1981 CHEVROLET MONTE CARLO stop start

Downloaded from www.Manualslib.com manuals search engine Make Connections in Numerical Order
Fi,st Jumpe, Ceble ,
Discharged
Battery
Make Last
Connection on
Engine,
Away
from Battery
Battery in Vehicle
with Charged Battery L--'''''''",,""
4. Slarllhe engine 01 the vehicle withJhe .good (charged) battery and run the
engine at a moderate speed.
5 .
Start the engine of the vehicle thathas the discharged battery.
6 . Remove the jumper
cables .by reversing the above sequence exactly.
Begin by removing the jumper
cable clamp from the vehiclewilh tM
discharged battery. While removing each clamp, lake care that it does not
touch any other
metal while the other end remains attached.
Your cooling system may temporarily overheat during severe
conditions such as:
• climbing a long hill on a hot day,
• stopping after high speed driving ,
• idling for long periods in traffic, or
• tawing a trailer.
3-3

Downloaded from www.Manualslib.com manuals search engine "the "TEMP" light comes on (or, if you have a 900lant temperature gage, the
gage needle goes into the warning zone) and your air conditioner is on, turn it
off.
If the "TEMP" light (or gage) comes on while you are stopped in traffic,
shift the transmission to
"N" (Neutral).
If the "TEMP" light doesn't go off (or the gage needle doesn't start to drop)
within a minute or two:
• Pull over to a safe Place ""d stop the vehicle. Set the parking brake and
shift to "P" (Park) 9r, with a manual transmission, shift to Neutral first, then
set the parking brake.
• DON'T TURN OFF THE ENGINE. INCREASE THE ENGINE SPEED until it
sounds like it's going about twice as fast as normal idle speed. Bring the
idle speed back to normal
after two or three minutes.
tfthe "TEMP" light still doesn't 90 off, (or the gage needle doesn't start to
drop),
NOW TURN OFF THE ENGINE and proceed as follows.
•
lift the engine hood. Look at the coolant level in the "see through" coolant
recovery tank. The coolant level. should be at or above the "Full Cold"
mark on the tank. If it looks like the coolant is boiling, wait until it stops
before proceeding. You should not need to remove the radiator cap to
check the coolant
level and. it can be dangerous if the coolant is still hot. See the following Caution.
CAUTION: To help avoid being burned:
"'-'''''''''i',",,;0-Fc:io'ffi)tcremoy'J~_ c;<)olant recovery tank cap if the coolant is boiling, and
• do not remove -the radiatorc:ap WhilethIit8ngine'-aUid:radiltor a,.Slili hot.
Scalding fluid and steamean be released under pressure it either cap is taken off too soon,
-;<
• If coolant level is low:
•
looklorleaks at the radiator hoses and connections, heater hoses and
connections,
r"diator,and water pump. See that the. fan belts are not
broken or off the pulleys an.d that the fan turns when the engine is started,
•
Add coolant to the recovery tahk.
If
the cQolant level in the recovery tank is althe correct lellel arid the "TEMP"
light (gage) still co"",s.dn,. air may be tr~ in the cooling system, This may
stop coolant from returning to the radiator. In this case, you may have to add
coolant directly to the radiator.
See "Coolant Replacement" under engine
cooling system
in "Service and Maintenance," Section 5 of this manual. Follow
steps 1 and 10. for the correct way to remove the radiator cap and add .coolant
to the radiator.
After the
"TEMP" light is out (or the gage needle is out of the warning zone),
resume driving at a reduced speed. Return to normal driving after about ten
minutes if the light does not come back
on (or the gage needle does not go
back into the warning zone).
3-4

