2023 GENESIS G90 engine

4-25
04
Low washer fluid
This message is displayed if the washer
fluid level in the reservoir is nearly empty.
Have the washer fluid reservoir refilled.
Low fuel
This message is displayed if the fuel tank
is almost out of fuel.
When this message is displayed, the low
fuel level warning light in the cluster will
come on.
It is recommended to look for the nearest
fueling station and refuel as soon as
possible.
Low engine oil (if equipped)
This warning message is displayed when
the engine oil level should be checked.
If this warning message is displayed,
check the engine oil level as soon as
possible and add engine oil as required.
Slowly pour the recommended oil little
by little into a funnel.
Use only the specified engine oil. (Refer
to "Recommended Lubricants and
Capacities“ section in chapter 2.)
Do not overfill the engine oil. Make sure
the oil level is not above F (Full) mark on
the dipstick.
Information
After adding engine oil, if you travel
approximately 31~62 miles (50~100 km)
after the engine warms up, the warning
message should disappear.
Engine overheated
This message is displayed when the
engine coolant temperature is above
248°F (120°C). This means that the
engine is overheated and may be
damaged.
If your vehicle is overheated, refer to
“Overheating” section in chapter 8.
Check haptic steering wheel system
This message is displayed if there is a
problem with the haptic steering wheel
system. Have the vehicle inspected by an
authorized retailer of Genesis Branded
products.
Check headlight (if equipped)
This message is displayed if the
headlights are not operating properly. A
lamp may need to be replaced.
Make sure to replace the burned out
bulb with a new one of the same wattage
rating.
Check turn signal (if equipped)
This message is displayed if the turn
signal lamps are not operating properly.
A lamp may need to be replaced.
Make sure to replace the burned out
bulb with a new one of the same wattage
rating.
Check headlight LED (if equipped)
This message is displayed if there is a
problem with the LED headlight. Have
the vehicle inspected by an authorized
retailer of Genesis Branded products.
004_RS4_HMA.indd 4-252022-04-06  3:02:33

4-27
04
ORS042035NORS042035N
Driving Assist, Map and Normal View
modes are displayed in the instrument
cluster.
Normal view is also show in the widget
mode.
Driving Assist view
ORS041026ORS041026
The status of Smart Cruise Control, Lane
Following Assist, Highway Driving Assist,
etc. is displayed when Driving Assist view
is selected.
For more details, refer to each system
information section in chapter 6.
Normal View
In the Normal View, using the (Optical
mouse), you may change through items
in the following order.
ORS042025NORS042025N
Drive info
Trip distance, average fuel economy, and
total driving time are displayed.
The information is combined for each
ignition cycle. However, when the engine
has been OFF for 4 hours or longer the
Drive Info screen will reset.
To manually reset the information, press
the
button three times on the steering
wheel when Drive Info is displayed.
The trip distance, the average fuel
economy, and total driving time will reset
simultaneously.
ORS042029NORS042029N
Since refueling
Trip distance, average fuel economy, and
total driving time after the vehicle has
been refueled are displayed.
To reset manually, press the
button
three times on the steering wheel when
‘Since Refueling’ is displayed.
004_RS4_HMA.indd 4-272022-04-06  3:02:34

4-28
Instrument Cluster, Armrest touchscreen, Infotainment system
ORS042028NORS042028N
Accumulated info
Accumulated trip distance, average fuel
economy, and total driving time are
displayed.
The information is accumulated starting
from the last reset.
To manually reset the information,
press the
button three times on the
steering wheel when Accumulated Info is
displayed. The trip distance, the average
fuel economy, and total driving time will
reset simultaneously.
ORS041031LORS041031L
Auto stop (if equipped)
AUTO STOP display shows the elapsed
time of engine stop by Idle Stop and Go
system.
To manually reset the information, press
the
button three times on the steering
wheel when ‘AUTO STOP’ is displayed.
For more details, refer to “Idle Stop and
Go (ISG)” section in chapter 6.
ORS041032LORS041032L
Tire pressure
The tire pressure of each tire is displayed.
For more details, refer to “Tire Pressure
Monitoring System (TPMS)” section in
chapter 8.
ORS041030LORS041030L
Driving force distribution (if equipped)The distribution status of the driving
power of the front and rear wheels are
displayed when Auto 4WD mode is
activated.
For more details, refer to "Four Wheel
Drive (4WD)" section in chapter 6.
004_RS4_HMA.indd 4-282022-04-06  3:02:34

