Page 108 of 638
03
3-27
Second row center seatbelt
(3-point rear center seat belt)
OTM038041
1. Insert the tongue plate (1) into the buckle (2) until an audible “click" is
heard, indicating the latch is locked.
Make sure the belt is not twisted.
When using the rear center seat belt, the
buckle with the “CENTER” mark must be used.
Information
If you are not able to pull out the safety
belt from the retractor, firmly pull the belt
out and release it. After release, you will be
able to pull the belt out smoothly.
WARNING
Make sure that the seatback is locked in
place when using the rear center seat belt.
If not, the seatback may move when
there is a sudden stop or collision,
which could result in serious injury. Stowing the rear seat belt
OTM030022
[ The rear seat belt buckles can be
stowed in the pocket between the
rear seatback and cushion when not in use.
Page 321 of 638

6
Special Driving Conditions .............................................................................6-49Hazardous Driving Conditions ................................................................................. 6-49
Rocking the Vehicle .................................................................................................. 6-49
Smooth Cornering ..................................................................................................... 6-50
Driving at Night ......................................................................................................... 6-50
Driving in the Rain ..................................................................................................... 6-50
Driving in Flooded Areas ............................................................................................ 6-51
Highway Driving ......................................................................................................... 6-51
Reducing the Risk of a Rollover ................................................................................ 6-51
Winter Driving ................................................................................................. 6-52 Snow or Icy Conditions ..............................................................................................6-52
Winter Precautions .....................................................................................................6-53
Trailer Towing .................................................................................................. 6-55 If you Decide to Pull A Trailer .................................................................................... 6-56
Trailer Towing Equipment ......................................................................................... 6-59
Driving With a Trailer ................................................................................................. 6-60
Maintenance When Towing a Trailer ........................................................................ 6-63
Vehicle Weight ................................................................................................6-64 The Loading Information Label ................................................................................ 6-65
Page 362 of 638

06
6-43
WARNING
Never start or run the engine while
an AWD vehicle is raised on a jack.
The vehicle can slip or roll off of a jack
causing serious injury or death to you or
those nearby.
Towing
AWD vehicles must be towed with
a wheel lift and dollies or flatbed
equipment with all the wheels off the
ground. For more details, refer to
"Towing" section in chapter 8.
Vehicle inspection [ If the vehicle needs to be operated on
a vehicle lift do not attempt to stop
any of the four wheels from turning.
This could damage the AWD system.
[ Never engage the parking brake while running the engine on a car lift. This
may damage the AWD system. Dynamometer testing
A AWD vehicle must be tested on a
special four wheel chassis dynamometer.
OTMH060001
[A] : Roll tester (Speedometer),
[B] : Temporary free roller
A AWD vehicle should not be tested on
a 2WD roll tester. If a 2WD roll tester
must be used, perform the following
procedure:
1. Check the tire pressures
recommended for your vehicle.
2. Place the rear wheels on the roll tester for a speedometer test as shown in
the illustration.
3. Release the parking brake.
4. Place the front wheels on the temporary free roller as shown in the
illustration.
WARNING
Keep away from the front of the vehicle
while the vehicle is in gear on the
dynamometer. The vehicle can jump
forward and cause serious injury or
death.
Page 368 of 638