2022 HYUNDAI SANTA FE HYBRID battery
[x] Cancel search: batteryPage 233 of 638
Convenience Features
5-28
1. Programming HomeLink®
The following steps show how to
program HomeLink. If you have any
questions or are having difficulty
programming your HomeLink buttons,
refer to the HomeLink website or call the
HomeLink customer support toll-free
number. Do this before going back to the
dealer who sold you the car. [
Visit the HomeLink website at: www.
homelink.com. Then at the top of the
page, choose your vehicle make. Then
watch the You Tube video, and/or
access additional website information.
[ If you choose to access the website
via your cell phone, scan the QR code.
[ Or call HomeLink customer support
at 1-800-355-3515 (Please have the
vehicle make/model and the opener
device make/model readily available.) 1) Programming Preparation
OTMA050003
1. When programming a garage door opener, it is advised to park the
vehicle outside of the garage.
2. It is recommended that a new battery be placed in the handheld transmitter
of the device being programmed to
HomeLink for quicker training and
accurate transmission of the radio-
frequency signal.
3. Place the ignition switch to the ACC (Accessory) position for programming
of HomeLink.
2) Programming a New HomeLink®
OTMA050004
1. Press and release the HomeLink button (1), (2) or (3), you would like
to program. The HomeLink indicator
light (7) will flash orange slowly (if
not, perform the steps of “Erasing
HomeLink Buttons” section, and start
over).
Page 243 of 638
Convenience Features
5-38
[ , I S & R Q Y H Q L H Q F H Ÿ : H O F R P H P L U U R U O L J K W Ÿ 2 Q G R R U X Q O R F NT L V V H O H F W H G L Q
the User Settings mode on the LCD
display, the outside mirror will fold or
unfold automatically as follows:
- The mirror will fold or unfold when the door is locked or unlocked by
the smart key.
- The mirror will fold or unfold when the door is locked or unlocked by
the button on the outside door handle.
[ , I S & R Q Y H Q L H Q F H Ÿ : H O F R P H P L U U R U O L J K W Ÿ 2 Q G R R U X Q O R F NT D Q G
S & R Q Y H Q L H Q F H Ÿ : H O F R P H P L U U R U O L J K W
Ÿ 2 Q G U L Y H U D S S U R D F KT L V V H O H F W H G L Q
the User Settings mode on the LCD
display, the outside mirror will unfold
automatically when you approach the
vehicle (all doors closed and locked)
with a smart key in possession.
NOTICE
The electric type side view mirror
operates even though the ignition
switch is in the OFF position. However,
to prevent unnecessary battery
discharge, do not adjust the mirrors longer than necessary while the engine
is not running.
NOTICE
Do not fold the electric type side view
mirror by hand. It could cause motor
failure.
Reverse Parking Aid (if equipped)
OTM050020
When the gear is shifted to the R
(Reverse) position, the side view mirror(s)
will rotate downwards to aid with driving
in reverse.
The position of the side view mirror
switch (1) determines whether or not the
mirrors will move:
Left/Right : When either the L (Left) or R (Right) switch is selected,
both side view mirrors will
move.
Neutral : When neither switch is selected, the side view mirrors
will not move.
The side view mirrors will automatically
revert to their original positions if any of
the following occur: [ The Engine Start/Stop button is
pressed to either the OFF position or
the ACC position.
[ The gear is shifted to any position
except R (Reverse).
[ The side view mirror adjustment
button is not selected.
Page 252 of 638
05
5-47
Resetting The Sunroof
OTMPH051003N
In some circumstances resetting the
sunroof operation may need to be
performed. Some instances where
resetting the sunroof may be required include:
- When the 12-volt battery is either disconnected or discharged
- When the sunroof fuse is replaced
- If the sunroof one-touch AUTO OPEN/ CLOSE operation is not functioning
properly Sunroof resetting procedure:
1. It is recommended to perform the
reset procedure with the vehicle
engine running. Start the vehicle in P
(Park).
