
Brake fluid reservoirReplenishing WindshieldWasher Fluid
WARNING
Use only windshield washer fluid or
plain water in the reservoir.
Using radiator antifreeze as washer
fluid is dangerous. If sprayed on the
windshield, it will dirty the windshield,
affect your visibility, and could result in
an accident.
Using Washer Fluid Without
Anti-freeze Protection in Cold
Weather:
Operating your vehicle in temperatures
below 4 ℃ (40 °F) using washer fluid
without anti-freeze protection is
dangerous as it could cause impaired
windshield vision and result in an
accident. In cold weather, always use
washer fluid with anti-freeze
protection.
CAUTION
Do not use soapy water or engine
antifreeze in the reservoir as it could
cause paint discoloration or pump
damage.
NOTE
State or local regulations may restrict
the use of volatile organic
compounds (VOCs), which are
commonly used as anti-freeze agents
in washer fluid. A washer fluid with
limited VOC content should be used
only if it provides adequate freeze
resistance for all regions and climates
in which the vehicle will be
operated.
Inspection and Servicing/Cleaning
Engine Compartment Inspection
9-17
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Replenish the washer fluid on a flat
surface. If the vehicle is tilted, washerfluid may not fill sufficiently.
Add washer fluid under any of the
following conditions.
The top of the fluid level is low.The Low Washer Fluid Level Warning
Indication/Warning Light (if
equipped) turns on.
The top of the fluid level is lower
than L (if equipped).
Use plain water if washer fluid is
unavailable.
But use only washer fluid in cold
weather to prevent it from freezing.
Inspecting Lead-acid
Battery
WARNING
Read the following
precautions carefully before using the
lead-acid battery or inspecting to
ensure safe and correct handling.
Always wear eye
protection when working near the
lead-acid battery.
Working without eye protection is
dangerous. Lead-acid battery fluid
contains SULFURIC ACID which could
cause blindness if splashed into your
eyes. Also, hydrogen gas produced
during normal lead-acid battery
operation, could ignite and cause the
lead-acid battery to explode.
Wear eye protection
and protective gloves to prevent
contact with lead-acid battery fluid.
Spilled lead-acid battery fluid is
dangerous.
Lead-acid battery fluid contains
SULFURIC ACID which could cause
serious injuries if it gets in eyes, or on
the skin or clothing. If this happens,
immediately flush your eyes with water
for 15 minutes or wash your skin
thoroughly and get medical attention.
Inspection and Servicing/Cleaning
Engine Compartment Inspection
9-18
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Inspecting the Tires
About Tires
For reasons of proper performance,
safety, and better energy efficiency,
always maintain recommended tire
inflation pressures and stay within the
recommended load limits and weight
distribution.
WARNING
Using Different Tire Types.
Driving your vehicle with different
types of tires is dangerous. It could
cause poor handling and poor braking;
leading to loss of control.
Except for the limited use of the
temporary spare tire, use only the
same type tires (radial, bias-belted,
bias-type) on all four wheels.
Using Wrong-Sized Tires.
Using any other tire size than what is
specified for the vehicle (page
10-71)is dangerous. It could seriously
affect ride, handling, ground
clearance, tire clearance, and
speedometer calibration. This could
cause you to have an accident. Use
only tires that are the correct size
specified for the vehicle.
Inspecting tire inflation pressure
WARNING
Always inflate the tires to the correct
pressure.
Overinflation or underinflation of tires
is dangerous. Adverse handling or
unexpected tire failure could result in a
serious accident.
Refer to Tires on page 10-71.
Use only a Mazda-genuine tire valve
cap.
Use of a non-genuine part is
dangerous as the correct tire air
pressure cannot be maintained if the
tire valve becomes damaged. If the
vehicle is driven under this condition,
the tire air pressure will decrease
which could result in a serious
accident. Do not use any part for the
tire valve cap that is not a
Mazda-genuine part.
Inspect all tire pressures monthly
(including the spare) when the tires are
cold. Maintain recommended
pressures for the best ride, handling ,
and minimum tire wear.
