1764-1. Before driving
must be in M and select gear step 4
or lower. ( P. 1 8 2 )
Manual transmission
Refrain from driving in 6th gear to
maintain the effectiveness of
engine braking and to maintain
charging system performance.
■If the engine overheats
Towing a loaded trailer up a long,
steep incline in temperatures
exceeding 30°C (85°F) may result
in the engine overheating. If the
engine coolant temperature gauge
indicates that the engine is over-
heating, turn the air conditioning off
immediately, leave the road and
stop the vehicle in a safe place.
( P.560)
■When parking the vehicle
Always place wheel chocks under
the wheels of both the vehicle and
trailer. Firmly set the parking brake
and shift the shift lever to P
(Multidrive) and 1 or R (manual
transmission).
WA R N I N G
Follow all the instructions described in this section. Failure to do so could
cause an accident resulting in death
or serious injury.
■Trailer towing precautions
When towing, make sure that none of the weight limits are exceeded.
( P.171)
■Vehicle speed in towing
Observe the legal maximum speeds
for trailer towing.
■Before descending hills or long declines
Reduce speed and downshift. How-
ever, never downshift suddenly while descending steep or long downhill
grades.
■Operation of the brake pedal
Do not hold the brake pedal
depressed often or for long periods of time. Doing so may result in the brake
overheating or reduce braking effects.
■To avoid accident or injury
●Vehicles with a compact spare tire:
Do not tow a trailer when the com- pact spare tire is installed on your
vehicle.
●Vehicles with the emergency tire
puncture repair kit: Do not tow a
trailer when the tire installed is repaired with the emergency tire
puncture repair kit.
●Do not use the following systems
when trailer towing.
• Cruise control (if equipped)
• Dynamic radar cruise control (if
equipped)
• Dynamic radar cruise control with
full-speed range (if equipped)
NOTICE
■Do not directly splice trailer lights
Directly splicing trailer lights may
damage your vehicle’s electrical sys- tem and cause a malfunction.
483
7
7-3. Do-it-yourself maintenance
Maintenance and care
■The tire pressure warning sys-
tem must be init ialized in the
following circumstances:
When rotating front and rear tires
which have different tire inflation
pressures.
When changing the tire size.
When the tire inflation pressure
is changed such as when chang-
ing traveling speed or load
weight.
When changing between two
registered wheel sets.
When the tire pressure warning
system is initialized , the current tire
inflation pressure is set as the
benchmark pressure.
■How to initialize the tire pres-
sure warning system
1 Park the vehicle in a safe place
and turn the engine switch off.
Initialization cannot be performed while the vehicle is moving.
2 Adjust the tire inflation pressure
to the specified co ld tire inflation
pressure level. ( P.573)
Make sure to adjust the tire pressure to
the specified cold tire inflation pressure level. The tire pre ssure warning system
will operate based on this pressure
level.
3 Turn the engine switch to ON.
4 Press or of the meter
control switch to select .
5 Press or to select “Vehi-
cle Settings” and then press and
hold .
6 Press or to select
“TPWS” and then press .
7 Press or to select “Set
Pressure”. Then press and hold
until the tire pressure warn-
ing light blinks 3 times.
■Initialization procedure
●Make sure to carry out initialization after adjusting the tire inflation pres-
sure.
Also, make sure the tires are cold before carrying out initialization or tire
inflation pressure adjustment.
●If you have accidentally turned the
engine switch off during initialization, it
is not necessary to press the reset switch again as initialization will
restart automatically when the engine
switch is turned to ON the next time.
●If you accidentally press the reset
switch when initialization is not neces- sary, adjust the tire inflation pressure
to the specified level when the tires
are cold, and conduct initialization
Initializing the tire pressure
warning system (if
equipped)
4867-3. Do-it-yourself maintenance
■Instructions for checking tire infla-
tion pressure
When checking tire inflation pressure,
observe the following:
●Check only when the tires are cold.
If your vehicle has been parked for at
least 3 hours or has not been driven for more than 1.5 km or 1 mile, you
will get an accurate cold tire inflation
pressure reading.
●Always use a tire pressure gauge.
It is difficult to judge if a tire is properly inflated based only on its appearance.
●It is normal for the tire inflation pres-sure to be higher after driving as heat
is generated in the tire. Do not reduce
tire inflation pressure after driving.
●Passengers and luggage weight
should be placed so that the vehicle is balanced.
WA R N I N G
■Proper inflation is critical to save
tire performance
Keep your tires properly inflated. If the tires are not properly inflated,
the following conditions may occur
which could lead to an accident resulting in death or serious injury:
●Excessive wear
●Uneven wear
●Poor handling
●Possibility of blowouts resulting from overheated tires
●Air leaking from between tire and wheel
●Wheel deformation and/or tire dam-age
●Greater possibility of tire damage while driving (due to road hazards,
expansion joints, sharp edges on
the road, etc.)
NOTICE
■When inspecting and adjusting
tire inflation pressure
Be sure to put the tire valve caps back on.
If a valve cap is not installed, dirt or
moisture may get into the valve and cause an air leak, resulting in
decreased tire inflation pressure.
