2023 HYUNDAI I20 media
[x] Cancel search: mediaPage 276 of 649
6-3
06
WARNING
Carbon monoxide (CO) gas is toxic. Breathing CO can cause unconsciousness and
death.
Engine exhaust contains carbon monoxide which cannot be seen or smelled.
Do not inhale engine exhaust.
If at any time you smell engine exhaust inside the vehicle, open the windows
immediately. Exposure to CO can cause unconsciousness and death by asphyxiation.
Be sure the exhaust system does not leak.
The exhaust system should be checked whenever the vehicle is raised to change the
oil or for any other purpose. If you hear a change in the sound of the exhaust or if you
drive over something that strikes the underneath side of the vehicle, we recommend
that the exhaust system be checked as soon as possible by a HYUNDAI authorised
repairer.
Do not run the engine in an enclosed area.
Letting the engine idle in your garage, even with the garage door open, is a hazardous
practice. Run the engine only long enough to start the engine and to move the vehicle
out of the garage.
Avoid idling the engine for prolonged periods with people inside the vehicle.
If it is necessary to idle the engine for a prolonged period with people inside the
vehicle, be sure to do so only in an open area with the air intake set at “Fresh” and fan
control set to high so fresh air is drawn into the interior.
Keep the air intakes clear.
To assure proper operation of the ventilation system, keep the ventilation air intakes
located in front of the windscreen clear of snow, ice, leaves, or other obstructions.
If you must drive with the tailgate open:
Close all windows.
Open instrument panel air vents.
Set the air intake control at “Fresh”, the air flow control at “Floor” or “Face”, and the
fan control set to high.
Page 290 of 649
6-17
06
The transmission is fully synchronized
in all forward gears so shifting to
either a higher or a lower gear is easily
accomplished. Depress the clutch pedal
down fully whilst shifting, then release it
slowly.
If your vehicle is equipped with an
ignition lock switch, the engine will not
start when starting the engine without
depressing the brake pedal and clutch
pedal. (if equipped)
The shift lever must be returned to the
neutral position before shifting into
R (Reverse). Push the button located
immediately below the shift knob
and pull the gearshift lever to the left
sufficiently, and then shift into reverse
(R) gear position. Make sure the vehicle
is completely stopped before shifting
into R (Reverse).
Never operate the engine with the
tachometer (rpm) in the red zone. CAUTION
[ When downshifting from fifth gear
to fourth gear, caution should be
taken not to inadvertently press the
shift lever sideways in such a manner
that the second gear is engaged.
Such a drastic downshift may cause
the engine speed to increase to the
point that the tachometer will enter
the red-zone. Such overrevving of
the engine and transmission may
possibly cause engine damage.
[ Do not downshift more than 2 gears
or downshift the gear when the
engine is running at high speed
(5,000 RPM or higher). Such a
downshifting may damage the
engine, clutch and the transmission.
[ During cold weather, shifting may
be difficult until the transmission
lubricant is warmed up. This is
normal and not harmful to the
transmission.
[ If you’ve come to a complete stop
and it’s hard to shift into the 1st gear
or R(Reverse), leave the shift lever at
N(Neutral) position and release the
clutch. Press the clutch pedal back
down, and then shift into the 1st gear
or R(Reverse) gear position.
Page 296 of 649
6-23
06
Shift-lock system
For your safety, the automatic
transmission has a shift-lock system
which prevents shifting the transmission
from P (Park) into R (Reverse) unless the
brake pedal is depressed.
To shift the transmission from P (Park)
into R (Reverse):
1. Depress and hold the brake pedal.
2. Start the engine or place the ignition
switch in the ON position.
3. Move the shift lever.
Shift-lock release
If the shift lever cannot be moved from
the P (Park) position into R (Reverse)
position with the brake pedal depressed,
continue depressing the brake, and then
do the following:
OBC3060003R
1. Place the ignition switch in the LOCK/
OFF position.
2. Apply the parking brake.
3. Press the shift-lock release button.
4. Press and hold the lock release button
on the shift lever.
5. Move the shift lever.
If you need to use the shift-lock release,
we recommend that the system be
inspected by a HYUNDAI authorised
repairer immediately.
Page 306 of 649
6-33
06
Shift-lock release
If the shift lever cannot be moved from
the P (Park) position into R (Reverse)
position with the brake pedal depressed,
continue depressing the brake, and then
do the following:
OBC3060003R
1. Place the ignition switch in the LOCK/
OFF position.
