2022 VOLKSWAGEN ID.5 windscreen

tional sign in the head-up display and in the
instrument cluster.
Displays
In addition to speed limits and o
vertaking re-
strictions, Dynamic Road Sign Display also
detects the road sign which indicates that all
restrictions have been lifted on motorways
and main roads in Germany. In all other coun-
tries in which the system is operated, the
current speed limit is displayed instead.
The road signs detected by the Dynamic Road
Sign Display system are displayed on the in-
strument cluster. Road signs may also be dis-
played in the Infotainment system, depend-
ing on the system installed in the vehicle.
With some equipment levels, a display is also
shown on the Head-up Display.
The system is in the initial-
isation phase. OR: the camera has not
detected any regulatory or warning
signs.
System fault. Go to
a qualified workshop.
Fault in the Dy-
namic Road Sign Display system
speed warning. Go to a qualified
workshop.
The
windscreen is dirty in the area of the
camera or the camera view is im-
paired due to the weather conditions.
Clean the windscreen.
No data
transmission from the Infotainment
system. Check whether valid map da-
ta is loaded in the Infotainment sys-
tem. OR: the vehicle is located in an
area that is not covered by the map
stored in the Infotainment system.
Dynamic Road Sign Display is
not supported in the country in which
you are currently travelling.
No road signs available.
Error: Dynamic Road Sign Display
Speed warning currently not available.
Dynamic Road Sign Display: Clean the windscreen!
Dynamic Road Sign Display is currently restricted.
No data available.
Display of road signs Fig. 16
In the instrument cluster display: e
xam-
ple of recognised speed limits with generic addi-
tional sign.
After validation and evaluation of the infor-
mation from the camera, the Infotainment
system and the current vehicle data, the Dy-
namic Road Sign Display shows up to two
valid road signs and one generic additional
sign

terior, e.g. the steering wheel, dash panel, or
windscreen

D
NOTICE
Before setting off and bef ore switching on
the ignition, always check the following to
avoid damage to the windows, wiper blades
and wiper motor:
x The wiper lever is located in the basic po-
sition.
x Snow and ice have been removed from the
wiper blades and windows.
x Wiper blades that have become frozen on-
to the glass have been carefully loosened.
Volkswagen recommends using a de-icer
spray for this. NOTICE
Do not switch on the wipers when the win-
dow is dry. Using the wipers when the win-
dow is dry can damage the glass. When switched on, the wipers will
temporarily be switched to the ne

xt
setting down when the vehicle is stationary.
If the driver or front passenger door is
opened when the vehicle is stationary,
the windscreen wipers will move to their ini-
tial position and will be switched off. If the
door is closed within a few seconds or the
wiper lever is moved, the wipers will be
switched back on again.
If the vehicle is parked during cold
weather, the service position of the
windscreen wiper may be helpful in order to
be able to release the wiper blades better
from the windscreen

x
Curv ed mirrors (convex or aspheric) en-
large the field of vision and can make
objects in the mirror seem smaller and
further away than they actually are.
x Using curved mirrors to estimate the
distance from other vehicles behind you
when changing lanes can provide inac-
curate results and can lead to accidents
and severe injuries.
x Whenever possible, use the interior mir-
ror to check the exact distance between
your vehicle and following traffic or oth-
er objects.
x Ensure that you have a good view to the
rear of the vehicle. NOTICE
If the glass of an automatic anti-dazzle mirror
is broken, electrolyte fluid can leak from the mirror. This fluid attacks plastic surfaces. Re-
mo ve the fluid as soon as possible, e.g. using
a wet sponge. Interior mirror
Fig. 94
On the windscreen: automatic anti-daz-
zle interior mirror.
Automatic anti-dazzle interior mirror
When the ignition is switched on, the sensors
measure the incident light from the rear

WARNING
Poor visibility through the door windows,
windscreen and rear window increases the
risk of collisions and accidents which can
cause serious injuries.
x Keep all door windows, the windscreen
and the rear window free from ice, snow
and condensation to maintain perf
ect
visibility.
x Adjust the heating, air conditioning and
rear window heating to prevent conden-
sation from forming on the windows.
x Only set off once all windows are clear.
x Use air recirculation mode for a short
period only. Condensation could other-
wise form very quickly on the windows,
greatly reducing visibility.
x Switch off the air recirculation mode
when it is no longer required. NOTICE
Food, medicine and other items that are sen-
sitiv
e to heat or cold could be either dam-
aged or rendered useless by the air flowing
out of the vents.
x Never leave food, medicines or other tem-
perature-sensitive objects in front of the
vents. NOTICE
If the air conditioning system is not working,
switch the air conditioning system off imme-
diately and ha

ve it checked by a qualified
workshop. This can help to prevent secondary
damage. Overview of functions
Please refer to and at the start of
the chapter on page 120.
Some functions of the air conditioning sys-
tem and menus in the Inf

otainment system as well as an air conditioning block for the
rear seats depend on the equipment le

vel.
In the Infotainment system Open the air conditioning settings in
the Infotainment system.
In the Infotainment system: upper screen
edge
Switch the air conditioning system on
and off.
In the Infotainment system: lower screen
edge Select temperature. Depending on the
equipment level, you can set the tem-
perature directly in the Infotainment
system or use the touch sliders be-
neath the Infotainment system. The
selected temperatures are displayed
at the bottom of the screen in the In-
fotainment system.
The temperatures set for the rear row
of seats are shown on the displays for
the air conditioning block for the rear
seats. Adopt temperature settings of driver
side f
or all seats. Switch the seat heating on and off

Automatic windscreen heating is also active
when the air conditioning system is switched
off
.
Windscreen heating using the defrost func-
tion
The windscreen heating will be switched on
when the defrost function is switched on and
a sensor detects that condensation may form
on the windscreen.
When does the windscreen heating switch
off?
The windscreen heating switches itself off if
one of the following conditions is met:

to detergent deposits or coatings. Clean
the windscreen

Fig. 158
Changing the wiper blade f or the rear
window.
The factory-fitted windscreen wiper blades
are coated with graphite. The graphite coat-
ing ensures that the wiper blade moves qui-
etly over the window. If the graphite coating
is damaged, the wiper will become louder.
Check the condition of the wiper blades on
a regular basis. Rubbing wiper blades should
be changed if damaged or cleaned if dirty