2. Make sure the power sunshade and sunroof glass are in the fully closed
position. If the power sunshade
and sunroof glass are open, push
the switch forward until the power
sunshade and sunroof glass are fully closed.
3. Release the switch when the power sunshade and sunroof glass are fully closed.
4. Push the switch forward until the power sunshade and sunroof glass
move slightly. Then release the switch.
5. Once again push and hold the sunroof switch forward until the power
sunshade and sunroof glass slide open
and close. Do not release the switch
until the operation is completed.
If you release the switch during
operation, start the procedure again from
step 2.
Information
If the sunroof is not reset when the vehicle
battery is disconnected or discharged, or
the sunroof fuse is blown, the sunroof may
not operate normally.
Page 257 of 638
Convenience Features
5-52
Power Tailgate (if equipped)
The power tailgate open/close button
automatically opens and closes the
tailgate.
Before using the power tailgate
The power tailgate operates when the
gear is in P (Park) with the Engine Start/
Stop button in the ON position. However,
the tailgate will operate regardless of the
gear position when the engine is off.
For safety, before attempting to open or
close the tailgate, make sure the vehicle
is in P (Park).
WARNING
[ Never leave children unattended
in your vehicle. Children might
operate the power tailgate. Doing so
could result in injury to themselves
or others, and could damage the
vehicle.
[ Make sure there are no people or
objects around the tailgate before
operating the power tailgate. Wait
until the tailgate is opened fully and
stopped before loading or unloading
cargo or passengers from the
vehicle.
NOTICE
Do not close or open the power
tailgate manually. This may cause
damage to the power tailgate. If it is
necessary to close or open the power
tailgate manually when the battery is
discharged or disconnected, do not
apply excessive force. Opening the power tailgate
OTM050046
The power tailgate will open
automatically by doing one of the
following: [ Press the tailgate unlock button on
the smart key for approximately one second.
OTM050050
[ Press the power tailgate button for
approximately one second.
For emergency stop while operating,
press the power tailgate button shortly.
Page 260 of 638
05
5-55
Resetting the power tailgate
OTMPH051009N
If the battery has been discharged or
disconnected, or if the power tailgate
fuse has been replaced or removed, reset
the power tailgate by performing the
following procedure:
1. Put the gear in P (Park).
2. Press the power tailgate inner button (B) and the power tailgate handle
switch (A) simultaneously for more than 3 seconds. The chime will sound.
3. Close the tailgate manually. If the power tailgate does not work
properly after the above procedure,
the system is checked by an
authorized HYUNDAI dealer.
Information
If the power tailgate does not operate
normally, check again if the gear position is in right position.
WARNING
OTMPH051005N
Do not hold on to or try to pull on
the tailgate strut. Be aware that the
deformation of the tailgate strut may
cause vehicle damage and risk of injury.
Setting the power tailgate
Power tailgate opening speed
To adjust the power tailgate opening
speed, go to User Settings mode and
V H O H F W S ' R R U Ÿ 3 R Z H U W D L O J D W H 2 S H Q L Q J
6 S H H G Ÿ ) D V W 1 R U P D OT R Q W K H / & ' G L V S O D \
- If power tailgate function turns off, you can not adjust the power tailgate speed.
- Initial speed of Power tailgate is set as “Fast”.
Page 268 of 638
05
5-63
OTMPH040003L
6. Pull the fuel filler door (1) out to fully open.
7. To remove the fuel tank cap (2), turn it counterclockwise. You may hear a
hissing noise as the pressure inside
the tank equalizes.
8. Place the cap on the fuel filler door.
NOTICE
[ It may take up to 20 seconds to
unlock fuel filler door.
[ If the fuel filler door does not open
because ice has formed around it,
tap lightly or push on the door to
break the ice and release the door.
[ Do not pry on the door. If necessary,
spray around the door with an
approved de-icer fluid (do not use
radiator anti-freeze) or move the
vehicle to a warm place and allow
the ice to melt.
