2024 MAZDA CX90 maintenance

Maintenance ItemNumber of times, maintenance was performed.
12345678
Disc brakes IIIIIIII
Steering operation and linkages II II
Front and rear suspension, ball joints and
wheel bearing axial play IIII
Body condition inspection for
rust, corrosion and perfora-
tion Canada IIIIIIII
Driveshaft dust boot II II
Bolts and nuts on chassis and body TTT T
Cabin air filter Replace every 48,000 km (30,000 miles) or 24 months.
Tire rotation Rotate every 12,000 km (7,500 miles).
Tire inflation pressure and tire wear
*4Inspect every 12,000 km ( 7,500 miles) or 12 months.
Emergency flat tire repair kit (if equipped)
*5Inspect annually.
Function of all lights IIIIIIII
Chart symbols:
I: Inspect: Inspect and clean, repair, adjust, fill up, or replace if necessary.
R: Replace
T: Tighten
Remarks:
*1 Reset the engine oil data whenever replacing the engine oil regardless of the message/wrench indicator light display.
*2 According to state/provincial and federal regulations, failure to perform maintenance on these itemswill not void your emissions warranties. However, Mazda recommends that all maintenance services
be performed at the recommended time or mileage/kilometer period to ensure long-term reliability.
*3 Use of FL-22 is recommended when replacing coolant. Using coolant other than FL-22 may causeserious damage to the engine and cooling system.
*4 Inspect a spare tire if equipped.*5 Check the tire repair fluid expiration date every year when performing the periodic maintenance.Replace the tire repair fluid bottle with new one before the expiration date.
Inspection and Servicing/Cleaning
Scheduled Maintenance
9-5
CX-90_8KG7-EA-22L_Edition1_new
2022-11-17 16:05:04

USA and Canada Residents (Severe Driving Scheduled Maintenance):
Number of months or kilometers (miles), whichever comes first.
Months 6 12182430364248
× 1000 km 8 16243240485664
× 1000 miles 5 10 15 20 25 30 35 40
Engine oil & filter
*1RRRRRRRR
Maintenance Interval (other than engine oil
& filter replacement)
*21st 2nd 3rd 4th
Chart symbols:
R: Replace
Remarks:
*1 Reset the engine oil data whenever replacing the engine oil regardless of the message/wrench indicator light display.
*2 Follow Maintenance Interval listed in Normal Driving Scheduled Maintenance.
Inspection and Servicing/Cleaning
Scheduled Maintenance
9-6
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Daily Inspection
The owner or a qualified service
technician should make these vehicle
inspections at the indicated intervals to
ensure safe and dependable
operation.

Bring any problem to the attention of
an Authorized Mazda Dealer or
qualified service technician as soon as
possible.
When Refueling
Brake fluid level (page 9-16)Coolant level (page 9-14)Engine oil level (page 9-13)Washer fluid level (page 9-17)
At Least Monthly
Tire inflation pressures (page 9-27)
At Least Twice a Year (For Example,
Every Spring and Fall)
You can do the following scheduled
maintenance items if you have some
mechanical ability and a few basic
tools and if you closely follow the
directions in this manual.
Coolant (page 9-14)Engine oil (page 9-13)

Improper or incomplete service may
result in problems. This section gives
instructions only for items that are easy
to perform.

As explained in the Inspection and
Servicing section (page 9-2), several
procedures can be done only by a
qualified service technician with
special tools.

Improper owner maintenance during
the warranty period may affect
warranty coverage. Refer to the
Inspection and Servicing section (page
9-2) for owner's responsibility in
protecting your investment. For details,
read the separate Mazda Warranty
statement provided with the vehicle. If
you are unsure about any servicing or
maintenance procedure, have it done
by an Authorized Mazda Dealer.

There are strict environmental laws
regarding the disposal of waste oil and
fluids. Please dispose of your waste
properly and with due regard to the
environment.

We recommend that you entrust the oil
and fluid changes of your vehicle to an
Authorized Mazda Dealer.
Inspection and Servicing/Cleaning
Daily Inspection
9-7
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Warnings and Cautionsfor Daily Inspection
WARNING
Do not perform maintenance work if
you lack sufficient knowledge and
experience or the proper tools and
equipment to do the work. Have
maintenance work done by a
qualified technician.
Performing maintenance work on a
vehicle is dangerous if not done
properly. You can be seriously injured
while performing some maintenance
procedures.
If you must run the hybrid system
while working under the hood, make
certain that you remove all jewelry
(especially rings, bracelets, watches,
and necklaces) and all neckties,
scarves, and similar loose clothing
before getting near the cooling fan
which may turn on unexpectedly.
Working under the hood with the
hybrid system operating is dangerous.
It becomes even more dangerous
when you wear jewelry, loose clothing
or have long hair or a long beard.
Either can become entangled in
moving parts and result in injury.
Pull over to a safe location, then
switch the vehicle power off and
make sure the fan is not running
before attempting to work near the
cooling fan.
Working near the cooling fan when it is
running is dangerous. The fan could
continue running indefinitely even if
the engine has stopped and the engine
compartment temperature is high. You
could be hit by the fan and seriously
injured.
Do not leave items in the motor
compartment.
After you have finished checking or
doing servicing in the engine
compartment, do not forget and leave
items such as tools or rags in the motor
compartment. Tools or other items left
in the engine compartment could
cause the hybrid system damage or a
fire leading to an unexpected accident.
CAUTION
When using a chassis roller, turn the
following systems off to prevent them
from mis-operating while the vehicle is
running on the chassis roller.
 Mazda Radar Cruise Control
(MRCC)
 Mazda Radar Cruise Control with
Stop & Go function (MRCC with
Stop & Go function)
 Cruising & Traffic Support (CTS)
 Smart Brake Support (SBS)
Inspection and Servicing/Cleaning
Daily Inspection
9-8
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Inspecting Engine Oil
CAUTION
Do not overfill the engine oil. This may
cause engine damage.

