
Fill to
here
Fill to here
FILLER
NECKProCarManuals.comMain Menu t s
