2023 HYUNDAI I20 start stop button

6-52
Driving your vehicle
Conventional MT vehicle (not MHEV or
not equipped with LATE Restart) is able
to restart engine, only in Neutral gear.
If you select a gear, without depressing
clutch pedal fully, then warning will be
displayed with beep. You should restart
the engine in Neutral gear position.
Unintentionally, when the engine is
turned off or the vehicle is moving, if the
gear is engaged and the clutch pedal
is not pressed, the system displays the
warning message as shown below. At
this time, if the driver presses the clutch
pedal all the way, the engine restarts
automatically. (Only with Late Restart
equipped ISG system, except MHEV)
OPDE050564L
ISG malfunction
The system may not operate when:
OBC3060009
The ISG related sensors or system error
occurs.
The yellow AUTO STOP indicator
(
) on the instrument cluster will
stay on after blinking for 5 seconds and
the light on the ISG OFF button will
illuminate.
NOTICE

[ ,IWKH,6*2))EXWWRQOLJKWLVQRW
turned off by pressing the ISG OFF
button again or if the ISG system
continuously does not work correctly,
have your vehicle inspected by a
professional workshop as soon as
possible. Hyundai recommends
to contact a HYUNDAI authorised
repairer.

[ :KHQWKH,6*2))EXWWRQOLJKWFRPHV
on, it may stop illuminating after
driving your vehicle at approximately
50 mph (80 km/h) for a maximum
of two hours and setting the fan
speed control knob below the 2nd
position. If the ISG OFF button light
continues to be illuminated in spite
of the procedure, have your vehicle
inspected by a professional workshop
as soon as possible. Hyundai
recommends to contact a HYUNDAI
authorised repairer.

Driver assistance system
7-32
„Type A
OTM070141L
„Type B
ONX4E070090
Warning volume
With the Engine Start/Stop button in the
ON position, select ‘Driver Assistance

07
7-61
Safe Exit Warning settings
Setting features
OCN7070042L
Safe Exit Warning
With the Engine Start/Stop button in the
21SRVLWLRQVHOHFW
S'ULYHU$VVLVWDQFH

07
7-71
Speed Limit Offset
With the Engine Start/Stop button in the
ON position, when ‘Driver assistance

8-4
Emergency situations
IN CASE OF AN EMERGENCY WHILST DRIVING
If the engine stalls whilst driving

[Reduce your speed gradually, keeping
a straight line. Move cautiously off the
road to a safe place.

[Turn on your hazard warning flasher.

[Try to start the engine again. If your
vehicle will not start, we recommend
that you contact a HYUNDAI
authorised repairer.
If the engine stalls at a
crossroad or crossing
If the engine stalls at a crossroads or
crossing, if safe to do so, move the shift
lever to the N (Neutral) position and then
push the vehicle to a safe location.
If you have a flat tyre whilst
driving
If a tyre goes flat whilst you are driving:

[Take your foot off the accelerator
pedal and let the vehicle slow down
whilst driving straight ahead. Do
not apply the brakes immediately or
attempt to pull off the road as this
may cause loss of vehicle control
resulting in an accident. When the
vehicle has slowed to such a speed
that it is safe to do so, brake carefully
and pull off the road. Drive off the
road as far as possible and park on
firm, level ground. If you are on a
divided highway, do not park in the
median area between the two traffic
lanes.

[When the vehicle is stopped, press
the hazard warning flasher button,
move the shift lever into P (Park, for
automatic transmission/dual clutch
transmission vehicle) or neutral
(for manual transmission vehicle),
apply the parking brake, and place
the ignition switch in the LOCK/OFF
position.

[Have all passengers get out of the
vehicle. Be sure they all get out on the
side of the vehicle that is away from
traffic.

[When changing a flat tyre, follow
the instructions provided later in this
chapter.

