
45
In the event of a breakdown
8► Tighten the spare wheel fixing screw by a few 
turns.
After changing a wheel
The temporary spare wheel is only intended for temporary emergency use, 
until the conventional wheel can be repaired 
or replaced.
Continuous use of this spare can result in tire 
failure and loss of control. Always observe 
these precautions when using this spare:
–
 
Y
our vehicle will respond differently with 
this temporary spare.
–
 
Do not exceed 80 km/h speed.
–
 
Replace this spare with a standard tire and 
wheel as soon as possible.
–
 
Use of this spare will reduce ground 
clearance.
–
 
Set the specified tire pressure indicated 
on the tire information label located on the 
driver's door lock pillar
.
–
 
Do not use tire chains on the temporary 
spare. If you must use tire chains, rearrange 
the wheels so standard tires and wheels are 
fitted to the front axle.
–
 
The temporary spare wheel has a much 
shorter tread life than the conventional 
wheels 
on your vehicle. Replace the tire as soon as 
possible as the tread wear indicator appears.
The inflation pressure of the temporary spare 
wheel should be checked at least monthly. At 
the same time, check that the tire is stored 
securely. If it is not, tighten it.
Note that two or more temporary spare 
wheels should not be used on one vehicle 
simultaneously.
Changing a bulb
In some weather conditions (e.g. low 
temperature or humidity), misting on the 
internal surface of the glass of the headlamps 
and rear lamps is normal, and will disappear 
after the lamps have been on for a few 
minutes.
The headlamps have polycarbonate  lenses with a protective coating:
–
 
Do not clean them with a dry or abrasive 
cloth, nor with detergent or solvent 
products.
–
 
Use a sponge and soapy water or a pH 
neutral product.
–
 
When using a high-pressure washer on 
persistent marks, do not keep the lance 
directed towards the headlamps, lamps or 
their edges for too long, so as not to damage 
their protective coating and seals.
Changing a bulb must only be done with 
the ignition off and after the headlamp / 
lamp has been switched off for several 
minutes - risk of serious burns!
Do not touch the bulb directly with your 
fingers; use a lint-free cloth.
It is essential only to use anti-ultraviolet 
(UV) type bulbs, so as not to damage the 
headlamp.
Always replace a failed bulb with a new bulb 
of the same type and specification. To avoid 
lighting imbalance, replace the bulbs in pairs.
Refitting the lamp units
Perform the operations in the reverse 
order to dismantling.
Opening the bonnet / Accessing the 
bulbs
With the engine warm, proceed with caution - 
risk of burns!
Take care with objects or clothing that could 
be caught in the blades of the cooling fan - 
risk of strangulation!
Halogen bulbs (Hx)
To ensure good quality lighting, check 
that the bulb is correctly positioned in its 
housing.    

48
In the event of a breakdown
Changing a fuse
Access to the tools 
 
The puller is located inside the engine fuse box.
► Open the bonnet.
►
 
Disengage the cover completely
 .
►
 
T
 ake the puller from its housing.
Changing a fuse
Before changing a fuse:
► Identify the cause of the fault and fix it.
►
 
Switch off all power consumption.
►
 
Identify the defective fuse using the current 
allocation tables and diagrams.
T
o replace a fuse, it is essential to:
►
 
Use the special puller to extract the fuse 
from its housing and check the condition of its 
filament.
► Always replace the failed fuse with a fuse of 
the same rating (same colour); use of a different 
rating may cause malfunctions - risk of fire!
If the fault recurs soon after replacing a fuse, 
have the electrical system checked by a 
CITROËN dealer
.
The fuse allocation tables and the corresponding diagrams are available 
from a CITROËN dealer.
The replacement of a fuse not shown in  the allocation tables may cause a serious 
malfunction of the vehicle. Contact a 
CITROËN dealer.
 
