INJECTOR COOLING FAN (VG30ET)
Inspection
START
T
Disconnect water temperature switch harness connector
and connect the terminal to ground with
a jumper wire
I
Turn ignition switch
I OFF+ON+OFF L
1
I
Make sure that cooling fan motor starts to operate 1 NG I IOK I
1
Check harness for continuity ~~
[ Perform
component check
COMPONENT CHECK
A Fan motor
1 Make sure that continuity exists between
terminals of fan motor
SEF734B
2. Apply battery voltage to the terminals of fan
motor. If fan motor
does not operate, replace
SEF7358
EF & EC-70