5-7
05
Information

[The side view mirror will fold if
‘Enable on Door Unlock’ is selected
from the Settings menu in the
infotainment system screen. Select:
-6HWXS
:9HKLFOH
:&RQYHQLHQFH
:
:HOFRPH0LUURU/LJKW
:2QGRRU
unlock

[The door handle touch sensor will only
operate when the smart key is within
28~40 in. (0.7~1 m) from the outside
door handle.

[Note that you cannot lock your vehicle
using the door handle touch sensor if
any of the following occur:
-The Smart Key is in the vehicle.
-The Engine Start/Stop button is from
$&&RU21SRVLWLRQ
-Any of the doors are open except for
the trunk.
WARNING
Do not leave the Smart Key in your
vehicle with unsupervised children.
Unattended children could press the
Engine Start/Stop button and may
operate power windows, lock the doors
or other controls, or even make the
vehicle move, which could result in
serious injury or death.
Unlocking your vehicle (When the
Two Press Unlock feature is off)
ORS051006
To unlock your vehicle using the door
handle touch sensor or the Smart Key:
1. Make sure you have the smart key in
your possession.
2. Touch the door lock/unlock sensor on
the door handle (the engraved part)
or press the Door Unlock button N on
the smart key.
3. When all doors unlock, door handles
will pop out and the hazard warning
lights will blink two times.

5-10
Convenience Features
Panic button
Press and hold the Panic button P for
more than one second. The horn sounds
and hazard warning lights blink for about
30 seconds. To cancel the panic mode,
press any button on the Smart Key.
Remotely starting vehicle (if
equipped)
You can start the vehicle using the
Remote Start button Q on the smart key.
To start the vehicle remotely:
1. Press the door lock button on the
smart key within 32 feet (10 m) from
the vehicle.
2. Press the Remote Start button Q for
more than 2 seconds within 4 seconds
after pressing the door lock button.
The hazard warning lights will blink
and the engine will start.
3. To turn off the remote start function,
press the Remote Start button Q
once.
Information

[The vehicle must be in P (Park) for the
remote start function to start.

[The engine turns off if you get in the
vehicle without a registered smart key.

[The engine turns off if you do not get
in the vehicle within 10 minutes after
remotely starting the vehicle.

[The Remote Start button Q may not
operate if the smart key is not within 32
feet (10 m).

[The vehicle will not remotely start if the
engine hood or trunk is opened.

[Do not idle the engine for a long period.

[Do not operate remote start in closed
areas where there is no adequate
ventilation for the engine exhaust.
Remotely moving vehicle forward or
backward (if equipped)
With the smart key, the driver can move
the vehicle forward or backward using
the Forward/Backward button R on the
smart key.
For more details, refer to “Remote Smart
Parking Assist (RSPA)” section in chapter
7.
Start-up
You can start the engine without
inserting the key.
For more details, refer to the “Engine
Start/Stop Button” section in chapter 6.

5-11
05
Using mechanical key
If the Smart Key does not operate
normally, you can lock or unlock the
driver’s door by using the mechanical
key.
OJWEV051097
1. Press the Genesis text section of the
Mechanical key to remove the case.
OJWEV051098
2. Remove the mechanical key from the
case.
3. After use, reinstall the mechanical key
in the reverse order of removal.
Loss of a smart key
A maximum of two Smart Keys can
be registered to a single vehicle. If
you happen to lose your smart key,
it is recommended that you should
immediately take the vehicle and
remaining keys to your authorized
retailer of Genesis Branded products or
tow the vehicle, if necessary.
Smart Key Precautions

[Avoid keeping a smart key with
accessories in the same location such
as pants or jacket pocket. The smart
key button may be pressed by the
accessory.