    
Good
Faulty 
 
Puller
Installing electrical accessories
The vehicle's electrical system is 
designed to operate with standard or optional 
equipment.
Before installing other electrical equipment 
or accessories to your vehicle, contact a 
CITROËN dealer.
CITROËN accepts no responsibility for 
the cost incurred in repairing the vehicle 
or for rectifying malfunctions resulting from 
the installation of accessories not supplied or 
not recommended by CITROËN and not 
installed in accordance with its 
recommendations, in particular when the 
combined power consumption of all of the 
additional equipment connected exceeds 10 
milliamperes.
Dashboard fuses
The fusebox is placed in the lower dashboard 
(right-hand side).
Access to the fuses 
     

56
In the event of a breakdown
RelayColourRating (A) Functions
MINI Grey 40Accessory load (HVAC Blower/Washer)
MAXI Grey 70ECM Power
12 V battery
Lead-acid starter batteries
These batteries contain harmful 
substances (sulphuric acid and lead).
They must be disposed at authorized dealer/
battery shop in accordance with regulations 
and must never under any circumstances be 
discarded with household waste.
Take used remote control batteries and 
vehicle batteries to a special collection point.
Protect your eyes and face before 
handling the battery.
Use goggles and gloves while working with 
the battery. Diluted sulphuric acid spilled from 
battery can cause blindness or severe burns. 
Flush eyes or body with ample water and get 
medical care immediately if suffered. 
Keep batteries out of the reach of children. 
All operations on the battery must be carried 
out in a well ventilated area and away from 
naked flames and sources of sparks, so as to 
avoid any risk of explosion or fire.
Wash your hands afterwards.
If the battery fails (after warranty 
coverage), replace it with a battery of the 
same specification as the one used in the 
vehicle. 
Access to the battery
The battery is located under the bonnet.
Naturally Aspirated engine version 
 
(+) Positive terminal.
(-) Negative terminal.
Turbo engine version 
 
(+) Positive terminal.
(-) Negative terminal.
A remote earth point is located near the battery.
Starting using another 
battery
If the vehicle's battery is flat/drain/discharged, 
the engine can be started using a backup battery 
(either external or from another vehicle) and 
jump leads or using a battery booster.
Never start the engine by connecting a 
battery charger.
Never use a 24
  V or higher battery booster.
Check beforehand that the backup battery 
has a nominal voltage of 12
  V and a capacity     