8-12
Emergency situations
Tyre pressure monitoring
system
WARNING
Over-inflation or under-inflation can
reduce tyre life, adversely affect
vehicle handling, and lead to sudden
tyre failure that may cause loss of
vehicle control resulting in an accident.
Each tyre, including the spare (if
provided), should be checked monthly
when cold and inflated to the inflation
pressure recommended by the vehicle
manufacturer on the vehicle placard
or tyre inflation pressure label. (If your
vehicle has tyres of a different size
than the size indicated on the vehicle
placard or tyre inflation pressure label,
you should determine the proper tyre
inflation pressure for those tyres.)
As an added safety feature, your
vehicle has been equipped with a tyre
pressure monitoring system (TPMS)
that illuminates a low tyre pressure
telltale when one or more of your
tyres is significantly under-inflated.
Accordingly, when the low tyre pressure
telltale illuminates, you should stop and
check your tyres as soon as possible,
and inflate them to the proper pressure.
Driving on a significantly under-inflated
tyre causes the tyre to overheat and can
lead to tyre failure.
Under-inflation also reduces fuel
efficiency and tyre tread life, and
may affect the vehicle’s handling and
stopping ability.
Please note that the TPMS is not a
substitute for proper tyre maintenance,
and it is the driver’s responsibility to
maintain correct tyre pressure, even if
under-inflation has not reached the level
to trigger illumination of the TPMS low
tyre pressure telltale.
Your vehicle has also been equipped
with a TPMS malfunction indicator
to indicate when the system is
not operating properly. The TPMS
malfunction indicator is combined with
the low tyre pressure telltale. When
the system detects a malfunction, the
telltale will flash for approximately one
minute and then remain continuously
illuminated. This sequence will continue
upon subsequent vehicle start-ups as
long as the malfunction exists.
When the malfunction indicator is
illuminated, the system may not be able
to detect or signal low tyre pressure as
intended. TPMS malfunctions may occur
for a variety of reasons, including the
installation of replacement or alternate
tyres or wheels on the vehicle that
prevent the TPMS from functioning
properly.
Always check the TPMS malfunction
telltale after replacing one or more tyres
or wheels on your vehicle to ensure that
the replacement or alternate tyres and
wheels allow the TPMS to continue to
function properly.
NOTICE
If any of the below happens, we
recommend that you have the system
checked by a HYUNDAI authorised
repairer.
1. The Low Tyre Pressure Telltale/
TPMS Malfunction Indicator does not
illuminate for 3 seconds when the
Engine Start/Stop button is pressed
to the ON position or when the
engine is running.
2. The TPMS Malfunction Indicator
remains illuminated after blinking for
approximately 1 minute.
3. The Low Tyre Pressure Position
Telltale remains illuminated.

8-30
Emergency situations
ODN8079020
5. Insert the sealant bottle into the
housing (5) of the compressor so that
the bottle is upright.
6. Ensure that the compressor is
switched off, position 0.
OBC3080011
NOTICE
Securely install the sealant filling hose
to the valve. If not, sealant may flow
backward, possibly clogging the filling
hose.
OBC3N080005
7. Connect between compressor and the
vehicle power outlet using the cable
and connectors (4).
8. With the engine start/stop button
position on or ignition switch position
on, switch on the compressor and let
it run for approximately 5~7 minutes to
fill the sealant up to proper pressure.
(refer to immediately chapter 2).
The inflation pressure of the tyre
immediately filling is unimportant and
will be checked/corrected later.
Be careful not to overinflate the tyre
and stay away from the tyre whilst
filling it.
NOTICE
- Tyre pressure
Do not attempt to drive your vehicle
if the tyre pressure is below 29
PSI(200kpa). This could result in an
accident due to sudden tyre failure.
9. Switch off the compressor.
10. Detach the hoses from the sealant
bottle connector and from the tyre
valve.
Return the Tyre Mobility Kit to its storage
location in the vehicle.

9-29
09
WARNING
To prevent SERIOUS INJURY or DEATH
to you or bystanders, always follow
these precautions when working near
or handling the battery:
Always read and follow
instructions carefully when
handling a battery.
Wear eye protection designed
to protect the eyes from acid
splashes.
Keep all flames, sparks, or
smoking materials away from
the battery.
Hydrogen is always present in
battery cells, is highly
combustible, and may explode
if ignited.
%DWWHULHVFRQWDLQVXOIXULFDFLG
which is highly corrosive. Do
not allow acid to contact your
eyes, skin or clothing.
If acid gets into your eyes, flush your
eyes with clean water for at least 15
minutes and get immediate medical
attention. If acid gets on your skin,
thoroughly wash the area. If you
feel pain or a burning sensation, get
medical attention immediately.

[When lifting a plastic-cased battery,
excessive pressure on the case may
cause battery acid to leak. Lift with a
battery carrier or with your hands on
opposite corners.

[Do not attempt to jump start your
vehicle if your battery is frozen.

[NEVER attempt to recharge the
battery when the vehicle’s battery
cables are connected to the battery.

[The electrical ignition system works
with high voltage. NEVER touch these
components with the engine running
or when the Engine Start/Stop button
is in the ON position.

[Do not allow the (+) and (-) jumper
cables to touch. It may cause sparks.

[The battery may rupture or explode
when you jump start with a low or
frozen battery.

[Leaked battery electrolyte due to
repeated driving on sharp curves
(e.g. on circuits) may cause safety
problem. Avoid repeated driving on
sharp curves.
NOTICE
If you connect unauthorised electronic
devices to the battery, the battery may
be discharged. Never use unauthorised
devices.
%$77(5<