Refer to the specification charts (page
10-71).
NOTE
Cold inflation pressure
The cold inflation pressure is the
pressure measured under ambient
temperatures before the vehicle is
driven.
Maximum inflation pressure
The maximum inflation pressure is
the upper limit of the cold inflation
pressure designated by the tire
manufacturer.
Recommended inflation pressure
The recommended inflation pressure
is the cold inflation pressure
necessary for maintaining the
performance of your Mazda.
Underinflation or overinflation can
cause a harsh ride, reduced fuel
economy, a greater possibility of
damage from road hazards, uneven
and accelerated tire wear, and poor
sealing of the tire bead, which will
deform the wheel and cause
separation of tire from rim.
Inspection and Servicing/Cleaning
Vehicle Exterior Inspection
9-27
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Keep your tire pressure at the correct
levels. If one frequently needsinflating, have it inspected.Rotating the Tires
WARNING
Rotate tires periodically.
Irregular tire wear is dangerous. To
equalize tread wear for maintaining
good performance in handling and
braking , rotate the tires periodically or
sooner if irregular wear develops.
Please refer to Scheduled maintenance
for your tire rotation interval.
During rotation, inspect them for
correct balance.
Do not include (TEMPORARY USE
ONLY) spare tire in rotation.
Also, inspect them for uneven wear
and damage. Abnormal wear is usually
caused by one or a combination of the
following:
Incorrect tire pressureImproper wheel alignmentOut-of-balance wheelSevere braking
After rotation, inflate all tire pressures
to specification (page 10-71) and
inspect the lug nuts for tightness.
Inspection and Servicing/Cleaning
Vehicle Exterior Inspection
9-28
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

CAUTION
Rotate unidirectional tires and radial
tires that have an asymmetrical tread
pattern or studs only from front to rear,
not from side to side. Tire performance
will be reduced if rotated from side to
side.
Replacing a Tire or aWheel
WARNING
Always use tires that are in good
condition.
Driving with worn tires is dangerous.
Reduced braking , steering , and
traction could result in an accident.
Replace all four tires at the same
time.
Replacing just one tire is dangerous. It
could cause poor handling and poor
braking resulting in loss of vehicle
control. Mazda strongly recommends
that you replace all four tires at the
same time.
Always use wheels of the correct size
on your vehicle.
Using a wrong-sized wheel is
dangerous. Braking and handling could
be affected, leading to loss of control
and an accident.
CAUTION
A wrong-sized wheel may adversely
affect:
Tire fit
Wheel and bearing life
Ground clearance
Snow-chain clearance
Speedometer calibration
Headlight aim
Bumper height
Tire Pressure Monitoring System
If a tire wears evenly, a wear indicator
will appear as a solid band across the
tread.
Inspection and Servicing/Cleaning
Vehicle Exterior Inspection
9-29
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Warnings and Cautionsabout Key BatteryReplacement
CAUTION
Make sure the battery is installed
correctly. Battery leakage could occur
if it is not installed correctly.
When replacing the battery, be
careful not to touch any of the
internal circuitry and electrical
terminals, bend the electrical
terminals, or get dirt in the
transmitter as the transmitter could
be damaged.
There is the danger of explosion if
the battery is not correctly replaced.
Dispose of used batteries according
to the following instructions.
Insulate the plus and minus
terminals of the battery using
cellophane or equivalent tape.
Never disassemble.
Never throw the battery into fire or
water.
Never deform or crush.
Replace only with the same type
battery (CR2032 or equivalent).
Replacing the Key Battery
Replace with a new battery before the
key becomes unusable.
The following conditions indicate that
the battery power is low:
The KEY indicator light (green)
flashes in the instrument cluster.
The system does not operate and the
operation indicator light on the
transmitter does not flash when the
buttons are pressed.
The system's operational range is
reduced.
Incorrect battery replacement
operation may damage the key.
Replacing the battery at an Authorized
Mazda Dealer is recommended.
If replacing the battery by yourself,
heed the following instructions.