70
Alphabetical index
A
ABS    23
Adjusting headlamps     
20
Adjusting seat
    
14
Adjusting the air distribution
    
17
Adjusting the air flow
    
17
Adjusting the headlamp beam height
    
20
Adjusting the height and reach of  
the steering wheel
    
15
Adjusting the temperature
    
17
Advice on care and maintenance
    
41
Advice on driving
    
4, 31
Airbags
    
26–27
Airbags, front
    
26–27
Air conditioning
    
16–17
Air conditioning, manual
    
17
Air intake
    
18
Air vents
    
16
Anti-lock braking system (ABS)
    
23
Antitheft / Immobiliser
    
10
B
Battery, 12 V    39, 56, 58
Battery, remote control     
10
Bodywork
    
41
Bonnet
    
35–36
Boot
    
11
Brake discs
    
40
Brake lamps
    
47
Brakes    40
Bulbs     
45
Bulbs (changing)
    
45–47
C
Capacity, fuel tank    35
Cap, fuel filler     
35
Care of the bodywork
    
41
Central locking
    
9–10
Changing a bulb
    
45–47
Changing a fuse
    
48, 51
Changing a wheel
    
42
Changing the remote control battery
    
10
Checking the levels
    
37–38
Checks
    
37, 39–41
Checks, routine
    
39–40
Child lock
    
30
Children
    
25
Children (safety)
    
30
Child seats
    
25, 28–29
Child seats, conventional
    
29
Cleaning (advice)
    
41
Closing the boot
    
11
Control, emergency boot release
    
11
Control, emergency door
    
10
Control stalk, lighting
    
20
Control stalk, wipers
    
21
Courtesy lamp
    
47
Courtesy lamps
    
19
D
Dimensions     60
Dipstick     
37
Direction indicators (turn signals)
    
20, 46–47
Doors
    
11
Driving
    
31
Driving economically
    
4
E
EBFD    23
Eco-driving (advice)     
4
Electric windows
    
12
Electronic brake force distribution (EBFD)
    
23
Emergency warning lamps
    
23
Engine
    
35–36, 41
Engine compartment
    
37
Engine, petrol
    
60
Engines
    
60
Environment
    
10
F
Filling the fuel tank     35
Filter, air     
40
Filter, oil
    
40
Filter, passenger compartment
    
16, 40
Fitting a wheel
    
43–44
Fittings, boot
    
19   

71
Alphabetical index
Fittings, interior    18
Flap, fuel filler     
35
Flashing indicators
    
20, 46
Fluid, brake
    
38
Fluid, engine coolant
    
38
Folding the rear seats
    
15–16
Fuel
    
4
Fuel consumption
    
4
Fuel level, low
    
35
Fuel (tank)
    
35
Fusebox, dashboard
    
48
Fusebox, engine compartment
    
48, 51
Fuses
    
48, 51
G
Gauge, fuel    35
Gearbox, manual     
32, 40
Gear lever, manual gearbox
    
32
Gear shift indicator
    
33
Glove box
    
18
H
Hazard warning lamps     23
Headlamps (adjustment)     
20
Headlamps, dipped beam
    
46
Headlamps, halogen
    
20, 45
Headlamps, main beam
    
46
Heating
    
16
Hooks    19
Horn     
23
I
Indicator, coolant temperature    7
Indicators, direction     
20, 46
Indicator, service
    
7
Inflating tyres
    
40, 61
Instrument panels
    
5
J
Jack    42
Jump starting     
56
K
Key    9–10
Key with remote control     
9, 31
L
Labels, identification     60
Lamps, rear     
47
LEDs - Light-emitting diodes
    
46–47
Level, brake fluid
    
38
Level, engine coolant
    
7, 38
Level, engine oil     37
Levels and checks     
37–38
Level, screenwash fluid
    
21, 38
Light-emitting diodes - LEDs
    
46–47
Lighting, exterior
    
20
Lighting, interior
    
19
Locating your vehicle
    
9
Locking
    
9
Locking from the inside
    
10
Locking the doors
    
10
M
Maintenance (advice)     41
Maintenance, routine     
39
Map reading lamps
    
19
Markings, identification
    
60
Mirrors, door
    
15
O
Obstacle detection    33
Oil change     
37
Oil consumption
    
37
Oil, engine
    
37
On-board tools
    
42
Opening the bonnet
    
35–36
Opening the boot
    
11
Opening the doors
    
11   

84
Pre Delivery Inspection (PDI) Coupon
Please see the MAINTENANCE SECTION in this chapter.
Notice of name/addressownership change
NAME/ADDRESS CHANGE 
SUBSEQUENT OWNER  
Please check one of the above boxes
Owner
’s Name:
Address:
VIN:
Engine No:
Registration No:
Date of Purchase:
Mileage at Present:
Owner’s Signature:
THANK YOU FOR YOUR CO-OPERATIONPlease give complete information
Maintenance and Warranty  

86
LABOUR FREE SERVICE at 
2 months / 2,000 kms
Please see the MAINTENANCE SECTION in this chapter.
Notice of name/addressownership change
NAME/ADDRESS CHANGE 
SUBSEQUENT OWNER  
Please check one of the above boxes
Owner
’s Name:
Address:
VIN:
Engine No:
Registration No:
Date of Purchase:
Mileage at Present:
Owner’s Signature:
THANK YOU FOR YOUR CO-OPERATIONPlease give complete information
Maintenance and Warranty  

88
LABOUR FREE SERVICE at 
12 months / 10,000 kms
Please see the MAINTENANCE SECTION in this chapter.
Note: Parts cost to be borne by customer.
Notice of name/addressOwnership change
NAME/ADDRESS CHANGE 
SUBSEQUENT OWNER  
Please check one of the above boxes
Owner
’s Name:
Address:
VIN:
Engine No:
Registration No:
Date of Purchase:
Mileage at Present:
Owner’s Signature:
THANK YOU FOR YOUR CO-OPERATIONPlease give complete information
Maintenance and Warranty