1988 JEEP CHEROKEE ignition

[x] Cancel search: ignition

Page 1261 of 1378

JEEP CHEROKEE 1988  Service Repair Manual                    Vacuum leak                  Repair vacuum leak
                   Improper float bowl fuel     Reset float
                   level                        adjustment, see FUEL

Page 1262 of 1378

JEEP CHEROKEE 1988  Service Repair Manual                                                 setting, see ENGINE
                                                PERFORMANCE
                   Vacuum leak                  Eliminate vacuum leak

Page 1286 of 1378

JEEP CHEROKEE 1988  Service Repair Manual ���������\
���������\
���������\
���������\
���������\
���������\
���������\
�������
Application

Page 1287 of 1378

JEEP CHEROKEE 1988  Service Repair Manual Fig. 1:  2.5L Firing Order & Distributor Rotation
         IGNITION TIMING
NOTE:    No adjustment is possible on models with Renix ignition.
         HOT (SLOW) IDLE RPM
NOTE:    Adjust ISC motor plun

Page 1289 of 1378

JEEP CHEROKEE 1988  Service Repair Manual Fig. 3:  TBI Idle Speed Control (ISC) Motor Adjustment
Courtesy of Chrysler Motors.
         4) Connect ISC motor connector. Turn ignition off for 10
seconds. ISC motor should fully extend. Restart en

Page 1290 of 1378

JEEP CHEROKEE 1988  Service Repair Manual connector. Connect negative voltmeter lead to terminal "D" and
positive voltmeter lead to terminal "A" to check input voltage. DO NOT
disconnect TPS connector.
         3) Hold throttle plate closed a

Page 1291 of 1378

JEEP CHEROKEE 1988  Service Repair Manual NOTE:    Idle mixture adjustment is not possible on TBI models.
         COLD (FAST) IDLE RPM
NOTE:    Fast idle is not adjustable on TBI models.
         SERVICING
          EMISSION CONTROL

Page 1296 of 1378

JEEP CHEROKEE 1988  Service Repair Manual inlet line or filter disconnected at carburetor. Disconnect fuel
return line at fuel filter and plug nipple on filter. Make all tests
at idle speed. See FUEL PUMP SPECIFICATIONS TABLE .
FUEL PUMP SPEC