Page 36 of 699
01
1-31
Charging Status Indicator Lamp for Portable Charger
Control BoxIndicator Details
PLUG
(Green)
On : Power on
Blink : Plug temperature sensor failure
(Red)
On : Plug high temperature protection
Blink : Plug high temperature warning
POWEROn : Power on
CHARGEBlink : Charging in power saving mode, only the CHARGE indicator is illuminated.
FAULTBlink : Charging interrupted
CHARGE LEVELCharging current 12 A The charging current
changes (3 level) whenever
the button (1) is pressed
for 1 sec with the charger
plugged into an electrical
outlet but not the vehicle.
à Back of the control box
Charging current 10 ACharging current 18 A
VEHICLE
(Green)
Charging connector plugged
(Blue)
Charging
(Red)
Blink : Charging impossible
Page 37 of 699
Foreword/Starting your Hybrid/Plug-in hybrid vehicle1-32
Charging Status Indicator Lamp for Portable ChargerNO Control Box Status / Diagnosis / Countermeasure NO Control Box Status / Diagnosis / Countermeasure1
• Charging connector plugged into vehicle (Green ON)
• Plug temperature sensor failure (Green blink)
• Plug high temperature protection (Red blink)
• Plug high temperature warning (Red ON)
Contact an authorized HYUNDAI dealer. 2
- Charging connector plugged into
vehicle (Green ON)
3
- While charging • Charge indicator (Green blink)
• Vehicle indicator (Blue ON) 4
- Before plugging charging connector
into vehicle (Red blink)
• Abnormal temperature
• ICCB (In-Cable Control Box) failure
Contact an authorized HYUNDAI dealer.
Page 38 of 699
01
1-33
NO Control Box Status / Diagnosis / Countermeasure NO Control Box Status / Diagnosis / Countermeasure5
- Plugged into vehicle (Red blink)
• Diagnostic device failure
• Current leakage
• Abnormal temperature
Contact an authorized HYUNDAI dealer. 6
- After plugging charging connector into
vehicle (Red blink)
• Communication failure
Contact an authorized HYUNDAI dealer.
7
• Plug temperature sensor failure (Green blink)
• Plug high temperature protection (Red blink)
• Plug high temperature warning (Red ON)
Contact an authorized HYUNDAI dealer. 8
- Power saving mode
• 3 minutes after charging starts (Green blink)
Charging Status Indicator Lamp for Portable Charger
Page 48 of 699
01
1-43
IndicatorDetails
Error code
On : Error while charging/ Error during self-diagnosis
Error code Item Cause
E1 CP
communication Vehicle communication error
E2 Leakage Current leakage
E3 Charger error
E4 Plug temperature Plug overtemperature
warning
E5 Plug temperature failure
E6 Charger error E7 Overcurrent Charging overcurrent warning
E8 Internal
temperature Charger overheating
E9 Charger error F1 Relay fusion Charger error
F2 GM/I Poor grounding of outlet
F3 SMPS
Power failure SMPS error (voltage failure)
F4 SMPS error (abnormal
voltage)
F5 CP voltage error CP (-) voltage error
F6 CP (+) voltage error F7 Temperature
sensor error Plug temperature sensor error
F8 PCB internal temperature
sensor error
Page 130 of 699

Seats & Safety System3-28
OLMB033040
The Pre-Tensioner Seat Belt System
consists mainly of the following
components. Their locations are shown
in the illustration above:
(1) SRS air bag warning light
(2) Retractor pre-tensioner
(3) SRS control module
(4) Emergency fastening device
NOTICE
The sensor that activates the SRS
control module is connected with the
pre–tensioner seat belts. The SRS air
bag warning light on the instrument
cluster will illuminate for approximately
3~6 seconds after the Engine Start/Stop
button is in the ON position, and then it
should turn off.
If the pre-tensioner is not working
properly, the warning light will
illuminate even if the SRS air bag is not
malfunctioning. If the warning light
does not illuminate, stays illuminated
or illuminates when the vehicle is
being driven, have the pre-tensioner
seat belts and/or SRS control module
inspected by an authorized HYUNDAI
dealer as soon as possible.
Information
[ Pre-tensioner seat belts may be
activated in certain frontal or side
collisions or rollover situations (if
equipped with rollover sensor).
[ When the pre-tensioner seat belts are
activated, a loud noise may be heard
and fine dust, which may appear to be
smoke, may be visible in the passenger
compartment. These are normal
operating conditions and are not
hazardous.
[ Although it is non-toxic, the fine dust
may cause skin irritation and should
not be inhaled for prolonged periods.
Wash all exposed skin areas thoroughly
after an accident in which the pre-
tensioner seat belts were activated.
Page 147 of 699