4887-3. Do-it-yourself maintenance
Use only Toyota wheel nuts and
wheel nut wrenches designed for
use with your aluminum wheels.
When rotating, repairing or
changing your tires, check that
the wheel nuts ar e still tight after
driving 1600 km (1000 miles).
Be careful not to damage the
aluminum wheels when using
tire chains.
Use only Toyota genuine balance
weights or equivalent and a plas-
tic or rubber hammer when bal-
ancing your wheels.
WA R N I N G
●Never use oil or grease on the
wheel bolts or wheel nuts.
Oil and grease may cause the wheel nuts to be excessively tight-
ened, leading to bolt or disc wheel
damage. In addition, the oil or grease can cause the wheel nuts to
loosen and the wheel may fall off,
causing an accident and resulting in
death or serious injury. Remove any oil or grease from the wheel bolts or
wheel nuts.
■Use of defective wheels prohib-
ited
Do not use cracked or deformed wheels. Doing so could cause the tire
to leak air during driving, possibly
causing an accident.
NOTICE
■Replacing tire pressure warning
valves and transmitters (vehicles
with a tire pressure warning sys-
tem)
●Because tire repair or replacement
may affect the tire pressure warning
valves and transmitters, make sure to have tires serviced by any
authorized Toyota retailer or Toyota
authorized repairer, or any reliable repairer. In addition, make sure to
purchase your tire pressure warn-
ing valves and transmitters at any authorized Toyota retailer or Toyota
authorized repairer, or any reliable
repairer.
●Ensure that only genuine Toyota
wheels are used on your vehicle. Tire pressure warning valves and
transmitters may not work properly
with non-genuine wheels.
Aluminum wheel precau-
tions (if equipped)
5669-1. Specifications
9-1.Specifications
Hatchback
Wagon
Maintenance data (fuel, oil level, etc.)
Dimensions and weights
Overall length4370 mm (172.0 in.)
Overall width1790 mm (70.5 in.)
Overall height*11435 mm (56.5 in.)*2
1460 mm (57.5 in.)*3
Wheelbase2640 mm (103.9 in.)
TreadFront1530 mm (60.2 in.)
Rear1530 mm (60.2 in.)
Gross vehicle mass1820 kg (4012 lb.)*4
1840 kg (4057 lb.)*5
Maximum permissible axle
capacity
Front1050 kg (2315 lb.)
Rear970 kg (2138 lb.)
Drawbar load*875 kg (165 lb.)
Towing capacity*8
Without brake450 kg (992 lb.)
With brake600 kg (1324 lb.)*6
1300 kg (2866 lb.)*7
Overall length4650 mm (183.0 in.)
Overall width1790 mm (70.5 in.)
Overall height*11435 mm (56.5 in.)*2
1460 mm (57.5 in.)*3
Wheelbase2700 mm (106.3 in.)
TreadFront1530 mm (60.2 in.)
Rear1530 mm (60.2 in.)
Gross vehicle mass1850 kg (4079 lb.)*4
1870 kg (4123 lb.)*5
587
9
9-3. Initialization
Vehicle specifications
9-3.Initialization
*: If equipped
Items to initialize
The following items must be initialized for normal system operation
after such cases as the battery being reconnected, or maintenance
being performed on the vehicle:
List of items to initialize
ItemWhen to initializeReference
PKSB (Parking Sup-
port Brake)*• After reconnecting or changing the
batteryP. 3 2 3
Toyota parking
assist-sensor*• After reconnecting or changing the
batteryP. 3 0 6
Engine oil mainte-
nance data• After maintenance is performedP. 4 7 4
S-IPA (Simple Intelli-
gent Parking Assist
System)*
• After reconnecting or changing the
batteryP. 3 4 6
Tire pressure warning
system*
• When rotating front and rear tires
which have different tire inflation
pressures
• When changing the tire size
• When the tire inflation pressure is
changed such as when changing
traveling speed or load weight
• When changing between two regis-
tered wheel sets
P. 4 8 3
604Alphabetical Index
Toyota parking assist-sensor OFF
indicator ................................... 516
Warning messages ....................... 520
Washer
Checking .................................... 477
Preparing and checking before win-
ter ............................................ 363
Switch ........................................ 206
Washing and waxing .................... 460
Weight............................................ 566
Wheels ........................................... 487
Replacing ................................... 487
Size ............................................ 573
Window lock switch ..................... 153
Windows
Power windows .......................... 151
Rear window defogger ....... 424, 429
Washer....................................... 206
Windshield wiper de-icer ............. 431
Windshield wipers ........................ 206
Winter driving tips ........................ 363
Wireless charger........................... 452
Wireless remote control
Battery-Saving Function............. 137
Locking/Unlocking ...................... 116
Replacing the battery ................. 490
WMA disc ...................................... 375
For vehicles with naviga-
tion/multimedia system,
refer to “Navigation and mul-
timedia system Owner’s
manual” for information
regarding the equipment
listed below.
· Navigation system
· Audio/visual system
· Rear view monitor system