2023 HYUNDAI I20 Stop and go
[x] Cancel search: Stop and goPage 119 of 649
4-24
Instrument cluster
Low engine oil (if equipped)
This warning message is displayed when
the engine oil level should be checked.
If this warning message is displayed,
check the engine oil level as soon as
possible and add engine oil as required.
Slowly pour the recommended oil little
by little into a funnel.
Use only the specified engine oil. (Refer
to "Recommended lubricants and
capacities" section in chapter 2.)
Do not overfill the engine oil. Make sure
the oil level is not above F (Full) mark on
the dipstick.
NOTICE
If the message is displayed
continuously after adding the engine
oil and travelling approximately 31~
62 mile (50~100 km) after the engine
warms up, we recommend that the
system be checked by a HYUNDAI
authorised repairer.
Engine has overheated
(if equipped)
This warning message is displayed
when the engine coolant temperature
is above 120°C (248°F). This means that
the engine is overheated and may be
damaged.
If your vehicle is overheated, refer to
“Overheating” section in chapter 8.
Check headlight (if equipped)
This warning message is displayed if the
headlamps are not operating properly.
In addition, if a specific lamp(turn signal
lamp etc.) is not operating properly, the
warning message according to a specific
lamp (turn signal lamp etc.) is displayed.
A corresponding bulb may need to be
replaced.
Make sure to replace the burned out
bulb with a new one of the same
wattage rating.
Check brake light (if equipped)
This warning message is displayed if the
stop lamps are not operating properly. A
lamp may need to be replaced.
Make sure to replace the burned out
bulb with a new one of the same
wattage rating.
Check Active Air Flap system (if
equipped)
This message is displayed in the
following situations:
- There is a malfunction with the
actuator flap
- There is a malfunction with the
actuator air flap controller
- The air flap does not open
When all of the above conditions are
fixed, the warning will disappear.
Page 128 of 649
4-33
04
' R R U
ItemsExplanation
Automatically
lock[ ( Q D E O H R Q 6 K L I W $ O O G R R U V Z L O O E H D X W R P D W L F D O O \ O R F N H G L I W K H V K L I W
button is shifted from the P (Park) position to the R (Reverse), N
(Neutral), or D (Drive) position. (only when the engine is running.)
[ ( Q D E O H R Q 6 S H H G $ O O G R R U V Z L O O E H D X W R P D W L F D O O \ O R F N H G Z K H Q W K H
vehicle speed exceeds 9.3mph (15km/h).
[ 2 I I 7 K H D X W R G R R U O R F N R S H U D W L R Q Z L O O E H G H D F W L Y D W H G
Automatically
unlock[ 2 Q 6 K L I W W R 3 $ O O G R R U V Z L O O E H D X W R P D W L F D O O \ X Q O R F N H G L I W K H V K L I W
button is shifted to the P (Park) position. (only when the engine is
running.)
[ 2 Q N H \ R X W 2 Q Y H K L F O H R I I $ O O G R R U V Z L O O E H D X W R P D W L F D O O \ X Q O R F N H G
when the ignition key is removed from the ignition switch or the
Engine Start/Stop button is set to the OFF position.
[ 2 I I 7 K H D X W R G R R U X Q O R F N R S H U D W L R Q Z L O O E H F D Q F H O O H G
& R Q Y H Q L H Q F H
ItemsExplanation
Rear occupant
alertTo activate or deactivate the Rear Occupant Alert.
For more details, refer to "Rear Occupant Alert (ROA) system" in
chapter 5.
Welcome mirror[ 2 Q G R R U X Q O R F N 7 K H R X W V L G H U H D U Y L H Z P L U U R U V D U H X Q I R O G H G
automatically when the doors are unlocked.
[ 2 Q G U L Y H U D S S U R D F K 7 K H R X W V L G H U H D U Y L H Z P L U U R U V D U H X Q I R O G H G
automatically when the vehicle is approached with the smart key.
For more details, refer to ''Welcome System'' in chapter 5.
Wireless
charging systemTo activate or deactivate the wireless charging system in the front seat.
For more details, refer to "Wireless cellular phone charging system" in
chapter 5.
Auto rear wiper
(in R)To activate or deactivate the Auto Rear Wiper function.If you move the
shift button from D to R when the front wiper operates, the rear wiper
will operate automatically. Then, if you move the shift button from R to
D, the rear wiper will stop.
Advanced anti-
theftTo activate or deactivate the Advanced Anti-Theft function.
Vehicle auto-
shut OffTo activate or deactivate the Vehicle Auto-Shut Off function.
Service interval[ 6 H U Y L F H L Q W H U Y D O
To activate or deactivate the service interval function.
[ $ G M X V W L Q W H U Y D O
If the service interval menu is activated, you may adjust the time and
distance.
[ 5 H V H W
To reset the service interval.
❈ The information provided may differ depending on which functions are applicable
to your vehicle.
Page 131 of 649
4-36
Instrument cluster
Trip computer
The trip computer is a microcomputer-
controlled driver information system that
displays information related to driving.
i Information
6 R P H G U L Y L Q J L Q I R U P D W L R Q V W R U H G L Q W K H
W U L S F R P S X W H U I R U H [ D P S O H $ Y H U D J H
9 H K L F O H 6 S H H G U H V H W V L I W K H E D W W H U \ L V
G L V F R Q Q H F W H G
Trip modes
Fuel Economy
[ Average Fuel Economy
[ Instant Fuel Economy
Accumulated Info
[ Tripmeter
[ Average Fuel Economy
[ Elapsed Time
Drive Info
[ Tripmeter
[ Average Fuel Economy
[ Elapsed Time
Auto Stop (if equipped)
Digital Speedometer
OBC3050050
To change the trip mode, toggle the
", " switch on the steering wheel.
