1965 CHEVROLET CORVAIR check engine

Downloaded from www.Manualslib.com manuals search engine TIRE CARE
Keep your tires inflated to the recommended pres­
sures.
Over-inflation can adversely affect riding comfort,
quietness and tire life while under-inflation affects vehicle
handling and tire life.
RECOMMENDED TIRE INFLATION PRESSURES (Based on Original Equipment Tires)
CORVAIR (6.50-134 PR Tires) Cold-Hot**
Average Owner Service up to 5-Front Rear Front Rear
passenger load (normal i nfla-tion) Air conditioned models and convertibles 15 28 18 33 All other models 15 26 18 31 Continuous Service with up to fu II load ca pacity or h ig h speeds (maximu m inflation) 19 30 22 35
NOTE: As shown in the above table, Corvair rear tire pressures should be maintained at least 11 psi higher than front tire pressures;
CORVAIR .95
7.00 x 14"4 ply S.P. 24 30 28 35 7.00 x 14-6 ply S.P. 24
34 28 39 7.00 x 14-6 ply I Light Truck 24
45 28 50
7 .00 x 14 -8 ply I Type 24 60 28 65
Spare Tire...,.lnflate to proper Rear (Cold) pressure. Deflate to correct pressure when using as front tire. -After car has been parked for 3 hours or more or driven less than one mile. --Pressures can riseas much as 7 pounds above cold figures depending on loads carried, length of driving, and car speed prior to check.
, Fron t tire loads increase appreciably with cargo
lci'ading; therefore the above is recommended for best
steering characteristics.
34
Full load capacity of the vehicle is 1 OOOlbs. total.
Consisting of 3 passengers in front seat, 3 passengers
in
rear seat and 100 Ibs . luggage.
Manufacturer's original equipment 4-plyrating tires
are designed and thoroughly tested to meet all normal
requirements of your vehicle as outlined above.
For continuous full load service or heavy duty oper­
ation, eight ply rated tire options are recommended at
the above recommended tire pressures.
Switching Tires
When rear tires are replaced, put new tires on front
and used on rear and reset to recommended tire
pressures. ,
FOR MAXIMUM TIRE LIFE
• Ke.ep tires properly inflated.
• Check regularly for cuts, bruises and puncturing ob­
jects. Nails etc. will often be carried in the tire with
no noticeable loss of air. Do not remove a puncturing
object until prepared to change or repair the tire.
• Avoid unnecessary sudden starts and stops; take curves
and corners slowly.
•
Avoid driving over curves, sharp objects or chuckholes.
•
Have wheel alignment checked periodically, especially
when tires show unusual wear.

Downloaded from www.Manualslib.com manuals search engine Inspection and Repair
Inspect frequently for puncturing objects in the tires.
If any are found, do not attempt removal until you are
in a position to change the tire or have it repaired. Also,
check regularly that the wheel rim has sustained no
damage which could affect the air seal.
AIR CONDITIONED CARS •
COUPE CONVERTIBLE
AND SEDAN STYLES
....
35
SPARE TIRE AND JACK STOWAGE
Spare tire and jack stowage for the different styles
are illustrated below. On models with the spare tire
located in the engine compartment, mount the wheel on
the locating studs with the valve opening downward and
toward the center of the car.
GREENBRIER MODELS

Downloaded from www.Manualslib.com manuals search engine PERIODIC MAINTENANCE AND LUBRICATION
The time or mileage intervals on the following pages
are intended as a general guide for establishing regular
maintenance and lubrication periods for your Corvair.
Sustained heavy duty or high speed operations or oper­
ation under adverse conditions may necessitate more
frequent servicing. For specific recommendations for con­
ditions under which you use your vehicle, consult your
authorized Chevrolet Dealer.
37
ENGINE OIL CHANGE*
See "Engine Lubrication" in previous pages.
OIL FILTER*
Change the filter element every 6000 miles or every
six months, whichever occurs first.
CRANKCASE VENTILA T10N*
Valve Type (Air Conditioned Models)-Test at every
oil change, replace as required.
Fixed Orifice Type-Check at every oil change,
clean every
12,000 miles.
STEERING GEAR
Every 36,000 miles-Remove filler plug and check
lubricant level. If necessary add water resistant EP
lubricant to bring to level of filler plug hole.
* More often under prolonged dusty driving conditions.

Downloaded from www.Manualslib.com manuals search engine FAN BELT
Every 6000 miles-check condition of belt. On vehicles
. equipped with belt guides, check belt guide to belt
clearance. Belt guide clearance should be approxi­
mately 1/ 16/1 after belt is tensioned. (Seepage 50.)
DISTRIBUTOR CAM
LUBRICATOR
Every 12,000 miles-
Rotate cam lubricator
180 degrees.
Replace lubricator at
24,000 mile intervals .
The cam lubricator should
not be oiled, damage to
ignition points
may result
if proper lubricant is not
used on cam.
8R:EAKER PlATE "nACHlNG SCREWS
39
AIR CLEANER
PAPER ELEMENT TYPE (Oil-Wetted)
Every 6000 miles -Inspect or test air cleaner paper
element. If inspection reveals that element is satisfac­
tory it may
be reused ; however, element should be
inspected or tested every 6000 miles until it is
replaced. Element must not be oiled, washed, tapped
or cleaned with an air hose.
Under severe dust conditions
it may be necessary to
inspect
or test the element more often.

