2023 HYUNDAI SANTA FE HYBRID light

Maintenance9-60
License Plate Lamp Replacement
OTM090047
1. Using a flat-blade screwdriver, gently pry the lens cover from the lamp
housing.
2. Remove the bulb by pulling it straight out.
3. Install a new bulb.
4. Reinstall in the reverse order.
Interior Light Replacement
Map lamp (LED/Bulb type), Room
lamp (LED type)
„Map lamp (LED type)
OTMH050006N
„Map lamp (Bulb type)
OTMH050007N
„Room lamp (Personnal lamp)
OTM078014
If the map lamp (LED/Bulb) (1) and the
room lamp (LED type) (1) do not operate,
we recommend that the system be
checked by an authorized HYUNDAI
dealer.

09
9-61
Room lamp, Sunvisor lamp and
Luggage compartment lamp (Bulb
type)
„Room lamp (Personnal lamp)
OTM090048
„Sunvisor lamp
OTM090049
„Luggage compartment lamp
OTMPH091014N
1. Using a flat-head screwdriver, gently pry the lens from the interior light
housing.
2. Remove the bulb by pulling it straight out.
3. Install a new bulb into the socket.
4. Align the lens tabs with the interior light housing notches and snap the
lens into place.
NOTICE
Be careful not to damage the cover, tab,
and plastic housing.

Maintenance9-62
APPEARANCE CARE
Exterior Care
Exterior general caution
It is very important to follow the label
directions when using any chemical
cleaner or polish. Read all warning and
caution statements that appear on the
label.
Finish maintenance
Washing
To help protect your vehicle’s finish from
rus
t and deterioration, wash it thoroughly
and frequently at least once a month
with lukewarm or cold water.
If you use your vehicle for off-road
driving, you should wash it after each
off-road trip. Pay special attention to the
removal of any accumulation of salt, dirt,
mud, and other foreign materials. Make
sure the drain holes in the lower edges
of the doors and rocker panels are kept
clear and clean.
Insects, tar, tree sap, bird droppings,
industrial pollution and similar deposits
can damage your vehicle’s finish if not
removed immediately.
Even prompt washing with plain water
may not completely remove all these
deposits. A mild soap, safe for use on
painted surfaces, should be used.
After washing, rinse the vehicle
thoroughly with lukewarm or cold water.
Do not allow soap to dry on the finish.
High-pressure washing

[ When using high-pr
essure washers,
make sure to maintain sufficient
distance from the vehicle.
Insufficient clearance or excessive
pressure can lead to component
damage or water penetration.

[ Do not spray the camera, sensors or
its surrounding area directly with a
high pressure washer. Shock applied
from high pressure water may cause
the device to not operate normally.

[ Do not bring the nozzle tip close to
boots (rubber or plastic covers) or
connectors as they may be damaged
if they come into contact with high
pressure water.
WARNING
After washing the vehicle, test the
brakes while driving slowly to see
if they have been affected by water
before getting on the road. If braking
performance is impaired, dry the
brakes by applying them lightly while
maintaining a slow forward speed.
NOTICE

[Do not use strong soap, chemical
detergents or hot water, and do not
wash the vehicle in direct sunlight
or when the body of the vehicle is
warm.

[ Be careful when washing the side
windows of your vehicle.

[ Especially, with high-pressure water,
water may leak through the windows
and wet the interior.

[ To prevent damage to the plastic
parts, do not clean with chemical
solvents or strong detergents.

[ To prevent damage to the charging
door, make sure to close and lock the
vehicle doors when washing (high-
pressure washing, automatic car
washing, etc.) the vehicle.

Maintenance9-64
Finish damage repair
Deep scratches or stone chips in the
painted surface must be repaired
promptly. Exposed metal will quickly
rust and may develop into a major repair
expense.
NOTICE
If your vehicle is damaged and requires
any metal repair or replacement,
be sure the body shop applies anti-
corrosion materials to the parts
repaired or replaced.
NOTICE
Matte paint finish vehicle (if equipped)
In case of matte paint finish vehicles,
it is impossible to modify only the
damaged area and repair of the whole
part is necessary. If the vehicle is
damaged and painting is required,
we recommend that you have your
vehicle maintained and repaired by
an authorized HYUNDAI dealer. Take
extreme care, as it is difficult to restore
the quality after the repair.
Bright-metal maintenance

[ To remove road tar and insects, use
a tar remover, not a scraper or other
sharp object.

[ To protect the surfaces of brightmetal
parts from corrosion, apply a coating
of wax or chrome preservative and rub
to a high luster.

