1987 MAZDA 626 wheel bolts

FRONT SHOCK ABSORBER AND SPRING 1 3
FRONT SHOCK ABSORBER AND SPRING
REMOVAL AND INSTALLATION
1. Jack up the front of the vehicle and support it with safety stands.
2. Remove in the sequence shown in the figure, referring to the removal note for specially marked parts.
3. Install in the reverse order of removal, referring to the installation note for specially marked parts.
4. Tighten all nuts and bolts to the specified torque, referring to the figure.
.CD
46—63 N m (4.7—6.4 m-kg, 34—46 ft-lb)
8—11 Nm (80—110 cm-kg, 69—95 In-lb)
93-117 N-m . (9.5-11.9 m-kg, 69—86 ft-lb)
88—118 N-m (9—12 m-kg, 65—87 ft-lb)
11—25 N-m (1.1—2.6 m-kg, 8.0—19 ft-lb)
1. Lug nut
2. Wheel and tire
3. Clip
4. Harness and bracket bolt
(ABS)
5. Rubber cap
6. Actuator (AAS)
7. Nuts and bolts (Ignition coil
bracket)
76G13X-012
8. Bolt and nut
9. Nut
10. Shock absorber assembly
11. Seat
86U13X-010
Removal Note
ABS Harness bracket
Remove the ABS harness and bracket.
13—13

1 3 FRONT LOWER ARM
FRONT LOWER ARM
REMOVAL AND INSTALLATION
1. Jack up the front of the vehicle and support it with safety stands.
2. Remove in the sequence shown in the figure, referring to the removal note for specially marked parts.
3. Inspect all components and parts, referring to inspection note.
4. Install in the reverse order of removal, referring to the installation note for specially marked parts.
5. Tighten all nuts and bolts to the specified torque, referring to the figure.
16—23 N m (1.6—2.3 m-kg, 12—17 ft-lb)
(9—12 m-kg, 65—87 ft-lb)
76G13X-018
1. Lug nut 6. Retainer and bushing 10. Nut
2. Wheel and tire 7. Retainer, bushing and 11. Bolt
3. Bolt and nut spacer 12. Front lower arm
4. Nuts 8. Nut 13. Front bushing
5. Bolt 9. Bolt 14. Rear bushing
13—18

13 FRONT STABILIZER (4WS)
86U13X-040
Removal Note
1. Remove the wheel and tire.
2. Remove the stabilizer bar control link.
3. Remove the bolts indicated by the arrows.
4. Remove the stabilizer bushing and bracket.
86U13X-042
86U13X-043
13-24
5. Remove the stabilizer.

REAR SHOCK ABSORBER AND SPRING 1 3
REAR SHOCK ABSORBER AND SPRING
REMOVAL AND INSTALLATION
1. Jack up the front of the vehicle and support it with safety stands.
2. Remove in the sequence shown in the figure, referring to the removal note for specially marked parts.
3. Install in the reverse order of removal, referring to the installation note for specially marked parts.
4. Tighten all nuts and bolts to the specified torque, referring to the figure.
1. Trim 4. Clip 7. Bolt and nut
2. Lug nut 5. Harness and bracket (ABS) 8. Nut
3. Wheel and tire 6. Actuator (AAS) 9. Shock absorber assembly
13-29