Use center display screen indication to
inspect the engine oil level.
1. Make sure the hood is closed.
2. Start the hybrid system.
3. Select “Information” on the Home screen to display the vehicle status
monitor.
4. Select “Vehicle Status Monitor”.
5. Select “Engine Oil Level”.
6. Select “Start”. The engine starts and measurement
of the engine oil level begins. Do
not depress the accelerator pedal
during the measurement.
NOTE
If measurement conditions not
shown on the display are not met
such as when warm-up operation
has not been completed due to low
outdoor temperatures, the
measurement error screen may be
displayed. In this case, drive the
vehicle using the engine for a
certain period of time to complete
the warm-up operation and repeat
the procedure.

7. Switch the vehicle power OFF.
NOTE
After the measurement is
completed, the engine does not
stop automatically.

Recommended Oil
Use SAE 0W-20 engine oil.
Mazda Genuine Oil is used in your
Mazda vehicle. Mazda Genuine
0W-20 Oil is required to achieve
optimum fuel economy.
For maintenance service, Mazda
recommends Genuine Mazda Parts
and Genuine Mazda Premium Oil.

Only use SAE 0W-20 oil “Certified For
Gasoline Engines” by the American
Petroleum Institute (API).
Oil with this trademark symbol
conforms to the current engine and
emission system protection standards
and fuel economy requirements of the
International Lubricant Standardization
and Approval Committee (ILSAC),
Inspection and Servicing/Cleaning
Engine Compartment Inspection
9-13
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Always keep lead-acid
batteries out of the reach of children.
Allowing children to play near
lead-acid batteries is dangerous.
Lead-acid battery fluid could cause
serious injuries if it gets in the eyes or
on the skin.
Keep flames and sparks
away from lead-acid battery cells and
do not allow metal tools to contact
the positive (+) or negative (-)
terminal of the lead-acid battery
when working near a lead-acid
battery. Do not allow the positive (+)
terminal to contact the vehicle body.
Flames and sparks near lead-acid
battery cells are dangerous. Hydrogen
gas, produced during normal lead-acid
battery operation, could ignite and
cause the lead-acid battery to explode.
An exploding lead-acid battery can
cause serious burns and injuries. Keep
all flames including cigarettes and
sparks away from lead-acid battery
cells.
Keep all flames and
sparks away from lead-acid battery
cells because hydrogen gas is
produced from lead-acid battery cells
while charging the lead-acid battery
or adding lead-acid battery fluid.
Flames and sparks near lead-acid
battery cells are dangerous. Hydrogen
gas, produced during normal lead-acid
battery operation, could ignite and
cause the lead-acid battery to explode.
An exploding lead-acid battery can
cause serious burns and injuries. Keep
all flames including cigarettes and
sparks away from lead-acid battery
cells.

Before performing lead-acid battery
maintenance, remove the hole cover
and the lead-acid battery cover.
Removing the Hole Cover
1.
2.
Inspection and Servicing/Cleaning
Engine Compartment Inspection
9-19
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Keep your tire pressure at the correct
levels. If one frequently needsinflating, have it inspected.Rotating the Tires
WARNING
Rotate tires periodically.
Irregular tire wear is dangerous. To
equalize tread wear for maintaining
good performance in handling and
braking , rotate the tires periodically or
sooner if irregular wear develops.
Please refer to Scheduled maintenance
for your tire rotation interval.
During rotation, inspect them for
correct balance.


Do not include (TEMPORARY USE
ONLY) spare tire in rotation.
Also, inspect them for uneven wear
and damage. Abnormal wear is usually
caused by one or a combination of the
following:

Incorrect tire pressureImproper wheel alignmentOut-of-balance wheelSevere braking

After rotation, inflate all tire pressures
to specification (page 10-71) and
inspect the lug nuts for tightness.
Inspection and Servicing/Cleaning
Vehicle Exterior Inspection
9-28
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Air ConditionerMaintenance
Before Using the Air Conditioner
Lack of refrigerant may make the air
conditioner less efficient.
The refrigerant specifications are
indicated on a label attached to the
inside of the engine compartment. If
the wrong type of refrigerant is used, it
could result in a serious malfunction of
the air conditioner. Consult a
professional, government certified
repairer for the inspection or repair
because a special device is required for
the air conditioner maintenance.
For details, consult an Authorized
Mazda Dealer.
Air filter
An air filter with pollen and dust
collecting function is equipped. To
ensure safe and comfortable use of the
air conditioner, have the air filter
replaced periodically.
For details, consult an Authorized
Mazda Dealer.
NOTE
If the airflow of the climate control
system significantly decreases, the airfilter may be clogged. Replace the air
filter.
If the vehicle is driven in areas with
large amounts of dust and heavytraffic such as in large cities and cold
regions, the air filter may need to be
replaced more frequently.
Inspection and Servicing/Cleaning
Vehicle Interior Inspection
9-32
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04