Downloaded from www.Manualslib.com manuals search engine COMPUTER COMMAND CONTROL SYSTEM
Your new vehicle has a special emission contrOl system, called the Computer
Command Control system. Some vehicleS sold in Canada also have the
Computer Command Control system. II your Canadian vehicle has a "CHECK
ENGINE" light,
it dOes have the Computer Command Control system.)
The Computer Command Control system monitors . the .exhaust stream with
an
oxygen sensor. Based on sensor signals, the electronic control module adjusts
the carburetor air-fuel ratio as needed. It is very important to use only
unleaded gasoline in vehicles equipped with the Computer COmmand Control
system . .Leaded gasoline will damage the oxygen sensor and may affect
. emission controL .
On
all vehicles with the COmpute r Command Control system, a "CHECK
ENGINE" ligtit
on the instrument panel is designed to come on during engine
starting, to
let you knowthe bulb .is working. (The light will stay on a'shdl1iime
after the. engine starts.) If. the light comes on while driving, service to the
Computer Command Control system may be. required. Although your vehicle
may
still be drivable,see yoyr dealer as SOon as possible for an inspection of
the system.
Continued
driving · Without having the Computer Command Control system
serviced could cause damage to the emiSsion control system. It could also aftect fuel economy and drivability. .. ..
ENGINE OIL AND FILTER RECOMMENDATIONS
Checking 011 Level ,>,-.. ,
The engine oil must be kept at the right level to. help assure proper lubrication
of your vehicle' .s engine.
It is the owner's responsibility to' cheCk the oil level at
regular': infervals '{such . 'as . "e~~Y"JHflLstop), according ·to ' the following instruct ions . It is normal for an engine-O to use Some oil, and most engines may
use
more oil when they are new . " .
• The best time to check' the engine Orffevel is when the oil IS warm, such as
during a
fuel stop. First, wait about 5 minutes for the oil to drain back to the oil pan. Then, pull out the dipstick on the side of the engine block (either
right or left). Wipe
it clean and. push the dipstick back down all the way.
Now,
pull out the dipstick and look at the oil level .on the dipstick.
Some dipsticks have "Add" and "Full" lines. Others are marked "Add lOt"
and "OperatlngRange ." In all cases, keep the oil level above the "Add" line_ Push the dipstick .oock down alilheway after taking the reading . Add oil , if needed . . .
• If you check the oil level when the oil is cold, do not iun the engine first.
The
cold oil will not drain back to the pan fast enough to give a tr ue oil
level. . .
Ch '
oosing the Right Quality on
Engine oils are labeled on'the containers with variOus API (Amercian Petroleum Institute) deSignations of·quality. Artewhigher-quality category of engine 011,
designation "SF", was introduced early in 1980. Be sure the oil you use has
the
API designation "SF," either alone or shown with other designations . Do not use oils labeled only SA, SB,SC, SO,' SE, CA, CB,CC, or CD; or oils
with a combination of any of these categories-like SE/CD.
5-3

Downloaded from www.Manualslib.com manuals search engine SERVICE STATION INFORMATION
Refer to "Service and Maintenance,"
Section 5 for Further Details
Fuel Cap -Localed behind the license plate.
See fuel cap removal procedl,lre on page 5-1.
Fuel Requirements -Use unleaded gasoline only. See "Fuel Requirements "
in "Starting and Operating. " Section 2 of this manual.
Hood Release - Located beneath the instrument panel to the left of the
steering column. To open, pull the handle to release the hood lock. Then push down slightly on the hood while lifting the underhood lever , and raise the hood. (See illustration).
Engine Oil Oipstiek-Located on right or left side of engine block depending on engine model. Check the engine oil level when the oil is warm, such as during a fuel stop. Keep the oil level above the "Add " line on the dipstick .
Engine Oil Recommendation (Gasoline Engine) -Use only SF-quality oils. (See "Service and Maintenance," Section 50f this manuaL) The chart on page 5·5 will serve as a guide for choosing the proper viscosity oil.
Tire Inflation. Pressures -Check at least monthly (including the spare, unless it is a stowaway spare). Keep them inflated to pressures shown on
the Tire Placard on the left door. (Keep compact spare tires inflated to 415 kPa or 60 psL)
Engine Cooling System -Check the fluid level in the "see·through " coolant recovery tank at regular intervals , such as during a fuel stop. (See "Engine Cooling System " in "Service and Maintenance, " Section 5 of this manual.
Windshield Washer -Check reservoir fluid level regularly. Use a washer fluid, such as GM Optikleen .
Battery -Your new car has a Delco FREE[X)M It battery. You will never have
to add water. The hydror:neter (test indicator) in ,the cover provides infor­mation for testing purposes only.