Fuel economy
OIK047124N
$ Y H U D J H ) X H O ( F R Q R P \
[ The average fuel economy is
calculated by the total driving distance
and fuel consumption since the last
average fuel economy reset.
[ The average fuel economy can be
reset both manually and automatically.
Page 133 of 649
4-38
Instrument cluster
The information is accumulated starting
from the last reset.
To manually reset the information, press
and hold the OK button when viewing
the accumulated driving info. The trip
distance, the average fuel economy,
and total driving time will reset
simultaneously.
The accumulated driving information
will continue to be counted whilst the
engine is still running (for example,
when the vehicle is in traffic or stopped
at a stop light).
i Information
7 K H Y H K L F O H P X V W E H G U L Y H Q I R U D
P L Q L P X P R I P H W H U V P L O H V
V L Q F H W K H O D V W L J Q L W L R Q N H \ F \ F O H Z L O O E H
U H F D O F X O D W H G
Drive Info display
„Type A
OJX1040011E
„Type B
OJX1040065E
This display shows the accumulated trip
distance (1), the average fuel economy
(2), and the total driving time (3).
Page 134 of 649
4-39
04
The information is combined for each
ignition cycle. However, when the
engine has been OFF for 4 hours or
longer the Drive Info screen will reset.
To manually reset the information, press
and hold the OK button when viewing
the Drive Info. The trip distance, the
average fuel economy, and total driving
time will reset simultaneously.
The driving information will continue
to be counted whilst the engine is still
running (for example, when the vehicle
is in traffic or stopped at a stop light.)
i Information
7 K H Y H K L F O H P X V W E H G U L Y H Q I R U D
P L Q L P X P R I P H W H U V P L O H V
V L Q F H W K H O D V W L J Q L W L R Q N H \ F \ F O H Z L O O E H
U H F D O F X O D W H G
Digital speedometer
OJX1040018E
This message shows the speed of the
vehicle (km/h, MPH).
OJX1069044
$ X W R V W R S L I H T X L S S H G
AUTO STOP display shows the elapsed
time of engine stop by Idle Stop and Go
system.
For more details, refer to “Idle Stop and
Go (ISG)” section in chapter 6.
Page 138 of 649
4-43
04
„Type A
OJX1040012E/OJX1040067E
„Type B
$ F F X P X O D W H G L Q I R
Accumulated trip distance (1), average
fuel economy (2), and total driving time
(3) are displayed.
The information is accumulated starting
from the last reset.
To reset manually, press the OK switch
on the steering wheel for more than
1 second when ‘Accumulated Info’ is
displayed.
OJX1040018E
' L J L W D O V S H H G R P H W H U
Digital speedometer display shows the
speed of the vehicle.
OBC3070068
$ W W H Q W L R Q O H Y H O L I H T X L S S H G
The driver’s attention level is shown
based on the driver’s driving pattern.
For more details, refer to "Driver
Attention Warning (DAW)“ section in
chapter 7.
OJX1069044
$ X W R V W R S L I H T X L S S H G
AUTO STOP display shows the elapsed
time of engine stop by Idle Stop and Go
system.
For more details, refer to “Idle Stop and
Go (ISG)” section in chapter 6.
Page 151 of 649
5-10
Convenient features
Start-up
You can start the engine without
inserting the key. For detailed
information, refer to the Engine Start/
Stop button in chapter 6.
NOTICE
To prevent damaging the smart key:
[ . H H S W K H V P D U W N H \ D Z D \ I U R P Z D W H U
or any liquid and fire. If the inside
of the smart key gets damp (due to
drinks or moisture), or is heated,
internal circuit may malfunction,
excluding the car from the warranty.
[ $ Y R L G G U R S S L Q J R U W K U R Z L Q J W K H
smart key.
[ 3 U R W H F W W K H V P D U W N H \ I U R P H [ W U H P H
temperatures.
NOTICE
Always have the smart key with you
when leaving the vehicle. If the smart
key is left near the vehicle, the vehicle
battery may be discharged.
Mechanical key
If the Smart Key does not operate
normally, you can lock or unlock the
door by using the mechanical key.
OIB044175E
Press and hold the release button (1) and
remove the mechanical key (2). Insert
the mechanical key into the key hole on
the door.
To reinstall the mechanical key, put the
key into the hole and push it until a click
sound is heard.
Loss of a smart key
A maximum of two smart keys can
be registered to a single vehicle. If
you happen to lose your smart key,
it is recommended that you should
immediately take the vehicle and
remaining key to your a HYUNDAI
authorised repairer or tow the vehicle, if
necessary.
Page 170 of 649
5-29
05
To reset the power windows
If the power windows do not operate
normally, the automatic power window
system must be reset as follows:
1. Place the ignition switch to the ON
position.
2. Close the window and continue pulling
up on the power window switch for at
least one second.
If the power windows do not
operate properly after resetting, it
is recommended that the system be
checked by a HYUNDAI authorised
repairer.
WARNING
The automatic reverse feature doesn’t
activate whilst resetting power window
system. Make sure body parts or other
objects are safely out of the way before
closing the windows to avoid injuries or
vehicle damage.
Automatic reverse (if equipped)
OLF044032
If a window senses any obstacle whilst it
is closing automatically, it will stop and
lower approximately 30 cm (12 inches) to
allow the object to be cleared.
If the window detects the resistance
whilst the power window switch is
pulled up continuously, the window
will stop upward movement then lower
approximately 2.5 cm (1 inch).
If the power window switch is pulled
up continuously again within 5 seconds
after the window is lowered by the
automatic window reverse feature,
the automatic window reverse will not
operate.
i Information
7 K H D X W R P D W L F U H Y H U V H I H D W X U H L V R Q O \
D F W L Y H Z K H Q W K H