2023 TOYOTA RAIZE Engine switch

3486-3. Do-it-yourself maintenance
RAIZE_OM_General_BZ358E
Checking and replacing fuses
If a light or the electrical system does not operate, a fuse may have
blown. Check the fuse.
a Turn the engine switch to “OFF”
b Open the fuse box
▶Engine compartment
While pressing down the claw, lift
the cover
▶Instrument panel
For right-hand drive vehicles,
remove the glove box in the leg-
room of the passenger's seat
a Push the left side inward and
disengage the upper claw
b Push the right side inward
and disengage the upper claw
c Disengage the lower claws
For left-hand drive vehicles, dis-
engage the claws at 8 locations
and remove the lower cover in
the legroom of the driver's seat
KBRO620702N
1
3
2
KBRO620703N
KBRO620704E
RAIZE_OM_General_BZ358E.book 348 ページ ２０２２年５月１７日　火曜日　午後１時５９分

366
RAIZE_OM_General_BZ358E
7-1. Essential information
Emergency flashers
Use the emergency flashers to warn other drivers when the vehicle
has to be stopped in the road due to a breakdown or other reason.
Press the switch
All the turn signal lights will flash.
To turn them off, press the switch once
again.
NOTICE
⬛Emergency flashers
If the emergency flashers are used for a long time while the engine is not oper-
ating, the battery may discharge.
KBRO710201E
RAIZE_OM_General_BZ358E.book 366 ページ ２０２２年５月１７日　火曜日　午後１時５９分

3677-1. Essential information
RAIZE_OM_General_BZ358E
When trouble arises
7
If your vehicle has to be stopped in an
emergency
Only in an emergency when it becomes impossible to stop the vehi-
cle in the normal way, stop the vehicle using the following procedure:
a Keep the brake pedal depressed firmly with your both feet
Do not pump the brake pedal repeatedly. Th is will increase the effort required, and
the braking distance will also become longer.
b Set the shift lever to N
▶If the shift lever is set to N
c After slowing down, stop the vehicle in a safe place by the roadside
d Stop the engine
▶If the shift lever cannot be set to N
c Keep the brake pedal depressed with your both feet to reduce vehicle
speed as much as possible
d Vehicles without key-free sys-
tem: Stop the engine by turning
the engine switch to “ACC”
Vehicles with key-free system:
Stop the engine by pressing and
holding the engine switch for 3
seconds or longer, or press the
engine switch quickly for 3 con-
secutive times or more
e Stop the vehicle in a safe place by the roadside
KBRO710401E
KBTA710402
Press and hold for 3 or more
seconds or press in succession 3
or more times
RAIZE_OM_General_BZ358E.book 367 ページ ２０２２年５月１７日　火曜日　午後１時５９分

3717-1. Essential information
RAIZE_OM_General_BZ358E
When trouble arises
7
If the vehicle is submerged or water on the
road is rising
This vehicle is not designed to be able to drive on roads that are
deeply flooded with water. Do not drive on roads where the roads
may be submerged or the water may be rising. It is dangerous to
remain in the vehicle, if it anticipated that the vehicle will be flooded
or set a drift. Remain calm and follow the following.
⚫If the door can be opened, open the door and exit the vehicle.
⚫If the door can not be opened, open the window using the power win-
dow switch and ensure an escape route.
⚫If the window can be opened, exit the vehicle through the window.
⚫If the door and window cannot be opened due to the rising water,
remain calm, wait until the water level inside the vehicle rises to the
point that the water pressure inside of the vehicle equals the water pres-
sure outside of the vehicle and then open the door after waiting for the
rising water to enter the vehicle, and exit the vehicle. When the outside
water level exceeds half the height of the door, the door cannot be
opened from the inside due to water pressure.
⬛Water level exceeds the floor
When the water level exceeds the floo r and time has passed, the electrical
equipment will get damaged, the power windows will not operate, the engine
stop, and the vehicle may not be able to get moving.
⬛Using an emergency escape hammer*
Laminated glass is used in th e windshield on this vehicle.
Laminated glass cannot be shattered with an emergency hammer*.
Tempered glass is used in the windows on this vehicle.
*Contact your Toyota dealer or aftermarket accessory manufacturer for further infor-
mation about an emergency hammer.
WARNING
⬛Caution while driving
Do not drive on roads where the road s may be submerged or the water may
be rising. Otherwise the vehicle may be damaged and cannot move, as well as
become flooded and set a drif t, which may lead to death.
RAIZE_OM_General_BZ358E.book 371 ページ ２０２２年５月１７日　火曜日　午後１時５９分