2. Apply the parking brake.
3. Press the shift-lock release button.
4. Press and hold the lock release button
on the shift lever.
5. Move the shift lever.
If you need to use the shift-lock release,
we recommend that the system be
inspected by a HYUNDAI authorised
repairer immediately.
Ignition key interlock system
(if equipped)
The ignition key cannot be removed
unless the shift lever is in the P (Park)
position.
Parking
Always come to a complete stop and
continue to depress the brake pedal.
Move the shift lever into the P (Park)
position, apply the parking brake, and
place the ignition switch in the LOCK/
OFF position. Take the Key with you
when exiting the vehicle.
WARNING
When you stay in the vehicle with
the engine running, be careful not to
depress the accelerator pedal for a long
period of time. The engine or exhaust
system may overheat and start a fire.
The exhaust gas and the exhaust
system are very hot. Keep away from
the exhaust system components.
Do not stop or park over flammable
materials, such as dry grass, paper or
leaves. They may ignite and cause a
fire.
Page 310 of 649
6-37
06
Parking brake warning light
Check the Parking Brake
Warning Light by placing the
ignition switch to the ON
position (do not start the
engine).
This light will illuminate when the
parking brake is applied with the ignition
switch in the START or ON position.
Before driving, be sure the parking brake
is released and the Brake Warning Light
is OFF.
If the Parking Brake Warning Light
remains on after the parking brake is
released whilst the engine is running,
there may be a malfunction in the
brake system. Immediate attention is
necessary.
If at all possible, cease driving the
vehicle immediately. If that is not
possible, use extreme caution whilst
operating the vehicle and only continue
to drive the vehicle until you can reach a
safe location.
Anti-lock Brake System (ABS)
WARNING
An Anti-Lock Braking System (ABS) or
an Electronic Stability Control (ESC)
system will not prevent accidents
due to improper or dangerous driving
manoeuvres. Even though vehicle
control is improved during emergency
braking, always maintain a safe
distance between you and objects
ahead of you. Vehicle speeds should
always be reduced during extreme
road conditions. The braking distance
for vehicles equipped with ABS or ESC
may be longer than for those without
these systems in the following road
conditions.
Drive your vehicle at reduced speeds
during the following conditions:
[ Rough, gravel or snow-covered
roads.
[ On roads where the road surface is
pitted or has different surface height.
[ Tyre chains are installed on your
vehicle.
The safety features of an ABS or ESC
equipped vehicle should not be tested
by high speed driving or cornering. This
could endanger the safety of yourself
or others.
ABS is an electronic braking system that
helps prevent a braking skid. ABS allows
the driver to steer and brake at the same
time.
Page 321 of 649
6-48
Driving your vehicle
Automatic Transmission/Dual Clutch
Transmission
- Conventional Idle STOP
[ ' H F U H D V H W K H Y H K L F O H V S H H G W R P S K
(0 km/h).
[ 3 U H V V W K H E U D N H S H G D O
- Extended Idle STOP
[ ' H F U H D V H W K H Y H K L F O H V S H H G O H V V W K D Q
15 mph (25 km/h).
[ 3 U H V V W K H E U D N H S H G D O
- During Sailing Mode
You can keep engine off status from
sailing to standstill by pressing brake
pedal below 24 mph (40 km/h).
NOTICE
Vehicle which is equipped automatic
transmission or dual clutch
transmission must reach a speed of at
least 18 mph (30 km/h) for Extended
Idle STOP or 3 mph (5 km/h) for
Conventional Idle STOP since last idle
stop.
- If you unfasten the seat belt or open
the driver’s door (engine bonnet)
in auto stop mode at standstill, ISG
system will be deactivated.
Auto start
To restart the engine from idle stop
mode (except 48V MHEV)
Manual transmission vehicle/ Intelligent
Manual Transmission
Vehicle which is equipped with manual
transmission or intelligent manual
transmission is available two version of
restart.
- Conventional restart
Press the clutch pedal when the shift
lever is in the N (Neutral) position.
- Late restart (if equipped)
1. Depress the clutch pedal
2. Engage the gear
3. Release the brake pedal
NOTICE
1. Late restart function is only operated
when it is on a level ground and the
vehicle is stable.
2. To start the engine when the brake
pedal is not pressed or gear is already
engaged, press the brake pedal first
and press on the clutch pedal for
safety.