Downloaded from www.Manualslib.com manuals search engine AIR CONDITIONING
After the first 6000 miles-have your Chevrolet Dealer
check the tightness of all hose damp connections.
Every 6000 miles-Check sight glass, located under the
hood, after the system has been in operation for
several minutes. Sight glass should be clear. Bubbles
or dirt indicate a leak which should be corrected
immediately by your Chevrolet Dealer.
BRAKE LININGS
Have the brake linings inspected periodically. Fre­
quency of inspection will depend on traffic, terrain
and the driving habits of the driver.
BRAKE
MAIN CYLINDER
Every 6,000 miles-Check fluid level and maintain % II
below opening with G. M. Hydraulic Brake Fluid
Supreme No. 11.
PARKING BRAKE AND CLUTCH PULLEYS
AND CABLES-CORVAIR
Every 12,000 miles-Lubricate pulleys under dash. Re­
move the tunnel cover under vehicle and lubricate
pulleys and cable bearing points with a water resist­
ant EP Chassis Lubricant. Lubricate gearshift lever
ball
and socket (see page 41 J at the same time.
40
FRONT WHEEL BEARINGS
Clean, repack with high melting point wheel bearing
lubricant, and adjust whenever brake drums are re­
moved. Replace grease seals at the same time.
ENGINE OIL COOLER
Every 12,000 miles (more often under prolonged dusty
driving
conditionsJ-Remove cover and brush or
blowout accumulated dirt.
NOTE: Material usually found in the oil cooler
consists primarily
of twigs, straw, chaff, and
leaves.

Downloaded from www.Manualslib.com manuals search engine TRANSMISSION-POWERGLIDE
Every 6000 miles-Check fluid level on dipstick with
engine idling, selector lever in NEUTRAL position,
parking brake set and transmission at operating
temperature. If fluid level is below full mark on dip­
stick,
add small amount of Automatic Transmission
Fluid Type
"A" bearing the mark AQ-ATF followed
by a
number and the suffix letter "A". Recheck
fluid
level on dipstick and again add a small amount
of fluid if needed to bring level to full mark. DO
NOT
OVERFILL.
NOTE: From the "Add Oil" mark to the "Ful/' ,
mark on the dipstick indicates a difference of
only 1 pint of fluid.
Every 1
2,000 miles (more frequently, depending on
severity of service, if vehicle is used to pull trailer,
carry full loads during high ambient temperatures,
41
operate in mountainous terrain or operate under
other severe condition .sl-Remove fluid from the
transmission sump and add two (2) quarts of fresh
fluid.
Operate transmission through all ranges and
check fluid level as described above.
If vehicle is so equipped, clean dust and dirt from
transmission oil cooler every 12,000 miles.
TRANSMISSION-3 AND 4-SPEED
Follow recommendations given under "Rear Axle"
on page 42.
TRANSMISSION CONTROL LINKAGE-
3 AND 4-SPEED
Corvair
Every 12,000 miles-Lubricate connector (indicated in the
illustration below) with a water resistant EP Chassis
Lubricant.
Every
12,000 miles-Remove tunnel cover under vehicle
and lubricate gearshift lever ball and socket with
Lubriplate.

Downloaded from www.Manualslib.com manuals search engine REAR AXLE
Check lubricant level, with 'axle at operating tempera­
ture, at the dipstick whenever engine oil is checked.
The dipstick is used to check lubricant level only;
do not attempt to fill axle at the dipstick tube.
,f lubricant level is at or below ADD mark on dip­
stick,
fill to level of the filler plug hole with SAE 80
Multi-purpose Gear Lubricant meeting the require­
ments
of U.S. Ordnance Spec. MIL-L-2105B.
Check 3-or
4-speed lubricant level, if the rear axle
lubricant level is low.
42
BATTERY
Every 6000 miles-Clean and
oil battery terminals and
oil felt washer. Clean
top
of battery with di­
luted
ammonia or soda
solution and flush with
clean
water. Check state
of charge especially in
freezing weather. An un­
dercharged battery may
freeze and break.
FUEL FILTER
Greenbrier Ballery and Transmission Oil Cooler Access Door
Corvair, Corsa and Greenbrier
Replace filters, located in each carburetor inlet, only
if flooding occurs.
Corsa Turbocharged
The fuel filter is a separate unit mounted on the air
cleaner support bracket at the left of the air cleaner. It
should be replaced at 12,000 mile intervals. At the
same interval, also clean the screen located in the car­
buretor inlet.

Downloaded from www.Manualslib.com manuals search engine BODY LUBRICATION POINTS
Most body lube points do not need frequent, heavy
lubrication. However, periodic checks
of certain points
on the Corvair body,
and lubrication when needed will
eliminate annoying squeaks and noises. Be careful not
to over-lubricate.
Wipe off all surplus lubricant.
The following items should
be lubricated periodically:
1. Door
Hinges-Wipe off dirt and apply lubriplate.
2. Door lock Striker-Wipe off dirt and apply stick
type lubricant.
3. Top lift Cylinder
Rods-Clean and lubricate with
G.M. Hydraulic Brake Fluid.
4. Door
Jamb Switch-Apply lubriplate.
5. Front and Rear Compartment lid lock-Apply lubri­
plate.
6. Front Compartment lid Torque Rods-Apply G.M .
lubriplate to bearing points.
43
7. Gas Tank Filler Door Hinge-Apply dripiess oil.
8 . Glove
Box Door Hinge-Apply dripless oil.
9. Rear Folding Seat Back Support link Assembly and
Filler Panel Hinge-Apply dripless oil to bearing
points.
The following should
be lubricated whenever acces­
sible.
10. Door Outside Handle lock Cylinder Shaft-Apply
lubriplate.
11. Door Window Regulator and Cams-Apply lubri­
plate.
12. Door
lock Parts-Apply lubriplate.
13. Door locking Mechanism-Apply lubriplate.
14 . Front
and Rear Compartment Hinges-Apply G.M.
lubriplate.