2023 HYUNDAI I20 engine
[x] Cancel search: enginePage 117 of 649
4-22
Instrument cluster
Shift to N to start engine
(for smart key system and
Automatic transmission/Dual clutch
transmission)
This warning message is displayed if
you try to start the engine with the shift
button not in the N (Neutral) position.
i Information
< R X F D Q V W D U W W K H H Q J L Q H Z L W K W K H V K L I W
O H Y H U L Q W K H 1 1 H X W U D O S R V L W L R Q
Check BRAKE SWITCH fuse (for
smart key system and Automatic
transmission/Dual clutch
transmission)
This warning message is displayed if the
brake switch fuse is disconnected.
You need to replace the fuse with a new
one. If that is not possible, you can start
the engine by pressing the Engine Start/
Stop button for 10 seconds in the ACC
position.
Door, Bonnet, Tailgate open
indicator
OBC3040012
This warning is displayed if any door
or bonnet or tailgate is left open. The
warning will indicate which door is open
in the display.
CAUTION
Before driving the vehicle, you should
confirm that the door/bonnet/tailgate
is fully closed. Also, check there is no
door/bonnet/tailgate open warning
light or message displayed on the
instrument cluster.
Page 119 of 649
4-24
Instrument cluster
Low engine oil (if equipped)
This warning message is displayed when
the engine oil level should be checked.
If this warning message is displayed,
check the engine oil level as soon as
possible and add engine oil as required.
Slowly pour the recommended oil little
by little into a funnel.
Use only the specified engine oil. (Refer
to "Recommended lubricants and
capacities" section in chapter 2.)
Do not overfill the engine oil. Make sure
the oil level is not above F (Full) mark on
the dipstick.
NOTICE
If the message is displayed
continuously after adding the engine
oil and travelling approximately 31~
62 mile (50~100 km) after the engine
warms up, we recommend that the
system be checked by a HYUNDAI
authorised repairer.
Engine has overheated
(if equipped)
This warning message is displayed
when the engine coolant temperature
is above 120°C (248°F). This means that
the engine is overheated and may be
damaged.
If your vehicle is overheated, refer to
“Overheating” section in chapter 8.
Check headlight (if equipped)
This warning message is displayed if the
headlamps are not operating properly.
In addition, if a specific lamp(turn signal
lamp etc.) is not operating properly, the
warning message according to a specific
lamp (turn signal lamp etc.) is displayed.
A corresponding bulb may need to be
replaced.
Make sure to replace the burned out
bulb with a new one of the same
wattage rating.
Check brake light (if equipped)
This warning message is displayed if the
stop lamps are not operating properly. A
lamp may need to be replaced.
Make sure to replace the burned out
bulb with a new one of the same
wattage rating.
Check Active Air Flap system (if
equipped)
This message is displayed in the
following situations:
- There is a malfunction with the
actuator flap
- There is a malfunction with the
actuator air flap controller
- The air flap does not open
When all of the above conditions are
fixed, the warning will disappear.
Page 128 of 649
4-33
04
' R R U
ItemsExplanation
Automatically
lock[ ( Q D E O H R Q 6 K L I W $ O O G R R U V Z L O O E H D X W R P D W L F D O O \ O R F N H G L I W K H V K L I W
button is shifted from the P (Park) position to the R (Reverse), N
(Neutral), or D (Drive) position. (only when the engine is running.)
[ ( Q D E O H R Q 6 S H H G $ O O G R R U V Z L O O E H D X W R P D W L F D O O \ O R F N H G Z K H Q W K H
vehicle speed exceeds 9.3mph (15km/h).
[ 2 I I 7 K H D X W R G R R U O R F N R S H U D W L R Q Z L O O E H G H D F W L Y D W H G
Automatically
unlock[ 2 Q 6 K L I W W R 3 $ O O G R R U V Z L O O E H D X W R P D W L F D O O \ X Q O R F N H G L I W K H V K L I W
button is shifted to the P (Park) position. (only when the engine is
running.)
[ 2 Q N H \ R X W 2 Q Y H K L F O H R I I $ O O G R R U V Z L O O E H D X W R P D W L F D O O \ X Q O R F N H G
when the ignition key is removed from the ignition switch or the
Engine Start/Stop button is set to the OFF position.