3. To turn on the engine without vehicle
movement with the brake pedal
pressed (only with Late Restart),
[ 3 U H V V D Q G U H O H D V H W K H F O X W F K S H G D O
[ 3 U H V V W K H F O X W F K S H G D O D J D L Q
immediately
4. After the engine stall, If you operate
as below the engine will start.
[ 5 H O H D V H W K H F O X W F K S H G D O D I W H U W K H
engine completely stop
[ ' H S U H V V W K H F O X W F K S H G D O
Page 322 of 649
6-49
06
Automatic Transmission/Dual Clutch
Transmission
- Release the brake pedal.
The engine will start and the green AUTO
STOP indicator (
) on the instrument
cluster will go out.
7 R U H V W D U W W K H H Q J L Q H I U R P L G O H V W R S
P R G H I R U 9 0 + ( 9
Manual Transmission/Intelligent
Manual Transmission
- Before standstill
Press the clutch pedal if the clutch pedal
has not pressed.
If the clutch pedal has already been
pressed, release the brake pedal or
move the gear to a position other than N
position.
- After standstill
[ , I W K H F O X W F K S H G D O K D V D O U H D G \ E H H Q
pressed, release the brake pedal or
move the gear from N (Neutral).
[ , I W K H F O X W F K S H G D O L V Q R W S U H V V H G W K H
engine will restart in accordance with
the LATE Restart procedure.
1) Depress the clutch pedal
2) Engage the gear
3) Release only the brake pedal
NOTICE
1. Late restart function is only operated
when it is on a level ground and the
vehicle is stable.
2. To start the engine when the brake
pedal is not pressed or gear is already
engaged, press the brake pedal first
and press on the clutch pedal for
safety.
3. To turn on the engine without vehicle
movement with the brake pedal
pressed (only with Late Restart),
[ 3 U H V V D Q G U H O H D V H W K H F O X W F K S H G D O
[ 3 U H V V W K H F O X W F K S H G D O D J D L Q
immediately
4. After the engine stall, if you operate
as below the engine will start.
[ 5 H O H D V H W K H F O X W F K S H G D O D I W H U W K H
engine completely stops
[ ' H S U H V V W K H F O X W F K S H G D O
5. After operating ISG STOP, if the
vehicle speed increases instead of
decreasing, the engine may restart
automatically.
Automatic Transmission/Dual Clutch
Transmission
Release the brake pedal
NOTICE
After operating ISG STOP, if the vehicle
speed increases instead of decreasing,
the engine may restart automatically.
Page 352 of 649
Driver assistance system
7-6
OBC3070003
Emergency braking
[ To warn the driver that emergency
braking will occur, the ‘Emergency
% U D N L Q JT Z D U Q L Q J P H V V D J H Z L O O D S S H D U
on the cluster and an audible warning
will sound and the steering wheel will
vibrate. (if equipped).
[ If a vehicle is detected in front,
the function will operate when
your vehicle speed is between
approximately 6~37 mph (10~60
km/h).
[ If a pedestrian or cyclist is detected
in front, the function will operate
when your vehicle speed is between
approximately 6~37 mph (10~60
km/h).
[ In emergency braking situation,
braking is assisted with strong braking
power by the function to help prevent
collision with the vehicle, pedestrian
or cyclist ahead.
OBC3070004
Stopping vehicle and ending brake
control
[ When the vehicle is stopped due
to emergency braking, the ‘Drive
F D U H I X O O \T Z D U Q L Q J P H V V D J H Z L O O D S S H D U
on the cluster.
For your safety, the driver should
depress the brake pedal immediately
and check the surroundings.
[ Brake control will end after the vehicle
is stopped by emergency braking for
approximately 2 seconds.
WARNING
Take the following precautions when
using Forward Collision-Avoidance
Assist:
[ For your safety, change the Settings
after parking the vehicle at a safe
location.
[ With ‘Active Assist’ or ‘Warning Only’
selected, when ESC is turned off by
pressing and holding the ESC OFF
button for more than 3 seconds,
Forward Collision-Avoidance Assist
will turn off automatically. In this
case, the function cannot be set
from the Settings menu and the
warning light will illuminate on the
cluster which is normal. If ESC is
turned on by pressing the ESC OFF
button, Forward Collision-Avoidance
Assist will maintain the last setting.