HEADLAMP
0
0
Headlamp Motor Check
0 No
8 Yes
Use an ohmmeter to check for continuity in
headlamp motor circuit while rotating motor
with manual knob
CAUTION.
Prior to performing continuity test, disconnect
ground cable from battery.
Ohmmeter probe
Headlamp Continuity
Yes
No
Alqning mark for
for up posltlon
SEL652D
- Aiming Adjustment
When performing headlamp aiming adjustment, use
ail aiming machine, aiming wall screen or headlamp
tester For operating instructions of any airner, it
should be in good repair, calibrated and used ac-
cording to respective operation manuals supplied
with the unit
If any aimer is not available, aiming adjustment can
be done
as follows
For details, refer to the regulations in your own
country.
CAUTION:
a Keep all tires inflated to correct pressures.
b. Place vehicle and tester on
one and same flat
surface.
c See that there is no load in vehicle (coolant, en-
gine oil filled up to correct level and full fuel
tank) other than
the driver (or equivalent
weight placed in driver's position).
W~=l,ltO(4409I c 'L
-7
, - LO 1300 001
Of headlamps
UPper edge of Vertical centerline ahead of headlamps -x high tntenrw zone
Height of lamp centers I .- 100 141
100 (41 .-
L A
4.. I.. 100 1100 1001 loo (41 (41 / (41 (41
KLeft edge of high intensity zone
= ACCEPTABLE RANGE untt mm (in1
SEL914D
Adjust headlamps so that upper edge and left
edge
of high intensty zone are within the ac-
ceptable range as shown
in the figure above
Dotted lines in illustration show center of
headlamp.
EL-33
@ To @ (Non-turbocharger models) 0 Ambient temp sensor 0 Vacuum tank (Turbocharger models)
0 To @I (Turbocharger models) 0 PoglampRH @ Hoodswitch
0 To @il White) @ Vacuumpump 0 I'oglampLH @ Hoadlamp washer motor
0 @D Horn L H
/ @ Side marker lamp L H
0 To @I (Blue) (Turbocharger models)
@ To @ White) 0 ranmotor
@ Uphold relay (Turbocharger models)
@ Fuublchk @ Headlamp motor R H
0 Front shock absorber R H @ Radiator coolant level switch 0 Hcadlamp L H
Front combmation lamp L H
A/T relay I @ AS C D relay (Non-turbocharger AIT models) @ Water cock an valve Compressor relay 0 Headlamp R H Vacuum pump relay @ Side marker lamp R H
(Turbocharger models) @ Horn RH Horn relay @ Front combination lamp R H
6 Headlamp tmer @ To @ (Blue) I@ To @ (White)
@Q To @ (White) @ To 0 (Non-turbocharger models)
@ Inhibitor switch (Non-turbocharger models)