WARNING
[ Before refueling, be sure to check
what type of fuel is used for your
vehicle. If you put diesel fuel into
a gasoline-powered vehicle or
gasoline into a diesel-powered
vehicle, it may affect the fuel system
and cause serious damage to the
vehicle.
[ Add fuel into the fuel tank within
20 minutes after opening the fuel
filler door. After 20 minutes, the fuel
tank may shut off, causing fuel to
overflow. In this case, re-press the
fuel filler door opening button.
[ Do not leave the fuel filler door
opened for an extended period of
time. It may discharge the battery.
[ Close the fuel filler door after fueling
the vehicle. If you start the vehicle with the fuel filler door opened,
the message, “Check fuel door”,
illuminates on the LCD display.
[ Avoid refueling the vehicle while
charging the (high-voltage) hybrid
battery. It may cause a fire or an
explosion due to static electricity.
Closing the fuel filler door
1. To install the fuel tank cap, turn it clockwise until it “clicks” one time.
2. Close the fuel filler door and press the rear center edge of fuel filler door.
3. When the fuel filler door is closed well, it will lock in 5 seconds.
à If the fuel door is opened again as soon as it is closed, the fuel door will
not lock. Then, close the fuel door well again and it will lock in 5 seconds.
Page 270 of 638
05
5-65
Information
Make sure to refuel your vehicle according
to the “Fuel Requirements” section in
suggested in chapter 1.
NOTICE
[ Do not spill fuel on the exterior
surfaces of the vehicle. Any type of
fuel spilled on painted surfaces may damage the paint.
[ If the fuel filler cap requires
replacement, use only a genuine
HYUNDAI cap or the equivalent
specified for your vehicle. An
incorrect fuel filler cap can result
in a serious malfunction of the fuel
system or emission control system.
WARNING
In case of using EV drive mode for a certain time without running engine,
EMM (Engine Maintenance Mode) will
automatically activate by the system to
protect the fuel system and the engine.
Therefore, even though if it is possible
to use EV drive mode with enough
battery power, the engine may run by
the system to protect fuel system and
the engine. If you leave the fuel without
refueling or using for over 6 months, the
remained fuel in the fuel system may
be deteriorated. From this, corrosion
or blocking problem may occur. It is
recommended using minimum 40 % of
remained fuel at least every 6 months
by selecting Hybrid (CS)mode and
refuel the vehicle with new fuel.
Page 275 of 638
Convenience Features
5-70
Turn signals and lane change signals
OIG046417
To signal a turn, push down on the lever
for a left turn or up for a right turn in
position (A).
If an indicator stays on and does not flash
or if it flashes abnormally, one of the turn
signal bulbs may be burned out and will
require replacement.
One touch turn signal
To use One Touch Turn Signal push the
turn signal lever up or down to position
(B) and then release it. The lane change signals will blink 3, 5 or 7 times.
You can enable the One Touch Turn Signal function or choose the number
R I E O L Q N L Q J E \ V H O H F W L Q J S 6 H W X S Ÿ 8 V H U
6 H W W L Q J V Ÿ / L J K W V Ÿ 2 Q H 7 R X F K 7 X U Q 6 L J Q D O
Ÿ 2 I I I O D V K H V I O D V K H V I O D V K H VT L Q W K H
instrument panel LCD cluster. Battery saver function
The purpose of this feature is to prevent
the battery from being discharged.
The system automatically turns off the
position lamp when the driver turns the
vehicle off and opens the driver-side
door.
With this feature, the position lamps will
turn off automatically if the driver parks
on the side of road at night.
However, the position lamps stay ON
even when the driver-side door is opened
if the headlamp switch is turned to the
position lamp or AUTO (if equipped)
position after the engine is turned off.
If necessary, to keep the lamps on turn the position lamps OFF and ON
again using the headlamp switch on
the steering column after the engine is
turned off.