[ 2 I I 7 K H D X W R G R R U X Q O R F N R S H U D W L R Q Z L O O E H F D Q F H O O H G
& R Q Y H Q L H Q F H
ItemsExplanation
Rear occupant
alertTo activate or deactivate the Rear Occupant Alert.
For more details, refer to "Rear Occupant Alert (ROA) system" in
chapter 5.
Welcome mirror[ 2 Q G R R U X Q O R F N 7 K H R X W V L G H U H D U Y L H Z P L U U R U V D U H X Q I R O G H G
automatically when the doors are unlocked.
[ 2 Q G U L Y H U D S S U R D F K 7 K H R X W V L G H U H D U Y L H Z P L U U R U V D U H X Q I R O G H G
automatically when the vehicle is approached with the smart key.
For more details, refer to ''Welcome System'' in chapter 5.
Wireless
charging systemTo activate or deactivate the wireless charging system in the front seat.
For more details, refer to "Wireless cellular phone charging system" in
chapter 5.
Auto rear wiper
(in R)To activate or deactivate the Auto Rear Wiper function.If you move the
shift button from D to R when the front wiper operates, the rear wiper
will operate automatically. Then, if you move the shift button from R to
D, the rear wiper will stop.
Advanced anti-
theftTo activate or deactivate the Advanced Anti-Theft function.
Vehicle auto-
shut OffTo activate or deactivate the Vehicle Auto-Shut Off function.
Service interval[ 6 H U Y L F H L Q W H U Y D O
To activate or deactivate the service interval function.
[ $ G M X V W L Q W H U Y D O
If the service interval menu is activated, you may adjust the time and
distance.
[ 5 H V H W
To reset the service interval.
❈ The information provided may differ depending on which functions are applicable
to your vehicle.
Page 132 of 649
![HYUNDAI I20 2023 Owners Manual 4-37
04
Manual reset
To clear the average fuel economy
manually, press the [OK] button on the
steering wheel for more than 1 second
when the average fuel economy is
displayed.
Automatic reset
To a](/manual-img/35/56129/w960_56129-131.png "HYUNDAI I20 2023 Owners Manual 4-37
04
Manual reset
To clear the average fuel economy
manually, press the [OK] button on the
steering wheel for more than 1 second
when the average fuel economy is
displayed.
Automatic reset
To a")
4-37
04
Manual reset
To clear the average fuel economy
manually, press the [OK] button on the
steering wheel for more than 1 second
when the average fuel economy is
displayed.
Automatic reset
To automatically reset the average fuel
economy after refuelling, select the
"Fuel Econ. Reset" mode in the User
Settings menu on the LCD display.
- After ignition: the average fuel
economy will reset automatically
whenever it has passed 4 hours after
turning OFF the engine.
- After refuelling: the average fuel
economy will reset automatically
when driving speed exceeds 1 mph
(1 km/h), after adding 6 litres (1.6
gallons) of fuel or more.
i Information
7 K H D Y H U D J H I X H O H F R Q R P \ P D \ E H
L Q D F F X U D W H Z K H Q W K H Y H K L F O H G U L Y H V
V K R U W H U W K D Q P L O H V P H W H U V D I W H U
W X U Q L Q J 2 1 W K H ( Q J L Q H 6 W D U W 6 W R S E X W W R Q
Instant Fuel Economy (2)
[ This mode displays the instant fuel
economy during the last few seconds
when the vehicle speed is more than
6.2 mph (10 km/h).
Accumulated Info display
„Type A
OJX1040012E
„Type B
OJX1040067E
This display shows the accumulated trip
distance (1), the average fuel economy
(2), and the total driving time (3).
Page 133 of 649
4-38
Instrument cluster
The information is accumulated starting
from the last reset.
To manually reset the information, press
and hold the OK button when viewing
the accumulated driving info. The trip
distance, the average fuel economy,
and total driving time will reset
simultaneously.
The accumulated driving information
will continue to be counted whilst the
engine is still running (for example,
when the vehicle is in traffic or stopped
at a stop light).
i Information
7 K H Y H K L F O H P X V W E H G U L Y H Q I R U D
P L Q L P X P R I P H W H U V P L O H V
V L Q F H W K H O D V W L J Q L W L R Q N H \ F \ F O H Z L O O E H
U H F D O F X O D W H G
Drive Info display
„Type A
OJX1040011E
„Type B
OJX1040065E
This display shows the accumulated trip
distance (1), the average fuel economy
(2), and the total driving time (3).
