2023 GENESIS GV60 battery

1-17
01
OJWEVQ011065
3. Check the operation status through
the front indicator of the power outlet.

[Blue: Standby

[Red: No power supply even the
power outlet is connected

[Green: Normal power supply
through the normal connection of
the power outlet.
Information

[V2L discharging mode will shut off if
the vehicle is off using indoor V2L on
the vehicle state of ON.

[Opening the charging door or
connecting the V2L connector to the
charging inlet, the V2L discharging
mode will shut off. If you want to
use the indoor and outdoor V2L
simultaneously, firstly connect the V2L
connector to the charging inlet and use
the indoor V2L.
CAUTION

[Be well-informed of the manual to
prevent accidents.

[The V2L discharging mode is
blocked automatically in case of
overheating. (When the discharging
mode is blocked, check whether
the V2L connector or power plug
is contaminated, worn, corroded
or broken or the home appliance
capacity is over 16 A. If the
temperature falls to proper level
after it is left unattended, you can
use it again. Use proper home
appliances.)

[Do not remodel or disassemble
the provided V2L connector. The
failure caused by remodeling or
disassembling is not covered by the
warrant.

[Do not drop the V2L connector or
give a strong impact to it.

[Do not place objects on the V2L
connector.

[Be sure to disconnect the V2L
connector from the vehicle when you
are finished using V2L.

[When the high voltage battery
charge reaches the set discharging
limit(%), the operation stops, and
a warning message is displayed on
the instrument panel. If you want
V2L operation, set the discharging
limit(%) lower than the current
battery charge.

[When using various electric
products, use them below the
maximum power capacity that can
be supplied by the vehicle.

1-20
Foreword / Starting your Electric vehicle
LCD display messages
ONE1Q011077L
V2L has ended. Battery level has reached
the set value
When the high voltage battery level
reaches the discharging limit set level,
the V2L will stop and the warning will
be displayed. If you want to use the V2L
continuously, make the discharging limit
set level lower than the present battery
level.
ONE1Q011078L
V2L stopped due to excessive power use
If you use an electrical appliance that
exceeds the maximum power output the
vehicle can supply, it will stop working
and display a warning message. Make
sure that the total power consumption of
your electrical appliance exceeds the V2L
maximum power output.
ONE1Q011079L
V2L conditions not met
If V2L is interrupted for any of the
following reasons, a warning message is
displayed.

[V2L connector switch off

[V2L connector overheating

[Opening the charging door while
using the V2L indoor outlet
Make sure there are no problems with
the V2L connector and the vehicle indoor
outlet.

1-22
Foreword / Starting your Electric vehicle
Charging current
OJWEVQ011100L

[You can adjust the charging
current for an AC charger. Select an
appropriate charging current.

[If the charging process does not
start or abruptly stops in the middle,
reselect another proper current and
re-try charging the vehicle.

[Charging time varies depending on
which charging current is selected.
Battery conditioning mode
OJWEVQ011101L
You can select or deselect the Battery
conditioning mode.
The Battery conditioning mode is
efficient during the winter time when the
high voltage battery temperature is low.
This mode is recommended to improve
driving and DC charging performances
during winter by raising the battery
temperature to an adequate level.
However, the driving distance may be
reduced as the energy is required to
increase battery temperature.
Also, if the battery temperature is low
during driving or when scheduled air
conditioner/heater is activated, this
mode is operated to improve driving
performance and charging performance.
However, the mode is not operated to
ensure driving distance when the battery
level is low.
Information
This mode is available for the vehicles
equipped with the battery heater.

1-23
01
Utility Mode
The high voltage battery is used instead
of the 12V auxiliary battery for operating
the convenient features of the vehicle.
When driving is not necessary such as
while camping or when stopping the
vehicle for a long time, it is possible to
use the electrical devices (audio, lights,
air conditioner, heater, etc.) for long
hours.
OJWEVQ011102L
System Setting and Activation
System setting
The driver can activate the Utility mode
function when the following conditions
are satisfied.

[The vehicle is in the ready
(
) mode and the gear is shifted
to P (Park).

[The EPB (Electronic Parking Brake)
does not have a malfunction.

