12-3
SUPPLEMENT
54P00-01E
Seat belt warning
Follow this warning as well as the instruc-
tion for seat belt in this book.
In the case where a “Seat Belt Assembly”
incorporates an “Automatic Length Adjust-
ing and Locking Retractor” or an “Emer-
gency Locking Retractor”.
For Mexico
Fuel recommendation
54P000101
Your vehicle requires regular unleaded
gasoline with a minimum rating of 87 pump
octane ((R + M)/2 method). In some areas,
the only fuels that are available are oxy-
genated fuels.
Oxygenated fuels which meet the mini-
mum octane requirement and the require-
ments described below may be used in
your vehicle without jeopardizing the New
Vehicle Limited Warranty.
WA R N I N G
Seat belts are designed to bear upon
the bony structure of the body, and
should be worn low across the front
of the pelvis or the pelvis, chest and
shoulders, as applicable; wearing the
lap section of the belt across the
abdominal area must be avoided.
• Seat belts should be adjusted as
firmly as possible, consistent with
comfort, to provide the protection
for which they have been designed.
A slack belt will greatly reduce the
protection afforded to the wearer.
• Care should be taken to avoid con-
tamination of the webbing with pol-
ishes, oils and chemicals, and
particularly battery acid. Cleaning
may safely be carried out using
mild soap and water. The belt
should be replaced if webbing
becomes frayed, contaminated or
damaged.
(Continued)
WA R N I N G
(Continued)
• It is essential to replace the entire
assembly after it has been worn in
a severe impact even if damage to
the assembly is not obvious.
• Belts should not be worn with
straps twisted.
• Each belt assembly must only be
used by one occupant; it is danger-
ous to put a belt around a child
being carried on the occupant’s
lap.
WA R N I N G
• No modifications or additions
should be made by the user which
will either prevent the seat belt
adjusting devices from operating to
remove slack, or prevent the seat
belt assembly from being adjusted
to remove slack.
• Referring to the instruction for seat
belt in this book, adjust the seat
belt so that the lap and sash por-
tions of the “Seat Belt Assembly”
fit as firmly as possible consistent
with comfort.
EXAMPLE
12-7
SUPPLEMENT
54P00-01E
How to stop the alarm
Should the alarm be triggered accidentally,
unlock the doors using the keyless push
start system remote controller, the request
switch or the keyless entry system trans-
mitter, or press the engine switch to
change the ignition mode to “ON” or turn
the ignition switch to “ON” position. The
alarm will then stop.
NOTE:
Even after the alarm has stopped, if you
lock the doors using the keyless push
start system remote controller, the
request switch or the keyless entry sys-
tem transmitter, the theft deterrent alarm
system will be rearmed with a delay of
about 20 seconds.
If you disconnect the battery while the
theft deterrent alarm system is in the
armed condition or the alarm is actually
in operation, the alarm will be triggered
or re-triggered when the battery is then
reconnected, although, in the latter case,
the alarm remains stopped for the period
between disconnection and reconnec-
tion of the battery.
Even after the alarm has stopped at the
end of the predetermined operation time,
it will be triggered again if any door or
engine hood (for EU specification vehi-
cle) is opened without disarming the
theft deterrent alarm system.Checking whether the alarm has been
triggered during parking
If the alarm was triggered due to an unau-
thorized entry into the vehicle and you then
press the engine switch to change the igni-
tion mode to “ON” or turn the ignition
switch to “ON” position, the theft deterrent
light will blink rapidly for about 8 seconds
and a buzzer will beep 4 times during this
period. If this happens, check whether your
vehicle has been broken into while you
were away from it.
Enabling and disabling the theft deter-
rent alarm system
The theft deterrent alarm system can be
either enabled or disabled.
When enabled (factory setting)
When the system is enabled, it causes the
hazard warning lights to flash for about 40
seconds if any of the alarm trigger condi-
tions is met. The system also causes the
interior buzzer to beep intermittently for
about 10 seconds, which is followed by
intermittent sounding of the horn for about
30 seconds.
The theft deterrent light continues to blink
during this time.
When disabled
When the system is disabled, it stays dis-
armed even if you perform any system
arming operation.How to switch the state of the theft
deterrent alarm system
You can switch the theft deterrent alarm
system from the enabled state to the dis-
abled state, and vice versa, using the fol-
lowing method.
54P000209
(2)(3)
(1)
EXAMPLE
13-1
INDEX
13
54P00-01E
INDEX
Symbols
“ENG A-STOP OFF” light .................................................. 2-101
“ENG A-STOP” indicator light .......................................... 2-101
Numerics
4WD warning light ............................................................... 2-98
A
Accelerator pedal................................................................. 3-12
Accessory socket .................................................................. 5-8
Adding coolant..................................................................... 7-27
AIR BAG light .............................................................. 2-51, 2-93
Air cleaner ............................................................................ 7-28
Air conditioning system ...................................................... 7-59
AM/FM CD PLAYER ............................................................. 5-40
Anti-lock brake system (ABS) ................................... 3-75, 3-77
Anti-lock brake system (ABS) warning light ..................... 2-91
Anti-theft feature .................................................................. 5-83
Assist grips .......................................................................... 5-11
Audio system ....................................................................... 5-40
Automatic headlight leveling system warning light ......... 2-97
Automatic heating and air conditioning system
(climate control) ................................................................... 5-32
Automatic light operation ................................................. 2-104
Average fuel consumption.................................................. 2-67
Average speed ..................................................................... 2-67
B
Battery .................................................................................. 7-39
Battery replacement ................................................... 2-14, 7-39
Bluetooth
® audio ................................................................. 5-78
Bluetooth® hands-free......................................................... 5-70Brake assist system............................................................. 3-75
Brake fluid............................................................................. 7-33
Brake pedal ..................................................................3-12, 7-34
Brake system warning light ................................................ 2-90
Brakes ................................................................................... 7-33
Braking .................................................................................. 3-74
Brightness control ............................................................... 2-65
Built date ............................................................................... 12-1
Bulb replacement ................................................................. 7-45
C
Cargo net hooks ................................................................... 5-17
Catalytic converter ................................................................. 4-1
Central door locking system ................................................. 2-3
Changing engine oil and filter............................................. 7-23
Changing wheels.................................................................... 8-4
Charging light ....................................................................... 2-93
Chassis serial number ......................................................... 10-1
Child restraint ..............................................................2-40, 12-1
Child restraint system ......................................................... 2-40
Child restraint systems ....................................................... 2-37
Child-proof locks (rear door) ................................................ 2-5
Clock ............................................................................2-67, 5-15
Clutch pedal.................................................................3-12, 7-32
Coat hooks............................................................................ 5-11
Compact spare tire............................................................... 7-38
Coolant level check.............................................................. 7-27
Coolant replacement............................................................ 7-28
Corrosion prevention............................................................. 9-1
Cruise control ....................................................................... 3-42
Cup holder and storage area .............................................. 5-13
54P00-01E
Specific conditions for installation
NOTE:
1) Antenna cable is routed as far as possible from the vehicle electronic devices and wiring harness in the vehicle.
2) Power cable of transmitter is properly connected to lead-acid battery on the vehicle.
NOTICE
Before using your vehicle, check if there is no interference to all electrical devices on your vehicle for both Standby mode
and Transmitting mode of the RF transmitting equipment.
54P00-01E
BATTERY LABEL SYMBOL MEANINGS
No smoking, no naked flames, no sparksBattery acid
Shield eyesNote operating instructions
Keep away from childrenExplosive gas
Prepared by
January, 2015
Part No. 99011-54P00-01E
Printed in Hungary
TP480