Page 134 of 649
4-39
04
The information is combined for each
ignition cycle. However, when the
engine has been OFF for 4 hours or
longer the Drive Info screen will reset.
To manually reset the information, press
and hold the OK button when viewing
the Drive Info. The trip distance, the
average fuel economy, and total driving
time will reset simultaneously.
The driving information will continue
to be counted whilst the engine is still
running (for example, when the vehicle
is in traffic or stopped at a stop light.)
i Information
7 K H Y H K L F O H P X V W E H G U L Y H Q I R U D
P L Q L P X P R I P H W H U V P L O H V
V L Q F H W K H O D V W L J Q L W L R Q N H \ F \ F O H Z L O O E H
U H F D O F X O D W H G
Digital speedometer
OJX1040018E
This message shows the speed of the
vehicle (km/h, MPH).
OJX1069044
$ X W R V W R S L I H T X L S S H G
AUTO STOP display shows the elapsed
time of engine stop by Idle Stop and Go
system.
For more details, refer to “Idle Stop and
Go (ISG)” section in chapter 6.
Page 137 of 649
![HYUNDAI I20 2023 Owners Manual 4-42
Instrument cluster
Utility view
In the Utility view, using the , (UP,
DOWN) switch, you may change through
items in the following order.
OBC3040035R
) X H O H F R Q R P \
Average fuel eco](/manual-img/35/56129/w960_56129-136.png "HYUNDAI I20 2023 Owners Manual 4-42
Instrument cluster
Utility view
In the Utility view, using the , (UP,
DOWN) switch, you may change through
items in the following order.
OBC3040035R
) X H O H F R Q R P \
Average fuel eco")
4-42
Instrument cluster
Utility view
In the Utility view, using the , (UP,
DOWN) switch, you may change through
items in the following order.
OBC3040035R
) X H O H F R Q R P \
Average fuel economy (1) and instant
fuel economy (2) are displayed.
[ Manual reset
To clear the average fuel economy
manually, press the OK switch on the
steering wheel for more than 1 second
when the Average Fuel Economy is
displayed.
[ Automatic reset
To automatically reset the average
fuel economy, select between ‘After
Ignition’ or ‘After Refuelling’ from the
Settings menu in the infotainment
system.
- After Ignition: when the engine has
been OFF for 4 hours or longer the
average fuel economy will reset
automatically.
- After Refuelling: the average fuel
economy will reset automatically
after adding 6 litres (1.6 gallons) of
fuel or more and after driving speed
exceeds 1 mph (1 km/h).
„Type A
OJX1040012E/OJX1040067E
„Type B
' U L Y H L Q I R
Trip distance (1), average fuel economy
(2), and total driving time (3) are
displayed.
The information is combined for each
ignition cycle. However, when the
engine has been OFF for 4 hours or
longer the Drive Info screen will reset.
To reset manually, press the OK switch
on the steering wheel for more than 1
second when ‘Drive Info’ is displayed.
„Type A
OJX1040013E/OJX1040066E
„Type B
6 L Q F H U H I X H O O L Q J
Trip distance (1), average fuel economy
(2), and total driving time (3) after the
vehicle has been refueled are displayed.
To reset manually, press the OK switch
on the steering wheel for more than
1 second when ‘Since Refuelling’ is
displayed.
Page 138 of 649
4-43
04
„Type A
OJX1040012E/OJX1040067E
„Type B
$ F F X P X O D W H G L Q I R
Accumulated trip distance (1), average
fuel economy (2), and total driving time
(3) are displayed.
The information is accumulated starting
from the last reset.
To reset manually, press the OK switch
on the steering wheel for more than
1 second when ‘Accumulated Info’ is
displayed.
OJX1040018E
' L J L W D O V S H H G R P H W H U
Digital speedometer display shows the
speed of the vehicle.
OBC3070068
$ W W H Q W L R Q O H Y H O L I H T X L S S H G
The driver’s attention level is shown
based on the driver’s driving pattern.
For more details, refer to "Driver
Attention Warning (DAW)“ section in
chapter 7.
OJX1069044
$ X W R V W R S L I H T X L S S H G
AUTO STOP display shows the elapsed
time of engine stop by Idle Stop and Go
system.
For more details, refer to “Idle Stop and
Go (ISG)” section in chapter 6.