[The smart key may not work if any of
the following occur:
- The smart key is close to a radio
transmitter such as a radio station
or an airport which can interfere
with normal operation of the
transmitter.
- The smart key is near a mobile
two way radio system or a mobile
phone.
- Another vehicle’s smart key is being
operated close to your vehicle.
- Connecting an external device to
the power outlet and placing the
smart key near the external device.
If the smart key does not work correctly,
open and close the door with the
mechanical key, To start the engine,
press the Engine Start/Stop button
directly with the smart key. If you have
a problem with the smart key, it is
recommended to contact an authorized
retailer of Genesis Branded products.
If the smart key is in close proximity to
your mobile phone, the signal could be
blocked by your mobile phone’s normal
operational signals. This is specifically
relevant when the phone is active such
as making and receiving calls, text
messaging, and/or sending/receiving
emails. When possible, avoid keeping the
smart key and your mobile phone in the
same location such as a pants or jacket
pocket in order to avoid interference
between the two devices.

5-14
Convenience Features
WARNING
THIS PRODUCT CONTAINS A BUTTON
BATTERY.
If swallowed, a lithium button battery
can cause severe or fatal injuries within
2 hours. Keep batteries out of reach of
children.
If you think batteries may have been
swallowed or placed inside any part
of the body, seek immediate medical
attention.
Information
An inappropriately disposed
battery can be harmful to
the environment and human
health. Dispose of the battery
according to your local law(s) or
regulations.
Immobilizer System
The immobilizer system protects your
vehicle from theft. If an improperly
coded key (or other device) is used, the
engine’s fuel system is disabled.
When the Engine Start/Stop button
is pressed to the ON position, the
immobilizer system indicator should
come on briefly, then go off. If the
indicator starts to blink, the system does
not recognize the coding of the key.
Press the Engine Start/Stop button to
the OFF position, then press the Engine
Start/Stop button to the ON position
again.
In some circumstances, the vehicle may
not recognize your smart key if another
smart key device is nearby or a metal
object such as a key chain is causing
interference with the smart key.
If this occurs, your vehicle may not
start. Remove any metal objects or
additional keys near the smart key before
attempting to start the vehicle again.
If the system repeatedly does not
recognize the coding of the key, it is
recommended that you contact your
retailer of Genesis Branded products.
Do not attempt to alter this system
or add other devices to it. Electrical
problems could result that may make
your vehicle inoperable.

5-17
05

[Ultra Wide Band supported smart
phone
- The digital key can be registered
if the smart phone is inside the
vehicle even without placing it
on the vehicle authentication pad
(wireless charging pad).
4. Press the ‘Save’ button from the
infotainment system screen. The
saving process begins automatically.

[When the digital key (smart phone)
is saved, a message appears on the
infotainment system screen.
Information

[If you want to register a digital key
(smart phone) again, refer to ‘How to
Delete Digital Key (Smart Phone)’ and
delete the digital key (smart phone)
before re-registering.

[During the digital key saving process,
the process will cancel when:
-The smart phone is removed from the
vehicle authentication pad (wireless
charging pad)
-The infotainment system screen is
changed
-The vehicle is turned off
-The gear is shifted

[The registering process does not start if
a smart key is not in the vehicle.

[Some smart phones may not start the
registering process depending on the
internal structure. Move the smart
phone to the left or right on the vehicle
authentication pad (wireless charger
pad) and try registering the smart
phone.
Using the digital key (smart phone)
Digital key touch control
The driver can lock or unlock the door by
placing the smart phone on the outside
door handle, and the vehicle can be
started by placing the smart phone on
the vehicle authentication pad (wireless
charging pad).
Digital key close proximity control

[If you have the smart phone in
possession, the doors can be locked
or unlocked without touching the
smart phone to the door handle, but
by touching the door lock/unlock
sensor (engraved part) on the door
handle. Also, the vehicle can be
started by pressing the Engine Start/
Stop button without placing the smart
phone on the vehicle authentication
pad (wireless charging pad).

[When the smart phone and vehicle is
connected by Bluetooth, the Remote
Start, Door Lock/Unlock, and Panic
functions are available using the
App provided by the smart phone
manufacturer.
Information

[The function is only available for Ultra
Wide Ban supported smart phone
digital keys. To use the function, the
smart phone’s Bluetooth must be
activated.

[The necessary distance between the
smart phone and vehicle for Bluetooth
connection may vary depending on the
surroundings of the vehicle and smart
phone.