
CHASSIS AND BODY MAINTENANCE
MAINTENANCE OPERATION MAINTENANCE INTERVAL
Periodic mamtenance should be performed Mdes x 1,000 15 30 45 60
at number of miles. kilometers or months IKnlometers x 1 0001 1241 1481 1721 196) Reference page
whichever comes first Months 12 24 36 48
Brake liner E hoses I I I I MA-26
Brake
pads E discs I 1 I I MA-27
Brake fluid
R R MA-26
Manual and
automatic transmission E differential gear 011 I I I I MA-18, 19. 20
Power rteerlng lines E hares I I I I MA-34
Steering gear & linkage, & suwenston parts I I I I MA-21,22,23.34
Steertng llnkage ball
~OlntL E front suspension ball JOllltS
Propeller shaft14 I I MA-20
Locks.
hinges E hood latch L L L L MA-35
Front wheel bearing grease
I I MA-22
Exhaust system
I I I I MA-17
Seat belts, buckles, retractors. anchors E adiusler I I I I MA-35
I MA-21,34
Abbreviations A =Adlust
R = Replace
I = Inspect Correct or replace if necessary
MAINTENANCE UNDER
SEVERE DRIVING CONDITIONS
The maintenance intervals shown on the
preceding pages are for normal operating
DW"g Mal"te"a"Ce Mal"te"a"Ce Malnte"a"Ce condition item OperaflO" interval
C Aw cleaner filter R More frequently
R Every 3.000 miles Engine 001 IExceDt turbo- ABC E charged engine) 15.000 km) or 3 months conditions If the vehicle is operated under
severe driving conditions as shown below, Engine 081 ITurboCharged R Every 2,500 miles
more frequent maintenance must be per-
formed on the following items as shown in A E
engd
Engine 081 filter R At the first 001 change
(4,000 kml or 3 months
and then every second 011 the table rhmae
Severe driving conditions
A - Repeated short distance driving
6 - Extensive idling
C - Driving in dusty conditions
D - Driving in extremely low or hlgh
ambient temperatures
E - Towing a trailer
F - Driving in areas using road salt or
G - Driving on rough andlor muddy
H - Driving in high humidity areas or in
other corrosive materials
roads
mountainous areas
A C EFG Brake pads & dorm I Every 7,500 miles 112,oW kml or 6 months
124.000 kml or 12 months
I48 Ow kml 01 24 monlhi
H Brakefluid R Every 15.000 miles
EG Manual and automatic trans- R Every 30.000 miles mmmn & drtferentml (lea, 011)
G Steering gear & linkage. I Every 7.500 miles 112 000 kml or 6 months
Every 7,500 miles
112.000 kml or 6 months
& rurpenrlon parm
(I front rurpenrlo" ball 1Ol"fS
CO FG Steering linkage ball pnts I
F Locks. hinges & hood latch I Every 7.930 miles
A EFG Exhaust system I Every 7,500miler
Maintenance operations I = lnr~ect Correct or replace 11 necerrary R = Replace
112.000 kml or 6 months
112.000 kml or 6 monthi

GENERAL MAINTENANCE
Item
Windshield washer fluid Check that there
is adequate fluid
in the tank
Reference item in MA section
-
Engine coolant level Check the coolant level when the -
engine is cold
Radiator and hoses Check the front of the radiator and
clean off any dirt, insects,
leaves, etc , that may have
accumulated Make sure the hoses have no cracks, deforrna-
tion, rot or loose connections
Brake and clutch fluid levels Make sure that the brake and CHECKING CLUTCH FLUID LEAKS
clutch fluid
levels are between the "MAX" and "MIN" lines INSPECTING BRAKE LINES & HOSES
on the reservoir
Engine drwe belts Make sure that no belt if frayed, worn,
cracked or oily CHECKING AND ADJUSTING DRIVE BELT
Engine oil level Check the level on the dipstick after park- -
ing the vehicle on a level spot and turning off the engine
Power steering fluid level Check the level on the dipstick
when the fluid
is cold and the engine is turned off
0 CHECKING POWER STEERING FLUID LEVEL
Automatic transmission fluid level Check the level on the CHECKING AUTOMATIC TRANSMISSION
dipstick after putting the selector
level in "P" with the FLUID LEVEL
engine idling
Exhaust system Make sure there are no loose supports, 0 INSPECTING EXHAUST SYSTEM
cracks or holes If the sound of the exhaust seems unusual
or there
is a smell of exhaust fumes, immediately locate the
trouble and correct
it
Underbody The underbody is frequently exposed to corro-
sive substances such as those used on icy roads or to control
dust
It is very impOrtant to remove these substances, other-
wise rust will form on the floor pan, frame, fuel lines and
around
the exhaust system. At the end of winter, the
underbody should be thoroughly flushed with plain water,
being careful to clean those
areas where mud and dirt can
easily accumulate.
Fluid leaks Check under the vehicle for fuel, oil, water or
other fluid
leaks after the vehicle has been parked for a 0 INSPECTING MANUAL TRANSMISSION OIL
while.
Water dripping from the air conditioner after use is 0 INSPECTING AUTOMATIC TRANSMISSION FLUID
normal. If you should notice
any leaks or gasoline fumes
are evident, check for
the cause and correct it immediately.
0 CHECKING CLUTCH FLUID LEAKS
0 INSPECTING DIFFERENTIAL GEAR OIL
0 INSPECTING FRONT AXLE AND SUSPENSION
0 INSPECTING REAR AXLE AND SUSPENSION
0 INSPECTING BRAKE LINES & HOSES
0 CHECKING POWER STEERING LINE & HOSES
PARTS
PARTS
MA-6