1. Remove the lower cover while pressing the knob in the direction
of the arrow.
2. Press in the tab to unlock the uppercover.
Inspection and Servicing/Cleaning
Key Inspection
9-33
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Exterior Maintenance
WARNING
Dry off brakes that have become wet
by driving slowly, releasing the
accelerator pedal and lightly applying
the brakes several times until the
brake performance returns to normal.
Driving with wet brakes is dangerous.
Increased stopping distance or the
vehicle pulling to one side when
braking could result in a serious
accident. Light braking will indicate
whether the brakes have been
affected.
CAUTION
Before lifting the windshield wiper
blades off the windshield, always
follow the procedure for moving the
windshield wiper blades. Otherwise,
a wiper blade, wiper arm, or the
hood could be damaged.
Refer to the Replacing Windshield
Wiper Blade Rubbers section (page
9-23) for the procedure on how to
move the windshield wiper blades to
the service position.
When the vehicle power is switched
ON and the wiper lever is in the
AUTO position, the windshield
wipers may operate automatically in
the following cases:
The area of the windshield above the
rain sensor is touched or wiped with
a cloth.
The windshield or the rain sensor
area in the cabin is hit.
When the vehicle power is switched
ON and the wiper lever is in the
AUTO position, do not touch the
windshield or the windshield wipers
Otherwise, the windshield wipers
will operate automatically which
could catch your fingers or damage
the windshield wipers.
When removing ice or snow, or
cleaning the windshield, always
make sure the wiper lever is in the
OFF position.
Do not spray water in the engine
compartment. Otherwise, it could
result in engine-starting problems or
damage to electrical parts.
When washing and waxing the
vehicle, be careful not to apply
excessive force to any single area of
the vehicle roof. Otherwise, you
could dent the vehicle.
Make sure that the fuel-filler lid is
closed and lock the doors.
Otherwise, the fuel-filler lid may be
forcefully opened by water pressure
causing damage to the vehicle or
fuel-filler lid.
(Vehicles with hands-free liftgate)
When washing or waxing the vehicle,
turn off the hands-free liftgate using
the Mazda Connect or do not bring
the transmitter into the area around
the liftgate. Otherwise, the liftgate
could open unexpectedly resulting in
an accident. Refer to Power Liftgate
section (page 4-21).
Do not use steel wool, abrasive
cleaners, or strong detergents
containing highly alkaline or caustic
agents on chrome-plated or
anodized aluminum parts. This may
damage the protective coating; also,
cleaners and detergents may discolor
or deteriorate the paint.
Inspection and Servicing/Cleaning
Exterior Maintenance
9-35
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Interior Maintenance
WARNING
Do not spray water into the vehicle
cabin.
Spraying water into the vehicle cabin is
dangerous as electrical devices such as
the audio and switches could get wet
resulting in a malfunction or vehicle
fire.
CAUTION
Do not use polishing agents.
Depending on the product
ingredients, they could cause
discoloration, stains, cracks or
peeling of the coating.
Do not scrape or scratch the inside
of the window glass. It could
damage the thermal filaments and
the antenna lines.
When washing the inside of the
window glass, use a soft cloth
dampened in lukewarm water, gently
wiping the thermal filaments and the
antenna lines.
Use of glass cleaning products could
damage the thermal filaments and
the antenna lines.
If liquid such as fragrance is spilled
on the interior, wipe it off
immediately.
Do not use wax containing
compounds, organic solvents such as
gasoline or benzene, alcohols, acidic
or alkaline solvents, or bleach for
cleaning.
Do not try to rub
off the shiny surface
panels and the metallic parts with a
dry cloth. Otherwise, it may cause
scratches.
Instrument Panel Top
(Soft pad) Maintenance
Dashboard maintenance for areas
requiring further cleaning.
1. Wipe the soiled area with a soft cloth soaked in a mild detergent
diluted with water.
2. Wipe off any detergent and water remaining on the surface using a
cloth soaked in water and wrung
out well.
Inspection and Servicing/Cleaning
Interior Maintenance
9-37
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04