[
S(96HWWLQJV

1-24
Foreword / Starting your Electric vehicle
Charging Information

[AC Charge: The electric vehicle is charged by plugging into a AC charger installed at
your home or a public charging station. (For further details, refer to the ‘AC Charge’.)

[DC Charge: You can charge at high speeds at public charging stations. Refer to the
respective charger’s display or manual instructions that is provided for each DC
charger type.
Battery performance and durability can deteriorate if the DC charger is used
constantly.
Use of DC charge should be minimized in order to help prolong high voltage battery
life. It is best to have a mix of AC and DC charging of your battery over time.

[Portable Charge: The Electric vehicle can be charged by using household electricity.
The electrical outlet at your home must comply with regulations and can safely
accommodate the Voltage / Current (Amps) / Power (Watts) ratings specified on the
portable charge.
Charging Time Information
Charging type Standard battery type
AC chargeTakes approx. 7 hours 10 minutes at room temperature when charged
From 10% to 100%
DC charge350 kW
chargerTakes about 18 minutes at room temperature when
charged from 10% to 80%. Can be charged to 100%.
50 kW
chargerTakes about 73 minutes at room temperature when
charged from 10% to 80%. Can be charged to 100%.
Portable chargeTakes approx. 68 hours at room temperature when charged From 10%
to 100%.
NOTICE
DC Charging speed will slow down after 80% SOC and take much longer time to
reach 100%.
Information
<002700480053004800510047004c0051004a00030052005100030057004b004800030046005200510047004c0057004c005200510003004400510047000300470058005500440045004c004f004c0057005c00030052004900030057004b00480003004b00
4c004a004b000300590052004f00570044004a004800030045[attery, charger
specifications, and ambient temperature, the time required for charging the high voltage
battery may vary.
CHARGE TYPES FOR ELECTRIC VEHICLE

1-25
01
Charging Types
Category AC Charge DC Charge Portable Charge
Charging
Inlet
(Vehicle)
OJWEVQ011001OJWEVQ011003OJWEVQ011001
Charging
Connector
ORG3EVQ011090OAEEQ016079NORG3EVQ011090
Charging
Outlet
OLFP0Q4057NOSQCEQ019005ONX4EPHQ011019L
How to
ChargeUse AC charger
installed at home or
public charging stationUse the DC charger at
public charging stationUse household current

[Depending on the condition and durability of the high voltage battery, charger
specifications, and ambient temperature, the time required for charging the high
voltage battery may vary.

[Actual charger image and charging method may vary in accordance with the
charger manufacturer.
Information
Type 3R, when mating with outlets. Additional Type 3R enclosure should be provided in
the end installation.

1-26
Foreword / Starting your Electric vehicle
CHARGE INDICATOR LAMP FOR ELECTRIC VEHICLE
When charging the high voltage battery,
the charge level can be checked from
outside the vehicle.
Charging Status
Electric charging door
OJWEVQ011002
1. Charging status
Lamp status Battery SOC [%]
OJWEVQ011005
0~12.5
OJWEVQ011006
12.5~25
OJWEVQ011007
25~37.5
OJWEVQ011008
37.5~50
Lamp status Battery SOC [%]
OJWEVQ011009
50~62.5
OJWEVQ011010
62.5~75
OJWEVQ011011
75~87.5
OJWEVQ011012
87.5~100
2. High voltage indicator
Lamp status Details
OJWEVQ011116N
High voltage electricity
flowing(Charging 12
V auxiliary battery
or scheduled air
conditioner/heater is
operating)
* The indicator is
located on top of the
crash pad.

1-29
01
Electric Charging Door
OJWEVQ011111L
The electric charging door will open and
close as follows.
CHARGING ELECTRIC VEHICLE
Methods Open Close
Touch and Push
OJWEV051052OJWEV051053
Smart Key
OJWEVQ011114
Voice RecognitionWNE1-208
(Limited to areas where voice recognition is applied)
Information

[The charging door automatically closes when:
-The charging connector is disconnected
-The charging procedure has not done for a certain amount of time while the
charging door is opened.
-The gear is in D (drive), N (neutral), or R (Reverse).

[After replacing battery (12 volt), open and close the charging door once to check that
the charging door automatic opening mechanism is functioning properly.

[When replacing the charging door, be sure to disconnect the vehicle-side wiring
connector of the charging door module and reconnect it to ensure normal operation of
the charging door.