2023 BMW X2 lock

Before unlocking the transmission lock man

Warning
If a rear seat backrest is not locked, unse

Checking and adjusting the tire
inflation pressure
Checking1.Switch off the compressor.2.Read the tire pressure on the tire pressure
display.
To continue the trip, a tire inflation pressure of at least 2 bar must be reached.
Removing and stowing the sealant
bottle
1.Unscrew the filler hose of the sealant bottle
from the tire valve.2.Press the red unlocking device.3.Remove the sealant bottle from the com

1.Hold the jack with one hand, arrow 1, and
grasp the jack crank handle with your other hand, arrow 2.2.Insert the jack into the rectangular recess ofthe jacking point closest to the wheel to be
changed.3.Extend the jack by turning the jack crank
handle or lever clockwise.4.Take your hand away from the jack as soon
as the jack is under load and continue turn

Indicator/warning lightsWhen the hood is unlocked, a Check Control
message is displayed.
Closing the hood
Energetically close the hood from approx.
20 in/50 cm.
The hood must engage on both sides.
Seite 258MOBILITYEngine compartment258
Online Edition for Part no. 01405A540A1

Adding coolant1.Let the engine cool down.2.Open the hood.3.Turn the lid of the coolant reservoir slightly
counterclockwise to allow any excess pres

Diagnostic socket
General information
Devices connected to the diagnostic socket will
trigger the alarm system after locking the vehi

Remove cover, arrow 2.3.Loosen both nuts, arrow 1, of the outer tail
light. Use the handle of the screwdriver from the onboard vehicle tool kit to loosen.
Carefully pull out the tail light from the body
toward the front, arrow 2. Ensure that the
wiring is not damaged.4.Detach the connector from the light bracket
and detach the tail light wiring.Replacing the bulbs1.Turn the light bracket counterclockwise and remove.2.Press the faulty bulb gently into the socket,turn counterclockwise and remove.3.Proceed in the reverse order to insert thenew bulb and attach the light bracket.
Installing the tail light
1.Connect the plug and hook the wiring onthe tail light, arrow 1.2.Place the tail light with the lugs, arrows 2,on the attachment points of the body and
push onto both of the threaded bolts.3.Press on the tail lights until flush and
tighten both of the nuts.4.Mount the cover. Make sure that the plastic tabs of the cover are correctly seated in the
corresponding recesses of the body.
Lights in the tailgate
General
Follow the safety information, refer to
page 268.
Seite 270MOBILITYReplacing components270
Online Edition for Part no. 01405A540A1