3737-2. Steps to take in an emergency
RAIZE_OM_General_BZ358E
When trouble arises
7
WARNING
Observe the following precautions. Failure to do so may result in death or seri-
ous injury.
⬛When towing the vehicle
Be sure to transport the vehicle with
the front wheels raised or with all four
wheels raised off the ground. If the
vehicle is towed with the front wheels
contacting the ground, the drivetrain
and related parts may be damaged.
NOTICE
⬛To prevent damage to the vehicle wh en towing using a wheel-lift type
truck
⚫Vehicles without key-free system: Do not tow the vehicle from the rear when
the engine switch is “OFF” or the key is removed. The steering lock mecha-
nism is not strong enough to hold the front wheels straight.
⚫Vehicles with key-free system: Do not to w the vehicle from the rear when the
engine switch is “OFF”. Th e steering lock mechanism is not strong enough to
hold the front wheels straight.
⚫When raising the vehicle, ensure adequate ground clearance for towing at
the opposite end of the raised vehicle.
Without adequate clearance, the ve hicle could be damaged while being
towed.
⬛Towing with a sling-type truck
Do not tow with a sling-type truck to
prevent body damage.
KBRO720115
KBRO720117N
RAIZE_OM_General_BZ358E.book 373 ページ ２０２２年５月１７日　火曜日　午後１時５９分

3757-2. Steps to take in an emergency
RAIZE_OM_General_BZ358E
When trouble arises
7
Emergency towing procedure
To have your vehicle towed by another vehicle, the towing eyelet must be
installed to your vehicle. Install the towing eyelet using the following procedure.
aTake out the wheel nut wrench and towing eyelet (➞ P. 397)
b Remove the eyelet cover using a
flathead screwdriver.
To protect the bodywork, place a rag
between the screwdriver and the vehi-
cle body as shown in the illustration.
cInsert the towing eyelet into the
hole and tighten partially by
hand.
d Tighten down the towing eyelet
securely using a wheel nut
wrench or hard metal bar.
e Securely attach cables or ch ains to the towing eyelet.
Take care not to damage the vehicle body.
fEnter the vehicle being towed and start the engine.
If the engine does not start, turn the engine switch to “ON”.
gShift the shift lever to N and release the parking brake.
When the shift lever cannot be shif ted (continuously variable transmis-
sion): ➞P. 191
KBRO720106E
KBRO720108TN
KBRO720109TN
RAIZE_OM_General_BZ358E.book 375 ページ ２０２２年５月１７日　火曜日　午後１時５９分

3767-2. Steps to take in an emergency
RAIZE_OM_General_BZ358E
⬛While towing
If the engine is not running, the power assist for the brakes and steering will
not function, making steering and braking more difficult.
⬛Wheel nut wrench
The wheel nut wrench is stored at the bottom of the front left seat. ( ➞P. 397)
⬛After towing
Remove the towing eyelet and secu rely attach the cover in place.
WARNING
Observe the following precautions. Failure to do so may result in death or seri-
ous injury.
⬛While towing
⚫When towing using cables or chains, avoid sudden starts, etc. which place
excessive stress on the towing eyelets, cables or chains. The towing eyelets,
cables or chains may become damaged, broken debris may hit people, and
cause serious damage.
⚫Do not turn the engine switch “OFF”.
There is a possibility that the steerin g wheel is locked and cannot be oper-
ated.
⬛Installing towing eyelets to the vehicle
Make sure that towing eyelets are instal led securely. If not securely installed,
towing eyelets may come loose during towing.
NOTICE
⬛To prevent damage to the vehicle during emergency towing
Do not secure cables or chains to the suspension components.
⬛When the engine switch malfunctions (vehicles with key-free system)
Since the steering wheel cannot be unloc ked, towing by rope is not possible.
RAIZE_OM_General_BZ358E.book 376 ページ ２０２２年５月１７日　火曜日　午後１時５９分

3787-2. Steps to take in an emergency
RAIZE_OM_General_BZ358E
Fuel pump shut off system
If the engine stalls due to a strong external impact, the fuel pump
shut off system may be operating. The fuel pump shut off system is a
device that prevents secondary disasters such as fires by stopping
the supply of fuel to the engine.
Follow the procedure below to restart the engine after the system is
activated
a Turn the engine switch to “ACC” or “OFF”
b Restart the engine
WARNING
⬛Before starting the engine
Inspect the ground under the vehicle.
If you find that fuel has leaked onto th e ground, the fuel system has been dam-
aged and is in need of repair. Do not restart the engine.
RAIZE_OM_General_BZ358E.book 378 ページ ２０２２年５月１７日　火曜日　午後１時５９分