[ During winter weather or in coastal
areas, cover the bright metal parts
with a heavier coating of wax or
preservative. If necessary, coat the
parts with non-corrosive petroleum
jelly or other protective compound.
Underbody maintenance
Corrosive materials used for ice and
snow removal and dust control may
collect on the underbody. If these
materials are not removed, accelerated
rusting can occur on underbody parts
such as the fuel lines, frame, floor pan
and exhaust system, even though they
have been treated with rust protection.
Thoroughly flush the vehicle underbody
and wheel openings with lukewarm or
cold water once a month, after off-road
driving and at the end of each winter. Pay
special attention to these areas because
it is difficult to see all the mud and dirt.
It will do more harm than good to wet
down the road grime without removing
it. The lower edges of doors, rocker
panels, and frame members have drain
holes that should not be allowed to clog
with dirt; trapped water in these areas
can cause rusting.
WARNING
After washing the vehicle, test the
brakes while driving slowly to see if
they have been affected by water. If
braking performance is impaired, dry
the brakes by applying them lightly
while maintaining a slow forward
speed.
Aluminum wheel maintenance
The aluminum wheels are coated with a
clear protective finish.

Maintenance9-68

[ Caring for the leather seats
- Vacuum the seat periodically to remove dust and sand on the seat. It
will prevent abrasion or damage of
the leather and maintain its quality.
- Wipe the natural leather seat cover often with dry or soft cloth.
- Use of proper leather protector may prevent abrasion of the cover and
helps maintain the color. Be sure to
read the instructions and consult
a specialist when using leather
coating or protective agent.

- Light colored (beige, cream beige)
leather is easily contaminated and
the stain is noticeable. Clean the
seats frequently.
- Avoid wiping with wet cloth. It may cause the surface to crack.

[ Cleaning the leather seats
- Remove all contaminations instantly. Refer to instructions below
for removal of each contaminant.
- Cosmetic products (sunscreen, foundation, etc.)
Apply cleansing cream on a cloth
and wipe the contaminated spot.
Wipe off the cream with a wet cloth
and remove water with a dry cloth. - Beverages (coffee, soft drink, etc.)
Apply a small amount of neutral
detergent and wipe until
contaminations do not smear.
- Oil Remove oil instantly with
absorbable cloth and wipe with
stain remover used only for natural
leather.
- Chewing gum
Harden the gum with ice and
remove gradually.
Cleaning the seat belt webbing
Clean the belt webbing with any
mild soap solution recommended for
cleaning upholstery or carpet. Follow
the instructions provided with the soap.
Do not bleach or re-dye the webbing
because this may weaken the seat belt.
Cleaning the interior window glass
If the interior glass surfaces of the
vehicle become fogged (that is, covered
with an oily, greasy or waxy film), they
should be cleaned with glass cleaner.
Follow the directions on the glass cleaner
container.
NOTICE
Do not scrape or scratch the inside of
the rear window. This may result in
damage to the rear window defroster
grid.

09
9-69
EMISSION CONTROL SYSTEM
The emission control system of your
vehicle is covered by a written limited
warranty. Please see the warranty
information contained in the Service
Passport in your vehicle.
Your vehicle is equipped with an
emission control system to meet all
applicable emission regulations. There
are three emission control systems, as
follows.
(1) Crankcase emission control system
(2) Evaporative emission control system
(3) Exhaust emission control system
In order to ensure the proper function
of the emission control systems, it
is recommended that you have your
vehicle inspected and maintained
by an authorized HYUNDAI dealer in
accordance with the maintenance
schedule in this manual.
NOTICE
For the Inspection and Maintenance
Test (with Electronic Stability Control
(ESC) system)

[To prevent the vehicle from misfiring
during dynamometer testing, turn
the Electronic Stability Control
(ESC) system off by pressing the ESC
switch (ESC OFF light illuminated).

[ After dynamometer testing is
completed, turn the ESC system back
on by pressing the ESC switch again.
1. Crankcase Emission Control
System
The positive crankcase ventilation system
is employed to prevent air pollution
caused by blow-by gases being emitted
from the crankcase. This system supplies
fresh filtered air to the crankcase through
the air intake hose. Inside the crankcase,
the fresh air mixes with blow-by gases,
which then pass through the PCV valve
into the induction system.
2. Evaporative Emission Control System
The Evaporative Emission Control System
is designed to prevent fuel vapors from
escaping into the atmosphere.
Canister
Fuel vapors generated inside the fuel
tank are absorbed and stored in the
onboard canister. When the engine is
running, the fuel vapors absorbed in the
canister are drawn into the surge tank
through the purge control solenoid valve.
Purge Control Solenoid Valve (PCSV)
The purge control solenoid valve
is controlled by the Engine Control
Module (ECM); when the engine coolant
temperature is low during idling, the
PCSV closes so that evaporated fuel
is not taken into the engine. After the
engine warms-up during ordinary
driving, the PCSV opens to introduce
evaporated fuel to the engine.