kmlmils Month
ENGINE ANTI FREEZE- - COOLANT
FRONT WHEEL
BEARING GREASE -
BRAKE FLUID -
DIFFERENTIAL - GEAR OIL
* Maintenance under severe driving condittons
z
tl
:
h)
whsather conditions or in areas where ambient
temperatures are either extremely low or extreme ly high, the filter might becomeclogged In such
, -1 --I-- 4 - -1 - t WINDSHIELD AND REAR
WINDOW WASHER FLUID --
-/---l--]--t-]-- POWERSTEERINGFLUID
w-1 --I- -ENGINE OIL (Except turbocharger engine)
- - @) OIL FILTER
*
--MANUAL TRANSMISSION
--AUTOMATIC
TRANSMISSION
@ Replace at the first 011 change After that. replace 011 filter every second engine 011 change

ENGINE MAINTENANCE
Aw conditioner
compressor
Power steering oil pump
Applied pushing force
Checking Drive Belts
1 Inspect for cracks, fraying, wear or oil adhe-
sion Replace
if necessary
The belts should not touch
the bottom of the
pulley groove.
2
Adjust if belt deflections exceed the limit.
0 VG3OE engine (without turbocharger)
Check drive belt deflections by pushing middle
between pulleys
16 9-11 7-9
10 63) (0 35.0431 (0 28 - 0 351
21 13-16 10-13 (083) (051 -0631 (039-0511
98 N (10 kg. 22 Ibl
Power steering
Alternator pulley
Water pump pulle
SMA777A
VG30ET engine (with turbocharger)
Replacing Air Cleaner Filter-
The viscous paper type air cleaner filter does not
require any cleaning operation between renewals.
SMA779A
Checking Vapor Lines
1. Visually inspect vapor lines for proper attach-
ment, cracks, damage,
loose connections,
chafing and deterioration
2. Check vacuum relief valve for clogging,
sticking, etc
MA-8

CHASSIS AND BODY MAINTENANCE
Checking Steering Gear
and Linkage
SM A130A
Steering gear
(1) Check gear housing and boots for looseness,
(2) Check connection with steering column for
Steering linkage
(1) Check ball joint, dust cover and other compo-
nent
parts for looseness, wear, damage or
grease leakage
(2) Check any missing parts (cotter pins, washer,
etc
)
damage or grease leakage
looseness
Checking Power Steering
System Fluid and Lines
Check fluid level, when the fluid is cold
SMA750A
Check lines for proper attachment, leaks,
cracks, damage,
loose connections, chafing and
deterioration
SM A7 39A
MA-34

SERVICE DATA AND SPECIFICATIONS (S.D.S.)
Used belt deflection
Limit
Adlusted deflecraon
Engine Maintenance
INSPECTION AND ADJUSTMENT
st deflec. TIon Of
new belt Pedal free Play "A"
Alternator
1 -3 IO M -0 121
Arr conditioner I 16 I 9-11 I 7-9 compressor (0631 1035 0431 (028-0351
ADDlted pushtng force I 98 N 110 kg, 22 Ibl
21
10831 Power steering 011 pump
Oil capacity
13.16 10-13
1051 .0631 (039-0511 ~~
unlt P IUS qt. Imp qtl
Wheel alignment IUnladenI
Camber
degree
Caster degree
-35' to 55'
5*50.7"30
Coolant capacity Unlt &? IUS qt. Imp qtl
Wlth 041 falter
Wtthout
001 filter
VG30E & VG30ET
4
0 (4-1 /4, 3-1/21
3 3 13-1/2.
2 7/81
Spark plug
VG30E
I VG30E I VO3OET
105 111-1/8, 91/41
Front wheel turning angle Toe-out turns
Inner wheelIOufer wheel
degree
Plug uaD I 10- 1 1 mm 10039-OW3 in1
22"30'/20'
altitude I 20*2'/650t50 I 20t2'/650f50
standard iype
Hot type
Cola woe
condmon
VG30ET I 20 f 2"/700 f 50 I 20 + 2'/650 t 50
BCPR6ES.11 BCPR6E-11
BCPRSES.11 BCPRSE-11
BCPR7ES.11 BCPR7E-11
TIGHTENING TORQUE
U"lt Nm kg-m ft-lb
Full turns Inner wheel degree
Outer wheel degree
Or1 pan drain plug 29-39 30-40 22-29
Spark plug 20-29 20-30 14-22
Fuel hme clamps 10-15 010-015 07-11
35" .39"
27" .31'
-Chassis and Body Maintenance-
INSPECTION AND ADJUSTMENT
Clutch
Unlt mm 11nI
Pedal height "H" I 195 - 205 I7 68.8 071
Front axle and front suspension
Wheel bearmg preload
IAr measured at wheel hub bolt1 6 86.14 61
With used parts N Ikg, Ibl 1 1 67.7 75 IO 17-079.037- 1741
Kingpin mclination degree I 12'15'- 13'45
degree I 6'- 16
Out 3 (0 0361 - In 3 (0 0361 Side lip IReference datal mm/m lin/ftl
37 5 I1 476) Standard side rod length "A" mm bnl
* On power steering models, wheel turning force la1 circumference
afsteeringwheellof98-147NI10-15kg.22-33lblwith
engtne at idle
Rear axle and rear suspension
Camber degree I -1-55' fa -25
mm (4") I -2 to 2 1-0 08 to 0 081 Toe-,"