Page 284 of 758

2824-5. Using the driving support systems
■Stopping the engine 
1 With the clutch pedal fully  
depressed, depress the brake 
pedal, and stop the vehicle. 
2 Shift the shift lever to N  
( P.186), and release the  
clutch pedal.
The Stop & Start indicator will come on.
■Restarting the engine 
Depress the clutch pedal.
The Stop & Start indicator will turn off.
■Operating conditions
●The Stop & Start system is operational  
when all of the following conditions  are met: 
• Vehicles with a Multidrive: The brake 
pedal is being depressed firmly.  (Except when the vehicle comes to a  
controlled stop while driving with the 
dynamic radar cruise control with 
full-speed range in vehicle-to-vehicle  distance control mode [if equipped]) 
• Vehicles with a manual transmission: 
The clutch pedal is not depressed. • The engine is adequately warmed up. 
• The outside temperature is -5°C 
(23°F) or higher. • The shift lever is in D or P (Multidrive)  
or in N (manual transmission). 
• The windshield defogger is off. • The selected driving mode is Normal  
or Eco mode.
• The hood is closed. • The driver’s seat belt is fastened. 
• The driver’s door is closed.
• The accelerator pedal is not being  depressed.
●In the following situations the engine may not be stopped by the Stop &  
Start system. This is not a malfunction 
of the Stop & Start system. • The air conditioning system is being  
used.
• The battery is undergoing a periodic  recharge. 
• The battery is not sufficiently charged, 
such as if the vehicle has been parked  for a long time and the battery charge  
has decreased, the electric load is 
large, the battery fluid temperature is  excessively low or the battery has  
deteriorated.
• The brake booster vacuum is low. • The vehicle is stopped on a steep  
incline.
• The steering wheel is being operated. • Due to traffic or other circumstances  
the vehicle is stopped repeatedly.
• The vehicle is being driven in a high  altitude area. 
• Engine coolant temperature or trans-
mission fluid temperature is extremely  low or high. 
• The battery fluid temperature is 
extremely low or high. • For a while after the battery terminals  
have been disconnected and recon-
nected. • For a while after the battery has been  
replaced.
• When the elapsed time since the 
engine was restarted is short.
●In the following situations, the engine 
will restart automatically if the engine  is stopped by the  Stop & Start system.  
(To enable stopping of the engine by 
the Stop & Start system, drive the  vehicle.) 
• The air conditioning system is turned 
on.
Stop & Start system opera- 
tion (vehicles with a manual  
transmission) 
     
        
        Page 469 of 758

467
7 
7-2. Maintenance
Maintenance and care
request that a record of maintenance  
be kept.
■Does your vehicle need repairs? 
Be on the alert for changes in perfor- mance and sounds, and visual tip-offs  
that indicate service is needed. Some 
important clues are:
●Engine missing, stumbling or pinging
●Appreciable loss of power
●Strange engine noises
●A fluid leak under the vehicle (How-
ever, water dripping from the air con- ditioning system after use is normal.)
●Change in exhaust sound (This may indicate a dangerous carbon monox- 
ide leak. Drive with the windows open 
and have the exhaust system checked  immediately.)
●Flat-looking tires, excessive tire squeal when cornering, uneven tire  
wear
●Vehicle pulls to one side when driven 
straight on a level road
●Strange noises related to suspension 
movement
●Loss of brake effectiveness, spongy 
feeling brake pedal or clutch pedal 
(vehicles with a manual transmission), 
pedal almost touches the floor, vehicle  pulls to one side when braking
●Engine coolant temperature continu-ally higher than normal ( P.89, 93) 
If you notice any of these clues, take  
your vehicle to any authorized Toyota  retailer or Toyota authorized repairer, or  
any reliable repairer as soon as possi-
ble. Your vehicle may need adjustment  or repair. 
     
        
        Page 573 of 758

571
9 
9-1. Specifications
Vehicle specifications
*: The fluid capacity is a reference quantity. 
If replacement is necessary, contact any  authorized Toyota retailer or Toyota  
authorized repairer, or any reliable repairer.
Electrical system (battery)
Open voltage at 20°C (68°F):
12.3 V or higher
(Turn the engine switch off and turn on the high 
beam headlights for 30 seconds.)
Charging rates 
Quick charge
Slow charge
15 A  max.
5 A  max.
Multidrive
Fluid capacity*7.5 L (7.9 qt., 6.6 Imp. qt.)
Fluid typeToyota Genuine CVT Fluid FE
NOTICE
■Multidrive fluid type 
Using Multidrive fluid other than theabove type may cause abnormal noise or  
vibration, or damage the Multidrive of your vehicle.
Manual transmission
Gear oil capacity (Reference)2.4 L (2.5 qt., 2.1 Imp. qt.)
Gear oil type“TOYOTA Genuine Manual Transmission Gear  
Oil LV GL-4 75W” or equivalent
NOTICE
■Manual transmission gear oil type
●Please be aware that depending on the particular characteristics of the gear oil  
used or the operating conditions, idle sound, shift feeling and/or fuel efficiency 
may be different or affected and, in the worst case, damage to the vehicle’s  transmission. 
Toyota recommends to use “TOYOTA Genuine Manual Transmission Gear Oil 
LV GL-4 75W” to achieve optimal performance. 
     
        
        Page 574 of 758

5729-1. Specifications
*1: Minimum pedal clearance when depressed with a force of 300 N (30.6 kgf, 67.4  
lbf) while the engine is running.
*2: Make sure to confirm that the brake warning light (yellow) does not illuminate. (If 
the brake warning light illuminates, refer to P.511.)
NOTICE
●Your Toyota vehicle is filled with “TOYOTA Genuine Manual Transmission Gear  
Oil LV GL-4 75W” at the factory.
Use Toyota approved “TOYOTA Genuine Manual Transmission Gear Oil LV  GL-4 75W” or an equivalent oil of matching quality that satisfies the above spec- 
ifications.
Please contact any authorized Toyota retailer  or Toyota authorized repairer, or  any reliable repairer for further details.
Clutch
Pedal free play3   15 mm (0.1  0.6 in.)
Fluid typeSAE J1703 or FMVSS No.116 DOT 3 
SAE J1704 or FMVSS No.116 DOT 4
Brakes
Pedal clearance*1107 mm (4.2 in.) Min.
Pedal free play1   6 mm (0.04  0.24 in.)
Parking brake indicator*2
When pulling the parking brake switch for 1 to 2  
seconds: comes on 
When pushing the parking brake switch for 1 to  
2 seconds: turns off
Fluid typeSAE J1703 or FMVSS No.116 DOT 3 
SAE J1704 or FMVSS No.116 DOT 4
Steering
Free playLess than 30 mm (1.2 in.)