I
I-5
Driving the Hybrid Vehicle ........................................................................\
.......... 1-10
Energy Flow ........................................................................\
............................. 1-17
Hybrid System Gauge ........................................................................\
.............. 1-12
LCD Display Messages ........................................................................\
............ 1-14
Special Features ........................................................................\
........................ 1-10
Starting the Vehicle ........................................................................\
.................. 1-10
Warning and Indicator Lights ........................................................................\
... 1-13
E
Emergency Commodity ........................................................................\
............... 8-25
Fire Extinguisher ........................................................................\
...................... 8-25
First Aid Kit ........................................................................\
.............................. 8-25
Tire Pressure Gauge ........................................................................\
................. 8-25
Triangle Reflector ........................................................................\
..................... 8-25
Emission Control System ........................................................................\
............ 9-69
Crankcase Emission Control System ............................................................... 9-69
Evaporative Emission Control System ............................................................. 9-69
Exhaust Emission Control System ................................................................... 9-70
Engine .................................................................\
................................................... 2-8
Engine Compartment ........................................................................\
............. 2-7, 9-3
Engine Coolant/Inverter Coolant ........................................................................\
. 9-18
Changing Coolant ........................................................................\
..................... 9-21
Checking the Coolant Level ........................................................................\
..... 9-18
Engine Number ........................................................................\
............................ 2-15
Engine Oil ........................................................................\
.................................... 9-16
Checking the Engine Oil and Filter .................................................................. 9-17
Checking the Engine Oil Level ........................................................................\
9-16
Explanation of Scheduled Maintenance Items .................................................... 9-14
Exterior Features ........................................................................\
.............. 5-68, 5-128
Fuel Filler Door ........................................................................\
........................ 5-78
Hood ........................................................................\
......................................... 5-68
Liftgate ........................................................................\
..................................... 5-69
Power Liftgate ........................................................................\
.......................... 5-71
Roof Side Rails.........................................................\
...................................... 5-128
Smart Liftgate ........................................................................\
........................... 5-76
Exterior Overview (I) ........................................................................\
.................... 2-2
Exterior Overview (II) ........................................................................\
................... 2-3

IndexI-8
Instrument Cluster ........................................................................\
......................... 4-4
Gauges and Meters ........................................................................\
..................... 4-5
Instrument Cluster Control ........................................................................\
......... 4-5
LCD Display Messages ........................................................................\
............ 4-23
Transmission Shift Indicator ........................................................................\
...... 4-9
Warning and Indicator Lights ........................................................................\
... 4-10
Instrument Panel Overview (I) ........................................................................\
...... 2-5
Instrument Panel Overview (II) ........................................................................\
..... 2-6
Integrated Memory System........................................................................\
.......... 5-38
Easy Access Function ........................................................................\
............... 5-40
Recalling Memory Positions ........................................................................\
.... 5-39
Resetting the System ........................................................................\
................ 5-39
Storing Memory Positions ........................................................................\
........ 5-38
Interior Features ........................................................................\
......................... 5-116
AC Inverter ........................................................................\
............................. 5-119
Ashtray ........................................................................\
................................... 5-117
Cargo Security Screen ........................................................................\
............ 5-127
Clock ........................................................................\
...................................... 5-124
Coat Hook ........................................................................\
.............................. 5-124
Cup Holder ........................................................................\
............................. 5-116
Floor Mat Anchor(s) ........................................................................\
............... 5-125
Luggage Net Holder ........................................................................\
............... 5-126
Power Outlet ........................................................................\
........................... 5-118
Side Curtain ........................................................................\
............................ 5-125
Sunvisor ........................................................................\
.................................. 5-117
USB Charger ........................................................................\
.......................... 5-119
Wireless Smart Phone Charging System ........................................................ 5-121
Interior Lights ........................................................................\
.............................. 5-90
Front Lamps ........................................................................\
............................. 5-90
Interior Lamp AUTO Cut ........................................................................\
......... 5-90
Luggage Compartment Lamp ........................................................................\
... 5-92
Puddle Lamp ........................................................................\
............................ 5-92
Rear Lamps ........................................................................\
.............................. 5-91
Vanity Mirror Lamp ........................................................................\
................. 5-91
Welcome System ........................................................................\
...................... 5-93
Interior Overview........................................................................\
........................... 2-4